Water-infiltration characteristics of soil can be improved by preventing clay dispersion. The present study determined the adsorption properties of hydroxy-Al polycations (Al-p) and their relation to the destabilization of clay suspensions. Al-p was synthesized and fractionated into nominal molecular weights between 104 and 5 × 104. The reactions of Al-p with Na-illite and Na-montmorillonite indicated a very strong affinity of Al-p to the clay surfaces. The maximum adsorptions of Al-p by Na-illite and Na-montmorillonite were found to be 0.37 and 1.7 mmole Al/g, and very close to the cation-exchange capacity of the two clays, suggesting that the adsorption was chiefly controlled by the mechanism of charge screening. Adsorption of Al-p increased the points of zero charge (PZCs) and the apparent points of zero salt effect (PZSEs) of illite and montmorillonite. PZSEs for both clays were 4.7 at their maximum Al-p adsorption, and PZCs ranged from 5.3 to 6.4, depending on solution ionic strength and the individual clay minerals. The differences in PZCs were probably due to outer-sphere complex formation between Al-p-treated illite and montmorillonite and the swamping electrolyte. Critical flocculation concentrations (CFCs) of Al-p for Na-illite and Na-montmorillonite were at 0.28 and 1.0 mmole Al/g, whereas zero electrophoretic mobilities were at about 0.36 and 1.67 mmole Al/g Al-p additions. Excessive addition of Al-p reversed this surface charge of clay colloids and restabilized the illite but not montmorillonite suspensions. This difference was probably due to the stronger and more extensive interparticle bridging of montmorillonite particles by Al-p than those of illite. The CFCs for the two clays were also found to be dependent on sodium adsorption ratio (SAR), pH, and ionic strength. Increases in SAR and pH significantly increased the CFC, whereas an increase in ionic strength decreased the CFC.

The purpose of this study was to investigate bonding mechanisms of representative inorganic anions and citrate with imogolite and allophane using electrophoresis. The electrophoretic mobility (EM) of synthetic imogolite and allophanes with Al/Si molar ratios of 2.02, 1.64, and 1.26 was determined in 0.001 and 0.01 M sodium solutions. The highest point of zero mobility (PZM) values for imogolite and the highest point of zero charge (PZC) values for allophane occurred in the presence of ClO4, NO3, Br, I, and Cl. Below the PZM and PZC, Cl and I lowered the EM relative to the other anions but did not shift the PZM and PZC significantly. This indicates that Cl and I formed more outer-sphere complexes than the other ions. The EM of imogolite and allophane was negative at pH < 6 in 0.001 and 0.01 M NaF probably due to a phase change. We observed the formation of cryolite (Na3AlF6) with transmission electron microscopy (TEM) and X-ray diffraction (XRD) in the NaF systems at low pH. Conversely, phosphate at 0.001 and 0.01 M concentrations lowered both the PZM and the EM in imogolite and both the PZC and the EM in allophane compared with ClO4. Phosphate-treated allophane had the same PZC as a synthetic amorphous aluminum phosphate. The PZM values of imogolite and allophane with 2:1 Al/Si in 0.0001 M Na-citrate were 10.9 and 5.9, respectively. At pH 7.3, Na-citrate lowered allophane EM more than it lowered imogolite EM relative to ClO4.

The EM in NaClO4 and Na2SO4 was reversible by forward- and back-titration with NaOH and HClO4, indicated that ClO4 and SO4 were not specifically adsorbed. Chloride likely formed more outer-sphere complexes than ClO4. Imogolite EM and allophane EM in dilute NaF and NaH2PO4 solutions were not reversible, indicating either surface inner-sphere complexes or surface precipitates of aluminum fluoride and amorphous aluminum phosphate-like materials on these minerals. Sulfate gave a lower EM than the monovalent anions, implying a greater tendency to form outer-sphere complexes. Citrate appeared to form inner-sphere complexes on both imogolite and allophane, but formation was concentration-dependent. The tendency of anions to form surface complexes with imogolite and allophane is consistent with the tendency of anions to form soluble aluminum complexes.

Surface adsorption mechanisms of dissolved inorganic carbon species on soil minerals are not well understood. Traditional infrared (IR) study of adsorbed species of inorganic carbon using air-dried samples may not reveal true species in the solid/water interface in suspension. The purpose of this study was to obtain information on interfacial carbonate speciation between solid and aqueous phases. The interaction of bicarbonate and carbonate ions with X-ray amorphous (am) Al and Fe oxides, gibbsite (γ−Al(OH)3) and goethite (α-FeOOH) was examined by electrophoresis and in situ attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy. The presence of carbonate lowered the electrophoretic mobility and decreased the point of zero charge (PZC) of all minerals, implying specific adsorption. Inner-sphere complexation of bicarbonate and carbonate was supported by a lowering in the anion symmetry due to the interaction with Al and Fe oxide surfaces. Only complexed monodentate carbonate was identified in am-Al(OH)3/aqueous solution at pH 4.1-7.8 when the solid was reacted with either NaHC03 or Na2CO3 solutions. Am-Al(OH)3 was transformed to a crystalline sodium aluminum hydroxy carbonate, dawsonite [NaAl(CO3)(OH)2], and bayerite (α-Al(OH)3) after reacting with 1.0 M Na2CO3 for 24 h. Gibbsite adsorbed much less carbonate than am-Al(OH)3 such that adsorbed carbonate on gibbsite gave weak IR absorption. It is probable that monodentate carbonate is also the complexed species on gibbsite. Evidence suggesting the presence of both surface complexed bicarbonate and carbonate species in the interfacial region of am-Fe(OH)3 in suspension and the dependence of their relative distribution on solution pH is shown. Only monodentate carbonate was found in the interfacial region of goethite in 1.0 M NaHCO3. A ligand exchange reaction was proposed to describe the interaction of bicarbonate and carbonate with the surface functional groups of Al and Fe oxides.

