A novel reconfigurable circular microstrip G-slotted antenna having a circularly defected ground structure (DGS) capable of switching its resonance frequency for several microwave applications is presented in this paper. Reconfigurability of the proposed G-slot antenna is obtained by incorporating three PIN diodes. One diode is embedded in the patch and two diodes are integrated into the DGS structure at appropriate places in the slot to achieve four different wireless applications such as aeronautical radio navigation (4.3 GHz with gain 3.6 dB), satellite communication (3.78 GHz with gain 3.7 dB), mobile communication (4.55 GHz with gain 4.0 dB), and WiMAX (3.35 GHz with gain 3.3 dB). These four bands are achieved depending on the different biasing conditions of the three PIN switches used. Antenna performance has been analyzed in ANSYS Electronics Desktop 2018.2 software. The equivalent circuit component of the switching element (PIN diode) has been considered and designed during the simulation. The creative structure lies in the way that it exhibits higher gain with compact size than the previously reported similar antenna. A prototype of the proposed patch antenna has been fabricated on a Roger substrate and its testing and measurement have been performed to demonstrate its desirable characteristics and features.

This research article represents the design of a simple, smaller, and novel frequency reconfigurable patch antenna for 5G communication using PIN diodes. This antenna operates in both mid-5G and high-5G bands. The antenna is intended to operate in eight distinct modes with three PIN diodes in 5G wireless communication covering 27.46–50 GHz of high-5G band (range n257/n258/n260/n261/n262) and frequencies of the 3–6 GHz of mid-5G band (range n77/n78/n79/n46). The antenna has an overall size of 20 mm × 25 mm × 1.6 mm and is placed upon a low-cost FR4 substrate. A higher radiation efficiency from 75% to 98% is achieved in all the different modes. The resonant frequencies are around 3.46, 4.43, 5.83, 31.8, 35.5, and 46 GHz in different modes of operation. Different switching statuses have been carried out in this research work and their performances have also been illustrated in the form of surface current distribution in different resonant frequencies. The simulated and measured results are compared to highlight its proposed design operation.

In this paper, we propose a frequency-reconfigurable antenna structure consisting of a dielectric resonator (DR) topped by a superstrate material. Two metasurfaces (MSs) are placed upon the DR and the superstrate, where these two MSs are utilized to synthesize a localized reduction of the dielectric constant of the DR. By placing switches into one of the MSs, the distribution of dielectric constant of the DR can be switched to one of two predefined distributions, which is equivalent to switching the DR length to two different lengths. Consequently, the frequency response of the proposed structure can be tuned to one of two operating bands. The excited modes inside the proposed antenna were obtained analytically and through simulations. Also, the dielectric constant value of substrates topped by MSs was analyzed. The antenna was fabricated and measured, and good agreement between simulation and measurement was attained. The antenna bandwidths are 7–8.1 GHz (14.7%) and 8.5–9.2 GHz (8%) and the gains are 5.1 and 7.8 dB, in the cases of having switches off and on, respectively.

A novel low profile dual band patch antenna is presented. It consists of a composite right/left-handed transmission line (CRLH TL) unit cell gap coupled with the radiating edge of a rectangular patch antenna. The dual band behavior is achieved by coupling the zeroth order resonance mode of CRLH TL and TM10 mode of the patch antenna. It is shown that frequency ratio can be changed by varying the gap between the patch and CRLH TL unit cell. The proposed configuration enables frequency reconfigurability by changing the CRLH TL unit cell using a switch. A prototype of the antenna having frequency ratio f2/f1 = 1.08 is designed and fabricated. The proposed antenna shows measured S11 ≤ −10 dB bandwidth of 100 and 50 MHz at resonance frequencies of f1 = 4.84 and f2 = 5.22 GHz, respectively. A 2 × 2 dual band CRLH TL coupled patch array is also presented, showing more than 12.7 dBi gain at both resonance frequencies.