We present the generation of high-repetition-rate strong-field terahertz (THz) pulses from a thin 4-N,N-dimethylamino-4’-N’-methyl-stilbazolium 2,4,6-trimethylbenzenesulfonate (DSTMS) organic crystal pumped by an ytterbium-doped yttrium aluminum garnet laser. The generated THz pulse energy reaches 932.8 nJ at 1 kHz repetition rate, with a conversion efficiency of 0.19% and a peak electric field of 819 kV/cm. At a repetition rate of 10 kHz, it is able to maintain a peak electric field of 236 kV/cm and an average THz power of 0.77 mW. The high-repetition-rate, strong-field THz source provides a convenient tool for the study of THz matter manipulation and THz spectroscopy.

The delay-shift of the pre-pulse may mislead the determination of its origination and cause problems for the temporal contrast improvement of high-peak-power lasers, especially when the corresponding post-pulse is beyond the time window of the measurement device. In this work, an empirical formula is proposed to predict the delay-shift of pre-pulses for the first time. The empirical formula shows that the delay-shift is proportional to the square of the post-pulse’s initial delay, and also the ratio of the third-order dispersion to the group delay dispersion’s square, which intuitively reveals the main cause for the delay-shift and may provide a convenient routing for identifying the real sources of pre-pulses in both chirped-pulse amplification (CPA) and optical parametric chirped-pulse amplification (OPCPA) systems. The empirical formula agrees well with the experimental results both in the CPA and the OPCPA systems. Besides, a numerical simulation is also carried out to further verify the empirical formula.

We reported on an efficient high-power continuous-wave laser operation on the 3H4 → 3H5 transition of Tm3+ ions in a diffusion-bonded composite YVO4/Tm:GdVO4 crystal. Pumped by a laser diode at 794 nm, a maximum output power of 7.5 W was obtained from a YVO4/Tm:GdVO4 laser at 2.29 μm, corresponding to a slope efficiency of 40.3% and exceeding the Stokes limit. To the best of our knowledge, this result represents the maximum power ever achieved from a Tm laser at 2.3 μm.

Simultaneous ultra-intense pulses at petawatt laser facilities enable a broad range of experiments in nuclear photonics and strong field quantum electrodynamics. These experiments often require very precise control of the time delays between pulses. We report measurements of the time delay between the two 1 PW outputs of the Extreme Light Infrastructure - Nuclear Physics (ELI-NP) facility in Romania. The short-term standard deviation of the time delay was approximately half of the pulse duration of 23 fs, and the average delay drifted with up to 100 fs/h. The drift and sporadic delay jumps were corrected using a feedback loop, which reduced the long-term standard deviation of the delay close to its short-term value. These results imply that in ELI-NP experiments using two simultaneous pulses, a temporal overlap of better than half of the pulse duration can be achieved for more than two thirds of the shots, which would enable high data rate experiments using simultaneous petawatt pulses.

Er:CaF2 crystals are crucial gain media for producing 3 μm mid-infrared (MIR) lasers pumped by 976 nm continuous-wave (CW) lasers owing to their low phonon energy and high conversion efficiency. This study investigated the damage characteristics and mechanism of Er:CaF2 crystals irradiated with a 976 nm CW laser. The laser-induced damage threshold of Er:CaF2 crystals with different Er3+ doping levels was tested; the damage morphology consists of a series of regular 70° cracks related to the angle of the crystal slip system on the surface. A finite-element model was used to calculate the temperature and stress fields of the crystals. The results indicated that the damage can be attributed to surface tensile stresses caused by the temperature gradient, and crystals with higher doping concentrations were more susceptible to damage owing to stronger light absorption. These findings provide valuable insights into the development of high-power MIR lasers.

