A detailed study of direct laser-driven electron acceleration in paraxial Laguerre–Gaussian modes corresponding to helical beams LG0m with azimuthal modes m = {1,2,3,4,5} is presented. Due to the difference between the ponderomotive force of the fundamental Gaussian beam LG00 and helical beams LG0m, we found that the optimal beam waist leading to the most energetic electrons at full width at half maximum is more than twice smaller for the latter and corresponds to a few wavelengths Δw0 = {6,11,19}λ0 for laser powers of P0 = {0.1, 1,10} PW. We also found that, for azimuthal modes m ≥ 3, the optimal waist should be smaller than Δw0 < 19λ0. Using these optimal values, we have observed that the average kinetic energy gain of electrons is about an order of magnitude larger in helical beams compared to the fundamental Gaussian beam. This average energy gain increases with the azimuthal index m leading to collimated electrons of a few 100 MeV energy in the direction of the laser propagation.

In two-dimensional (2D) electron systems, the viscous flow is dominant when electron-electron collisions occur more frequently than the impurity or phonon scattering. In this work, a quantum hydrodynamic model, considering viscosity, is proposed to investigate the interaction of a charged particle moving above the two-dimensional viscous electron gas. The stopping power, perturbed electron gas density, and the spatial distribution of the velocity vector field have been theoretically analyzed and numerically calculated. The calculation results show that viscosity affects the spatial distribution and amplitude of the velocity field. The stopping power, which is an essential quantity for describing the interactions of ions with the 2D electron gas, is calculated, indicating that the incident particle will suffer less energy loss due to the weakening of the dynamic electron polarization and induced electric field in 2D electron gas with the viscosity. The values of the stopping power may be more accurate after considering the effect of viscosity. Our results may open up new possibilities to control the interaction of ions with 2D electron gas in the surface of metal or semiconductor heterostructure by variation of the viscosity.

To accelerate high-intensity heavy-ion beams to high energy in the booster ring (BRing) at the High-Intensity Heavy-Ion Accelerator Facility (HIAF) project, we take the typical reference particle 238U35+, which can be accelerated from an injection energy of 17 MeV/u to the maximal extraction energy of 830 MeV/u, as an example to study the basic processes of longitudinal beam dynamics, including beam capture, acceleration, and bunch merging. The voltage amplitude, the synchronous phase, and the frequency program of the RF system during the operational cycle were given, and the beam properties such as bunch length, momentum spread, longitudinal beam emittance, and beam loss were derived, firstly. Then, the beam properties under different voltage amplitude and synchronous phase errors were also studied, and the results were compared with the cases without any errors. Next, the beam properties with the injection energy fluctuation were also studied. The tolerances of the RF errors and injection energy fluctuation were dictated based on the CISP simulations. Finally, the effect of space charge at the low injection energy with different beam intensities on longitudinal emittance and beam loss was evaluated.

For low carbon energy generation, a very large exchange of electricity generators is existentially vital within the next number of years by power stations preferably at considerably low cost than the present installations. When considering the million times higher nuclear energy per reaction than chemical, the usual hydrogen fusion with abundant boron fuel is used for environmentally clean electricity generators. Instead of usually needed ignition temperatures of hundreds of million degrees Celsius, it is possible to use nonthermal ignition pressures from now available CPA laser pulses. In this non-LTE scheme, there is no need for high compression, the medium of hydrogen-boron-11 temperatures is low, and therefore the bremsstrahlung losses practically do not exist. The neutron, created by secondary reactions, elimination device includes tin and is arranged such that the neutrons are brought to nuclear reactions with the tin. We suggest adding the tin that has proven to be particularly advantageous because of its high effective cross section, and the neutron reactions with tin transform the tin nuclei into stable nuclei with a higher atomic weight.

