Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-28T06:56:37.811Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of strong magnetic field on solid solubility and microsegregation during directional solidification of Al–Cu alloy

Published online by Cambridge University Press:  10 October 2013

Xi Li ,
Annie Gagnoud ,
Zhongming Ren ,
Yves Fautrelle  and
François Debray
Xi Li*
Affiliation:
Department of Materials Science Engineering, Shanghai University, Shanghai 200072, People’s Republic of China; and EPM/SIMAP, Grenoble Institute of Technology, St Martin d’Heres Cedex 38402, France
Annie Gagnoud
Affiliation:
EPM/SIMAP, Grenoble Institute of Technology, St Martin d’Heres Cedex 38402, France
Zhongming Ren
Affiliation:
Department of Materials Science Engineering, Shanghai University, Shanghai 200072, People’s Republic of China
Yves Fautrelle
Affiliation:
EPM/SIMAP, Grenoble Institute of Technology, St Martin d’Heres Cedex 38402, France
François Debray
Affiliation:
Grenoble High Magnetic Field Laboratory, Grenoble Cedex 9, France
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The effect of a strong magnetic field on the solid solubility and the microsegregation during directional solidification of Al–Cu alloy at lower growth speeds (1–10 μm/s) has been investigated experimentally. Results indicate that the magnetic field causes the reduction of the grain boundary and promotes the amalgamation of the grains. Further, measurement results reveal that the magnetic field increases the solid solubility and decreases the microsegregation. It is also found that the value of the solid solubility increases as the magnetic field and the temperature gradient increase. The modification of the solid solubility and the microsegregation under the magnetic field is attributed to the thermoelectric magnetic force acting on the solid and the interdendritic thermoelectric magnetic convection. The present work may initiate a new method to enhance the solid solubility and to eliminate the microsegregation in Al-based alloys via an applied strong magnetic field during directional solidification.