The surface charge components of 2 Georgia kaolinites of differing degrees of crystallinity (KGa-1 and KGa-2) were determined using procedures based on charge balance concepts. Permanent structural charge density (σ0) was determined by measuring the surface excess of Cs, which is highly selective to permanent charge sites. The values of σ0 determined were -6.3 ± 0.1 and -13.6 ± 0.5 mmol kg−1 for kaolinites KGa-1 and KGa-2, respectively. The net proton surface charge density (σH) was determined as a function of pH by Potentiometrie titration in 0.01 mol dm-3 LiCl. Correction from apparent to absolute values of σH was made by accounting for Al release during dissolution, background ion adsorption and charge balance. Lithium and C1 adsorption accounted for the remainder of the surface charge components. Changes in surface charge properties with time were measured after mixing times of 1, 3 and 15 h, the latter representing “equilibrium”. Time-dependent behavior is believed to be caused by mineral dissolution followed by readsorption or precipitation of Al on the mineral surface. Both the point of zero net charge (p.z.n.c.) and the point of zero net proton charge (p.z.n.p.c.) changed with mixing time, generally increasing. The “equilibrium” p.z.n.c. values were approximately 3.6 for KGa-1 and 3.5 for KGa-2, whereas the corresponding p.z.n.p.c. values were about 5.0 and 5.4. The p.z.n.c. results were in good agreement with previous studies, but the values of p.z.n.p.c. were higher than most other values reported for specimen kaolinite.

The effect of interlayering montmorillonite with different amounts of hydroxy aluminum cation on the cation exchange capacity (CEC) and the point of zero charge (PZC) of the clay was studied. The CEC decreased as the Al content of the clay increased. Both the CEC and the loss in the CEC were linearly dependent on the Al content, thus indicating the predominance of a single polynuclear interlayered species. Its composition is [Al6(OH)16.5]1.5+. Acid base titration of the interlayered montmorillonites produced values for the PZC in the range 4.5-5.9, increasing with the Al content of the materials. The values, however, did not represent real conditions of zero charge and some samples were still negatively charged at the determined PZC. The PZC values obtained by acid-base titration are thought to be adversely affected by secondary reactions involving the interlayered material with a concomitant release of soluble Al in amounts dependent on the pH and ionic strength.

Contaminant-transport modeling requires information about the charge of subsurface particle surfaces. Because values are commonly reused many times in a single simulation, small errors can be magnified greatly. Goethite (α-FeOOH) and pyrolusite (β-MnO2) are ubiquitous mineral phases that are especially contaminant reactive. The objective of the present study was to measure and compare the point of zero charge (PZC) using different methods. The pyrolusite PZC was measured with three methods: mass titration (MT) (PZC = 5.9±0.1), powder addition (PA) (PZC = 5.98±0.08), and isoelectric point, IEP (PZC = 4.4±0.1). The IEP measurement was in agreement with literature values. However, MT and PA resulted in a statistically larger PZC than the IEP measurement. The surface area of pyrolusite, 2.2 m2g−1, was too small to permit PZC determination by the potentiometric titration (PT) method. Goethite PZC values were measured using MT (7.5±0.1), PT (7.46±0.09), and PA (7.20±0.08). The present work presents the first reported instance where MT and PA have been applied to measure the point of zero charge of either pyrolusite or goethite. The results illustrate the importance of using multiple, complementary techniques to measure PZC values accurately.

The majority of investigations of soil electrical characteristics are concerned with tropical and subtropical regions and hence there is little information about soils from other regions. The present study attempts to discover the most important constituents affecting soil electrical charge characteristics in a temperate zone. The study area is located on southern coastal zones of the Caspian Sea in northern Iran (Guilan province). The soil moisture and temperature regimes of the region determined by means of Newhall software were udic and thermic, respectively. Six representative pedons developed on granite, andesite, basalt, phyllite and limestone as their parent rocks are described and their physicochemical, mineralogical and electrical properties studied. The results indicate that the point of zero charge (PZC) values are small in all samples and smaller at the surface than in subsurface horizons. There is a positive correlation between pH0 (PZC) values, organic carbon percentage and crystalline Fe (Fed) content. The points of zero net charge (ZPNC) values are <2.5 in all the pedons studied, which refers to large amounts of negative charge in these soils. The results also show that the differences in negative charge development in a pH range from 2.5 to 6 were largest for horizons rich in organic C and least for those with significant amounts of layer silicate minerals. Therefore, the most important variable charge component in all of the soils studied is organic matter which controls the negative charge at the soil surface. The permanent charge (бp) of the soils studied is also large and negative, which agrees with the amount of clay and the mineralogy of these soils.