With the advantages of short duration and extreme brightness, laser proton accelerators (LPAs) show great potential in many fields for industrial, medical, and research applications. However, the quality of current laser-driven proton beams, such as the broad energy spread and large divergence angle, is still a challenge. We use numerical simulations to study the propagation of such proton bunches in the plasma. Results show the bunch will excite the wakefield and modulate itself. Although a small number of particles at the head of the bunch cannot be manipulated by the wakefield, the total energy spread is reduced. Moreover, while reducing the longitudinal energy spread, the wakefield will also pinch the beam in the transverse direction. The space charge effect of the bunch is completely offset by the wakefield, and the transverse momentum of the bunch decreases as the bunch transports in the plasma. For laser-driven ion beams, our study provides a novel idea about the optimization of these beams.

It is shown that the dynamics of electrons accelerated in narrow capillary waveguides is significantly influenced by the parametric excitation of their betatron oscillations. On the one hand, this excitation can irreversibly spoil the emittance of an accelerated electron bunch that limits the possibilities of their practical use. On the other hand, controlled parametric excitation of betatron oscillations can be used to generate short-pulse sources of synchrotron radiation. The article analyzes the regions of parametric instabilities, their dependence on the parameters of accelerated electron bunches and guiding structures, and their influence on the dynamics of accelerated electrons. The parameters of the generated synchrotron radiation are also estimated. Measurements of the spectral parameters of synchrotron radiation can serve as a tool for diagnostics of betatron oscillations and their excitation in the case of parametric resonances.

In this work, we present experimental results on the behavior of liquid water at megabar pressure. The experiment was performed using the HIPER (High-Intensity Plasma Experimental Research) laser facility, a uniaxial irradiation chamber of GEKKO XII (GXII) at the Institute of Laser Engineering (ILE), and the PHELIX at GSI (GSI Helmholtz Centre for Heavy Ion Research), a single-beam high-power laser facility, to launch a planar shock into solid multilayered water samples. Equation-of-state data of water (H2O are obtained in the pressure range 0.50–4.6 Mbar by tuning the laser-drive parameters. The Hugoniot parameters (pressure, density, etc.) and the shock temperature were simultaneously determined by using VISAR and SOP as diagnostic tools and quartz as the standard material for impedance mismatch experiments. Finally, our experimental results are compared with hydrodynamic simulations tested with different equations of state, showing good compatibility with tabulated SESAME tables for water.

Solid-state nuclear track detectors (CR-39 type) are frequently used for the detection of ions accelerated by laser-plasma interaction because they are sensitive to each single particle. To the present day, CR-39 detectors are the main diagnostics in experiments focused on laser-driven proton-boron (p11B) fusion reactions to detect alpha particles, which are the main products of such a nuclear reaction, and to reconstruct their energy distribution. However, the acceleration of multispecies ions in the laser-generated plasma makes this spectroscopic method complex and often does not allow to unambiguously discriminate the alpha particles generated from p11B fusion events from the laser-driven ions. In this experimental work, performed at the PALS laser facility (600 J, 300 ps, laser intensity 1016 W/cm2), CR-39 detectors were used as main detectors for the angular distribution of the produced alpha particles during a p11B fusion dedicated experimental campaign. Additionally, a CR-39 detector was set inside a Thomson Parabola (TP) spectrometer with the aim to calibrate the CR-39 response for low energetic laser-driven ions originating from the plasma in the given experimental conditions. The detected ion energies were ranging from hundreds of keV to a few MeV, and the ion track diameters were measured for etching times up to 9 hours. The goal of the test was the evaluation of the detectors’ ability to discriminate the alpha particles from the aforementioned ions. Within this study, the calibration curves for protons and silicon low energy ions are accomplished, the overlapping of the proton tracks and alpha particles is verified, and a methodology to avoid this problem is realized.

In the present paper, filamentous structure formation, associated turbulent spectrum, and density cavity formation phenomena have been investigated for low-β plasma $\left(\beta \ll m_e/m_i\right)$ applicable to the auroral region. A set of dimensionless equations governing the dynamics of three dimensionally propagating inertial Alfvén wave (3D-IAW) and perpendicularly propagating magnetosonic wave (PMSW) has been developed. Ponderomotive force due to 3D-IAW has been included in the dynamics of the PMSW. Numerical simulation has been performed to study the nonlinear coupling of these two waves. From the obtained results, we found that the field intensity localization takes place which may further lead to the additional dissipation/turbulence process for particle heating and acceleration in space plasma. The associated turbulent spectrum is obtained with scaling nearly k−4.28 at smaller scales (in the dissipation range). Relevance of the obtained results with the observations reported by various spacecrafts such as Hawkeye and Heos 2 has been discussed. Also, density fluctuations (depletion) of ∼0.10 n0 are calculated, which are consistent with the FAST spacecraft observation reported.

