Duplex stainless steels, a review after DSS'07 in Grado

J. Charles

doi:10.1051/metal:2008028

Abstract

Duplex stainless steels present simultaneously very diversified technicalchallenges and very attractive in service properties along withexcellent cost/properties ratios particularly in very critical markets: oiland gas, chemical industry, pulp and paper industry, water systems,desalination plants, pollution control equipments, chemical tankers.This paper reviews the 100 scientific contributions at the latestinternational Duplex Stainless Steel Conference DSS'07 in Grado,Italy, June 18-20, 2007.

Crossref Citations

This article has been cited by the following publications. This list is generated based on data provided by Crossref.

Colli, Marcela Nunes Santos, Daniella Caluscio dos and Morais, Luara da Costa 2013. ESTUDO DA INFLUÊNCIA DA TEMPERATURA NA CORROSÃO SELETIVA DO AÇO UNS S31803 EM SOLUÇÃO 1M HCL. p. 356.

Santos, Daniella Caluscio dos Magnabosco, Rodrigo and de Moura-Neto, Carlos 2013. Influence of Sigma Phase Formation on Pitting Corrosion of an Aged UNS S31803 Duplex Stainless Steel. Corrosion, Vol. 69, Issue. 9, p. 900.

Elsabbagh, Fady M. Hamouda, Rawia M. and Taha, Mohamed A. 2014. On Microstructure and Microhardness of Isothermally Aged UNS S32760 and the Effect on Toughness and Corrosion Behavior. Journal of Materials Engineering and Performance, Vol. 23, Issue. 1, p. 275.

Pilhagen, Johan and Sandström, Rolf 2014. Influence of nickel on the toughness of lean duplex stainless steel welds. Materials Science and Engineering: A, Vol. 602, Issue. , p. 49.

Shamanian, Morteza Eghlimi, Abbas Eskandarian, Masoomeh and Szpunar, Jerzy A. 2014. Interface microstructure across cladding of super duplex stainless steel with austenitic stainless steel buffer layer. Surface and Coatings Technology, Vol. 259, Issue. , p. 532.

Pilhagen, Johan Sieurin, Henrik and Sandström, Rolf 2014. Fracture toughness of a welded super duplex stainless steel. Materials Science and Engineering: A, Vol. 606, Issue. , p. 40.

Liu, Tie Zhiyong, Richard Wu Xu, Daqin and Aung, Aye Aye 2014. Metallurgical Analysis on a Cracked Super Duplex Stainless Steel Flange. Journal of Failure Analysis and Prevention, Vol. 14, Issue. 4, p. 470.

Palumbo, Gianfranco Piglionico, Vito Piccininni, Antonio Guglielmi, Pasquale Sorgente, Donato and Tricarico, Luigi 2015. Determination of interfacial heat transfer coefficients in a sand mould casting process using an optimised inverse analysis. Applied Thermal Engineering, Vol. 78, Issue. , p. 682.

dos Santos, Daniella Caluscio and Magnabosco, Rodrigo 2016. Kinetic Study to Predict Sigma Phase Formation in Duplex Stainless Steels. Metallurgical and Materials Transactions A, Vol. 47, Issue. 4, p. 1554.

Pennington, Jamie Wynne, Bradley P. and Byrne, Glenn 2016. Constitutive Equation Development to Model the Hot Forging of ZERON®100 Super Duplex Stainless Steel and Associated Microstructural Evolution. Key Engineering Materials, Vol. 716, Issue. , p. 632.

Morais, Luara da Costa and Magnabosco, Rodrigo 2017. Experimental investigations and DICTRA® simulation of sigma phase formation in a duplex stainless steel. Calphad, Vol. 58, Issue. , p. 214.

Wan, Jianquan Ruan, Haihui Wang, Jianbiao and Shi, Sanqiang 2018. The Kinetic diagram of sigma phase and its precipitation hardening effect on 15Cr-2Ni duplex stainless steel. Materials Science and Engineering: A, Vol. 711, Issue. , p. 571.

Gao, Tao Wang, Jian Sun, Qi and Han, Peide 2018. Corrosion Behavior Difference in Initial Period for Hot-Rolled and Cold-Rolled 2205 Duplex Stainless Steels. Metals, Vol. 8, Issue. 6, p. 407.

Gonçalves, Karina Aparecida Martins Barcelos Santos, Dagoberto Brandão and Oliveira, Tarcísio Reis de 2018. Analysis of the Crystallographic Microtexture of a UNS S32205 and a UNS S32304 Duplex Stainless Steels After Cold Rolling and Heat Treatment. Materials Research, Vol. 21, Issue. 4,

Caetano, G. A. and Passos, C.A. C. 2019. ANÁLISE COMPARATIVA ENTRE MÉTODOS DE QUANTIFICAÇÃO DE FASES EM METAIS POR PROCESSAMENTO E ANÁLISE DE IMAGENS. p. 20.

Magnabosco, Rodrigo da Costa Morais, Luara and dos Santos, Daniella Caluscio 2019. Use of composition profiles near sigma phase for assessment of localized corrosion resistance in a duplex stainless steel. Calphad, Vol. 64, Issue. , p. 126.

Garfinkel, David A. Poplawsky, Jonathan D. Guo, Wei Young, George A. and Tucker, Julie D. 2019. Proceedings of the 18th International Conference on Environmental Degradation of Materials in Nuclear Power Systems – Water Reactors. p. 2399.

Sun, Tian-Yi Guo, Yan-Jun Jiang, Yi-Ming and Li, Jin 2019. Effect of Short-Time Aging on the Pitting Corrosion Behavior of a Novel Lean Duplex Stainless Steel 2002. Acta Metallurgica Sinica (English Letters), Vol. 32, Issue. 6, p. 755.

Oliveira, Clélia Ribeiro de Maia, Eloá Lopes Fonseca, Solange Tamara da Martins, Marcelo Avila, Julian Arnaldo and Mei, Paulo Roberto 2019. Microstructural Evolution Due to One Thermal Cycle in a Superduplex Stainless Steel ASTM A890/A890M - Grade 6A in the As-Weld and Post-Weld Heat Treatment Conditions. Materials Research, Vol. 22, Issue. 4,

Download full list

Article contents

Duplex stainless steels, a review after DSS'07 in Grado

Abstract

Access options

This article has been cited by the following publications. This list is generated based on data provided by Crossref.

Article contents

Duplex stainless steels, a review after DSS'07 in Grado

Abstract

Access options

Save article to Kindle

Save article to Dropbox

Save article to Google Drive

Reply to: Submit a response

Your details

You have entered the maximum number of contributors

Conflicting interests