Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-27T23:08:33.188Z Has data issue: false hasContentIssue false
  • English
  • Français

Dynamic Analysis of Non-Symmetric Cracks Extension

Published online by Cambridge University Press:  05 May 2011

Yen-Ling Chung  and
Mei-Rong Chen
Yen-Ling Chung*
Affiliation:
Department of Construction Engineering, National Taiwan University of Science and Technology, Taipei, Taiwan 10672, R.O.C.
Mei-Rong Chen*
Affiliation:
Department of Construction Engineering, National Taiwan University of Science and Technology, Taipei, Taiwan 10672, R.O.C.
*
*Professor
**Graduate student
Get access

Abstract

This paper applies the method of self-similar potentials to analyze the dynamic behaviors of the problems of mode-I, mode-II, and mode-III cracks propagating along the x-axis with constant speed, while the constant speeds of both crack tips are not the same, called nonsymmetric crack expansion. It is assumed that an unbound homogeneous isotropic elastic material is at rest for time t < 0. However, for time t ≥ 0, a central crack starts to extend from zero length along the x-axis. On the crack surfaces of x ≥ 0, there exists uniform distributed load such that the rightmost crack tip propagates with speed ms, while the leftmost crack tip with speed s, where m > 1 and is constant. First, the complete solutions of the mode-I, mode-II, and mode-III problems are obtained. After the complete solutions are found, attention is focused on the crack surface displacements and dynamic stress intensity factors. The results of this study show that the DSIF is equal to the static SIF when the crack-tip speed is zero, and DSIF is zero as the crack-tip speed approaches the Rayleigh-wave speed. Moreover, for the special case m = 1 which indicates that the velocities of both crack tips are the same, the DSIFs of this three modes in this study is the same as those of Ref. [15].

Keywords

The method of self-similar potentialsNonsymmetric crack expansionCrack surface displacementDynamic stress intensity factor
Type
Articles
Information
Journal of Mechanics , Volume 16 , Issue 3 , September 2000 , pp. 157 - 167
Copyright
Copyright © The Society of Theoretical and Applied Mechanics, R.O.C. 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Eringen, A. C. and Suhubi, E. S., Elastodynamics, Vol. II, Academic Press, New York (1975).Google Scholar
2Sih, G. C. and Embley, G. T., “Sudden Twisting of a Penny-shaped Crack,” Journal of Applied Mechanics, 39, pp. 395–400 (1972).CrossRefGoogle Scholar
3Kostrov, B. V., “The Axisymmetric Problem of Propagation of a Tension Crack,” Journal of Applied Mathematics and Mechanics, 28, pp. 793–803 (1964).CrossRefGoogle Scholar
4Kostrov, B. V., “Self-Similar Problems of Propagation of Shear Cracks,” Journal of Applied Mathematics and Mechanics, 28, pp. 1077–1087 (1964).CrossRefGoogle Scholar
5Nilsson, F., “A Note on the Stress Singularity at a Nonuniformly Moving Crack Tip,” Journal of Elasticity, 4, pp. 73–75 (1974).CrossRefGoogle Scholar
6Ing, Y. S. and Ma, C. C., “Transient Analysis of a Propagating Crack with Finite Length Subjected to a Horizontally Polarized Shear Wave,” International Journal of Solids and Structures, 36, pp. 4609–4627 (1999).CrossRefGoogle Scholar
7Freund, L. B., Dynamic Fracture Mechanics, Cambridge University Press, New York, pp. 334–336 (1990).CrossRefGoogle Scholar
8Achenbach, J. D., Wave Propagation in Elastic Solids, North-Holland (1973).Google Scholar
9Freund, L. B., “Crack Propagation in an Elastic Solid Subjected to General Loading — I Constant Rate Extension,” Journal of the Mechanics and Physics Solids, 20, pp. 129–140 (1972).CrossRefGoogle Scholar
10Cherepanov, G. P., “Some Dynamic Problems of the Theory of Elasticity – A Review,” International Journal of Engineering Science, 12, pp. 665–690 (1974).CrossRefGoogle Scholar
11Freund, L. B., “Crack Propagation in an Elastic Solid Subjected to General Loading – III Stress Wave Loading,” Journal of the Mechanics and Physics Solids, 21, pp. 46–61 (1973).CrossRefGoogle Scholar
12Smirov, V. I., A Course of Higher Mathematics, Addison-Wesley (1964).Google Scholar
13Thompson, J. C. and Robinson, A. R., “Exact Solution of Some Dynamic Problems of Indentation and Transient Loadings of an Elastic Half Space,” SRS 350, University of Illinois at Champaign-Urbana (1969).Google Scholar
14Johnson, J. J. and Robinson, A. R., “Wave Propagation in Half Space Due to an Interior Point Load Parallel to the Surface,” SRS 388, University of Illinois at Champaign-Urbana (1972).Google Scholar
15Chung, Y. L., “The Transient Solutions of Mode-I, Mode-II, Mode-III Cracks Problems,” Journal of the Chinese Institute of Civil and Hydraulic Engineering, 3, pp. 51–61 (1991).Google Scholar
16Chung, Y. L., “The Transient Problem of a Mode-III Interface Crack,” Engineering Fracture Mechanics, 41, pp. 321–330 (1992).CrossRefGoogle Scholar
17Chung, Y. L., “The Stress Singularity of Mode-I Crack Propagating with Transonic Speed,” Engineering Fracture Mechanics, 52, pp. 977–985 (1995).CrossRefGoogle Scholar
18Churchill, R. V., Complex Variables and Applications, McGraw-Hill, New York (1984).Google Scholar
19Hellan, K. R., Introduction to Fracture Mechanics, McGraw-Hill, New York (1984).Google Scholar
20Burridge, R., “Theoretical Seismic Sources and Propagating Brittle Cracks,” Journal of Physics of the Earth, 16, pp. 83–92 (1968).CrossRefGoogle Scholar
21Burridge, R. and Halliday, G. S., “Dynamic Shear Cracks with Friction as Models for Shallow Focus Earthquakes,” Geophysical Journal of the Royal Astronomical Society, 25, pp. 261–283 (1971).CrossRefGoogle Scholar