Femtosecond oscillators with gigahertz (GHz) repetition rate are appealing sources for spectroscopic applications benefiting from the individually accessible and high-power comb line. The mode mismatch between the potent pump laser diode (LD) and the incredibly small laser cavity, however, limits the average output power of existing GHz Kerr-lens mode-locked (KLM) oscillators to tens of milliwatts. Here, we present a novel method that solves the difficulty and permits high average power LD-pumped KLM oscillators at GHz repetition rate. We propose a numerical simulation method to guide the realization of Kerr-lens mode-locking and comprehend the dynamics of the Kerr-lens mode-locking process. As a proof-of-principle demonstration, an LD-pumped Yb:KGW oscillator with up to 6.17-W average power and 184-fs pulse duration at 1.6-GHz repetition rate is conducted. The simulation had a good agreement with the experimental results. The cost-effective, compact and powerful laser source opens up new possibilities for research and industrial applications.

The high-power narrow-linewidth fiber laser has become the most widely used high-power laser source nowadays. Further breakthroughs of the output power depend on comprehensive optimization of stimulated Brillouin scattering (SBS), stimulated Raman scattering (SRS) and transverse mode instability (TMI). In this work, we aim to further surpass the power record of all-fiberized and narrow-linewidth fiber amplifiers with near-diffraction-limited (NDL) beam quality. SBS is suppressed by white-noise-signal modulation of a single-frequency seed. In particular, the refractive index of the large-mode-area active fiber in the main amplifier is controlled and fabricated, which could simultaneously increase the effective mode field area of the fundamental mode and the loss coefficient of higher-order modes for balancing SRS and TMI. Subsequent experimental measurements demonstrate a 7.03 kW narrow-linewidth fiber laser with a signal-to-noise ratio of 31.4 dB and beam quality factors of Mx2 = 1.26, My2 = 1.25. To the best of our knowledge, this is the highest reported power with NDL beam quality based on a directly laser-diode-pumped and all-fiberized format, especially with narrow-linewidth spectral emission.

A high-energy picosecond 355 nm ultraviolet (UV) laser operating at 100 Hz was demonstrated. A 352 mJ, 69 ps, 1064 nm laser at 100 Hz was realized firstly by cascaded regenerative, laser diode end-pumped single-pass and side-pumped main amplifiers. The stimulated Raman scattering-based beam shaping technique, thermally induced birefringence compensation and 4f spatial filter-image relaying systems were used to maintain a relatively homogeneous beam intensity distribution during the amplification process. By using lithium triborate crystals for second- and third-harmonic generation (THG), a 172 mJ, approximately 56 ps, 355 nm UV laser was achieved with a THG conversion efficiency of 49%. To the best of our knowledge, it is the highest pulse energy of a picosecond 355 nm UV laser so far. The beam quality factor ${M}^2$ and pulse energy stability were ${M}_x^2$=3.92, ${M}_y^2$=3.71 and root mean square of 1.48%@3 hours. This laser system could play significant roles in applications including photoconductive switch excitation, laser drilling and laser micro-fabrication.

Isolated multi-MeV $\gamma$-rays with attosecond duration, high collimation and beam angular momentum (BAM) may find many interesting applications in nuclear physics, astrophysics, etc. Here, we propose a scheme to generate such $\gamma$-rays via nonlinear Thomson scattering of a rotating relativistic electron sheet driven by a few-cycle twisted laser pulse interacting with a micro-droplet target. Our model clarifies the laser intensity threshold and carrier-envelope phase effect on the generation of the isolated electron sheet. Three-dimensional numerical simulations demonstrate the $\gamma$-ray emission with 320 attoseconds duration and peak brilliance of $9.3\times 10^{24}$ photons s${}^{-1}$ mrad${}^{-2}$ mm${}^{-2}$ per 0.1$\%$ bandwidth at 4.3 MeV. The $\gamma$-ray beam carries a large BAM of $2.8 \times 10^{16}\mathrm{\hslash}$, which arises from the efficient BAM transfer from the rotating electron sheet, subsequently leading to a unique angular distribution. This work should promote the experimental investigation of nonlinear Thomson scattering of rotating electron sheets in large laser facilities.