The single ionization and dissociation of ethanol molecules induced by low-energy electrons (E0 = 90 eV) are investigated using multiparticle coincident momentum spectroscopy. By detecting two outgoing electrons (e1 and e2) and one fragment ion in coincidence, we obtain the energy deposition (E0 − E1 − E2) during electron ionization of the molecule, i.e., the binding energy spectra, for production of the different ionic fragments C2H5OH+, C2H4OH+, COH+, and H3O+. These data allow us to study the ionization channels for different ionic products. In particular, we focus on H3O+ as a product of double hydrogen migration. It is found that this channel mainly originates from the ionization of outer-valance orbitals (3a″,10a′, 2a″, 9a′, 8a′, 1a″, and 7a′). Additionally, there are minor contributions from the inner-valence orbitals such as 6a′, 5a′, and 4a′. Quantum chemistry calculations show two fragmentation pathways: concerted and sequential processes for formation of H3O+.

The laser-induced breakdown spectroscopy (LIBS) technique is one of the most promising laser-based analytical techniques. Coincidentally, the LIBS acronym was proposed by Radziemski and Loree in two seminal papers published in 1981, almost at the same time in which the Laser and Particle Beams journal started its publication. In this contribution, the evolution of the LIBS technique is discussed following a chronological collection of key papers in LIBS, some of which were in fact published on LPB.

In this paper, we characterize a high repetition-rate regenerating plasma mirror produced by the thin film of liquid formed when two laminar streams collide. The use of a flowing liquid film is inexpensive and the interaction surface refreshes automatically, avoiding buildup of on-target debris. The composition of the liquid material and the relative angle of the film-generating nozzles was optimized for this application. Spectra measured in reflection from a water-based plasma mirror showed a blue shift but an optical reflectivity of up to 30%. The thickness of the film was found to be of the order of 2 ${\rm \mu}$m, and the stability of the reflected spot was ${\approx }1$ mrad. The reflected beam profile was highly distorted but stable. Further optimization of the nozzles to affect the fluid flow should enable significant improvements in control of the fluid films and increase in the reflectivity of these mirrors.

We present a theory for describing the inner structure of the electron bunch in the bubble regime starting from a random distribution of electrons inside the bubble and subsequently minimizing the system's energy. Consequently, we find a filament-like structure in the direction of propagation that is surrounded by various shells consisting of further electrons. If we specify a two-dimensional (2D) initial structure, we observe a hexagonal structure for a high number of particles, corresponding to the close packing of spheres in two dimensions. The 2D structures are in agreement with the equilibrium slice model.

The efficient transfer of angular orbital momentum from circularly polarized laser pulses into ions of solid density targets is investigated with different geometries using particle-in-cell simulations. The detailed electron and ion dynamics presented focus upon the energy and momentum conversion efficiency. It is found that the momentum transfer is more efficient for spiral targets and the maximum value is obtained when the spiral step is equal to twice the laser wavelength. This study reveals that the angular momentum distribution of ions strongly depends up on the initial target shape and density.

The measured spatial-intensity distribution of the beam of protons accelerated from the rear side of a solid target irradiated by an intense (>1019 Wcm−2) laser pulse provides a diagnostic of the two-dimensional fast electron density profile at the target rear surface and thus the fast electron beam transport pattern within the target. An analytical model is developed, accounting for rear-surface fast electron sheath dynamics, ionization and projection of the resulting beam of protons. The sensitivity of the spatial-intensity distribution of the proton beam to the fast electron density distribution is investigated. An annular fast electron beam transport pattern with filamentary structure is inferred for the case of a thick diamond target irradiated at a peak laser intensity of 6 × 1019 Wcm−2.