Hostname: page-component-cd9895bd7-gbm5v Total loading time: 0 Render date: 2024-12-19T03:11:23.198Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of electric current direction on the microstructural evolution and mechanical properties of a cold-rolled Cu–Zn alloy during the phase transformation induced by electric current pulses

Published online by Cambridge University Press:  07 August 2015

Xinli Wang ,
Meishuai Liu ,
Wenbin Dai ,
Nan Wu  and
Xiang Zhao
Xinli Wang*
Affiliation:
Research Institute, Northeastern University, Shenyang 110004, People's Republic of China
Meishuai Liu
Affiliation:
Key Laboratory for Anisotropy and Texture of Materials (Ministry of Education), Northeastern University, Shenyang 110819, People's Republic of China
Wenbin Dai
Affiliation:
School of Materials and Metallurgy, Northeastern University, Shenyang 110819, People's Republic of China
Nan Wu
Affiliation:
Key Laboratory for Anisotropy and Texture of Materials (Ministry of Education), Northeastern University, Shenyang 110819, People's Republic of China
Xiang Zhao*
Affiliation:
Key Laboratory for Anisotropy and Texture of Materials (Ministry of Education), Northeastern University, Shenyang 110819, People's Republic of China
*
a)Address all correspondence to these authors. e-mail: [email protected]
b)e-mail: [email protected]
Get access

Abstract

The effect of current direction (CD) on the microstructural evolution and mechanical properties of a Cu–Zn binary phase (α + β) alloy during the primary process of phase transformation induced by electric current pulses (ECP) treatment was investigated. To clarify the effect of CD, the samples were prepared with different angles between the CD and rolling direction (RD) from 0° to 90°. Results showed that not only the microstructural evolution but also the corresponding mechanical properties all had a saddle point in the sample with the angle 45°. Analyzed from the mechanical properties, it could be found that the anisotropic of the materials becomes stronger due to the application of ECP. An important finding is that by changing the angles between the CD and the RD, a novel and effective approach to control the phase transformation process could be provided.

Keywords

electric current pulsescurrent directionphase transformation
Type
Articles
Information
Journal of Materials Research , Volume 30 , Issue 16 , 28 August 2015 , pp. 2500 - 2507
Copyright
Copyright © Materials Research Society 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Dolinsky, Y. and Elperin, T.: Peculiarities of coexistence of phases with different electric conductivities under the influence of electric current. Mater. Sci. Eng., A 287, 219 (2000).CrossRefGoogle Scholar
Conrad, H.: Effects of electric current on solid state phase transformations in metal. Mater. Sci. Eng., A 287, 227 (2000).CrossRefGoogle Scholar
Qin, R.S. and Zhou, B.L.: Effect of electric current pulses on grain size in castings. Int. J. Non-Equilib. Process. 11, 77 (1998).Google Scholar
Zhou, Y.Z., Zhang, W., Guo, J.D., and He, G.H.: Diffusive phase transformation in a Cu–Zn alloy under rapid heating by electropulsing. Philos. Mag. Lett. 84, 341 (2004).CrossRefGoogle Scholar
Wang, X.L., Guo, J.D., Wang, Y.M., Wu, X.Y., and Wang, B.Q.: Segregation of lead in Cu–Zn alloy under electric current pulses. Appl. Phys. Lett. 89, 061910 (2006).CrossRefGoogle Scholar
Zhu, Y.H., To, S., Lee, W.B., Liu, X.M., Jiang, Y.B., and Tang, G.Y.: Effects of dynamic electropulsing on microstructure and elongation of a Zn–Al alloy. Mater. Sci. Eng., A 501, 125 (2009).CrossRefGoogle Scholar
Jiang, Y.B., Tang, G.Y., Shek, C.H., Zhu, Y.H., and Xu, Z.H.: On thermodynamics and kinetics of electropulsing induced dissolution of β-Mg17Al12 phase in aged Mg-9Al-1Zn alloy. Acta Mater. 57, 4797 (2009).CrossRefGoogle Scholar
Dai, W.B., Wang, X.L., Zhao, H.M., and Zhao, X.: Effect of electric current on grain orientation in a cold rolled Fe-3%Si steel. Mater. Trans. 53, 229 (2012).CrossRefGoogle Scholar
Wang, X.L., Dai, W.B., Ma, C.W., and Zhao, X.: Effect of electric current direction on recrystallization rate and texture of a Cu-Zn alloy. J. Mater. Res. 28, 1378 (2013).CrossRefGoogle Scholar
Wang, X.L., Zan, N., Wu, N., Gromov, V.E., Dai, W.B., Liu, M.S., and Zhao, X.: Recrystallized microstructural evolution under different current direction in a Cu-Zn alloy. Fundam. Probl. Mod. Mater. Sci. 12, 143 (2015).Google Scholar
Wang, X.L., Dai, W.B., Wang, R., Tian, X.Z., and Zhao, X.: Enhanced phase transformation and variant selection by electric current pulses in a Cu-Zn alloy. J. Mater. Res. 29, 975 (2014).CrossRefGoogle Scholar
Conrad, H. and Sprecher, A.F.: Dislocations in Solids; Nabarro, F.R.N. ed.; Elsevier: Amsterdam, 1989; p. 499.Google Scholar
Dolinsky, Y. and Elperin, T.: Thermodynamics of phase transitions in current-carrying conductors. Phys. Rev. B: Condens. Matter 47, 14778 (1993).CrossRefGoogle ScholarPubMed
Hummel, R.E.: Electromigration and related failure mechanisms in integrated circuit interconnects. Int. Mater. Rev. 39, 97 (1994).CrossRefGoogle Scholar
Blech, I.A.: Electromigration in thin aluminum films on titanium nitride. J. Appl. Phys. 47, 1203 (1976).CrossRefGoogle Scholar
Huntington, H.B. and Grone, A.R.: Current-induced marker motion in gold wires. J. Phys. Chem. Solids 20, 76 (1961).CrossRefGoogle Scholar
Ho, P.S. and Kwok, T.: Electromigration in metals. Rep. Prog. Phys. 52, 301 (1989).CrossRefGoogle Scholar
Brandes, E.A.: Smithells Metals Reference Book (Butterworth, Washington, DC, 1983); p. 13–17.Google Scholar
Wert, C. and Zener, C.: Interstitial atomic diffusion coefficients. Phys. Rev. 76, 1169 (1949).CrossRefGoogle Scholar