Keywords

strong magnetic fieldsolid solubilitymicrosegregationAl–Cu alloy
Type
Articles
Information
Journal of Materials Research , Volume 28 , Issue 20 , 28 October 2013 , pp. 2810 - 2818
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Lan, C.W. and Tu, C.Y.: Three-dimensional analysis of flow and segregation control by slow rotation for Bridgman crystal growth in microgravity. J. Cryst. Growth 1881, 237 (2002).Google Scholar
Li, Z., Samuel, A.M., Samuel, F.H., and Ravidran, C.: Effect of alloying elements on the segregation and dissolution of CuAl2 phase in Al-Si-Cu 319 alloys. J. Mater. Sci. 38, 1203 (2003).CrossRefGoogle Scholar
Nishida, M., Kawamura, Y., and Yamamuro, T.: Formation process of unique microstructure in rapidly solidified Mg97Zn1Y2 alloy. Mater. Sci. Eng., A 1217, 375 (2004).Google Scholar
Loboda-Cackovic, J.: Segregation processes in PdCu(110) and the effects of sulphur impurity on surface composition and microstructure from annealing. Vacuum 48, 913 (1997).CrossRefGoogle Scholar
Stelian, C., Delannoy, Y., Fautrelle, Y., and Duffar, T.: Solute segregation in directional solidification of GaInSb concentrated alloys under alternating magnetic fields. J. Cryst. Growth 266, 207 (2004).CrossRefGoogle Scholar
Youdelis, W.V. and Dorward, R.C.. Directional solidification of aluminium-copper alloys in a magnetic field. Can. J. Phys. 44, 139 (1966).CrossRefGoogle Scholar
Youdelis, W.V. and Cahoon, J.R.: Diffusion in a magnetic field. Can. J. Phys. 48, 805 (1970).CrossRefGoogle Scholar
Asai, S.: Recent development and prospect of electromagnetic processing of materials. Sci. Technol. Adv. Mater. 1, 191 (2000).CrossRefGoogle Scholar
Yasuda, H., Ohnala, I., Yamamoto, Y., Wismogroho, A.S., Takezawa, N., and Kishio, K.: Alignment of BiMn crystal orientation in Bi-20 at% Mn alloys by laser melting under a magnetic field. Mater. Trans., JIM 44, 2550 (2003).CrossRefGoogle Scholar
Li, L., Zhang, Y.D., Esling, C., Zhao, Z.H., Zuo, Y.B., Zhang, H.T., and Cui, J.Z.: Formation of feathery grains with the application of a static magnetic field during direct chill casting of Al-9.8wt%Zn alloy. J. Mater. Sci. 44, 1063 (2009).CrossRefGoogle Scholar
Li, L., Zhang, Y.D., Esling, C., Jiang, H., Zhao, Z.H., Zuo, Y.B., and Cui, J.Z.: Crystallographic features of the primary Al3Fe phase in as-cast Al-3.31wt% Fe alloy. J. Appl. Crystallogr. 43, 1108 (2010).CrossRefGoogle Scholar
Liu, T., Wang, Q., Gao, A., Zhang, C., Wang, C.J., and He, J.C.: Fabrication of functionally graded materials by a semi-solid forming process under magnetic field gradients. Scr. Mater. 57, 992 (2007).CrossRefGoogle Scholar
Garcin, T., Rivoirard, S., Elgoyhen, C., and Beaugnon, E.: Experimental evidence and thermodynamics analysis of high magnetic field effects on the austenite to ferrite transformation temperature in Fe–C–Mn alloys. Acta Mater. 58, 2026 (2010).CrossRefGoogle Scholar
Zuo, X.W., Wang, E.G., Han, H., Zhang, L., and He, J.C.: Magnetic properties of Fe–49%Sn monotectic alloys solidified under a high magnetic field. J. Alloys Compd. 92, 621 (2010).CrossRefGoogle Scholar
Yasuda, H., Ohnaka, I., Ninomiya, Y., Ishii, R., Fujita, S., and Kishio, K.: Levitation of metallic melt by using the simultaneous imposition of the alternating and the static magnetic fields. J. Cryst. Growth 260, 475 (2004).CrossRefGoogle Scholar
Lu, X.Y., Nagata, A., Watanabe, K., Nojima, T., Sugawara, K., and Kamada, S.: Crystal growth of Bi-2201 phase in high magnetic fields. Physica C 382, 27 (2002).CrossRefGoogle Scholar
Wang, Q., Lou, C.S., Liu, T., Pang, X.J., Nakajima, K., and He, J.C.: Effects of uniform and gradient high magnetic fields on gravity segregation in aluminum alloys. ISIJ Int. 49, 1094 (2009).CrossRefGoogle Scholar
Wang, C.J., Wang, Q., Wang, Y.Q., Huang, J., and He, J.C.: Effects of high magnetic fields on the distribution of Si in solidified structures of Al-Si alloy. Acta Phys. Sin. 55, 648 (2006).CrossRefGoogle Scholar
Liu, T., Wang, Q., Hirota, N., Liu, Y., Chen, S.H., and He, J.C.: In situ control of the distributions of alloying elements in alloys in liquid state using high magnetic field gradients. J. Cryst. Growth 335, 121 (2011).CrossRefGoogle Scholar
Wang, J., Fautrelle, Y., and Ren, Z.M.: Modification of liquid/solid interface shape in directionally solidifying Al-Cu alloys by a transverse magnetic field. J. Mater. Sci. 48, 213 (2013).CrossRefGoogle Scholar
Yesilyurt, S., Vujisic, L., Motalkef, S., Szofran, F.R., and Volz, M.P.: A numerical investigation of the effect of thermoelectromagnetic convection (TEMC) on the Bridgman growth of Ge1–xSix. J. Cryst. Growth 207, 278 (1999).CrossRefGoogle Scholar
Wang, J., Fautrelle, Y., and Ren, Z.M.: Thermoelectric magnetic force acting on the solid during directional solidification under a static magnetic field. Appl. Phys. Lett. 101, 251904 (2012).CrossRefGoogle Scholar
Lehmann, P., Moreau, R., Camel, D., and Bolcato, R.: A simple analysis of the effect of convection on the structure of the mushy zone in the case of horizontal Bridgman solidification comparison with experimental results. Acta Mater. 46, 4067 (1998).CrossRefGoogle Scholar
Shercliff, J.A.: Thermoelectric magnetohydrodynamics. J. Fluid Mech. 91, 235 (1979).CrossRefGoogle Scholar
Li, X., Ren, Z.M., and Fautrelle, Y.: Effect of a high axial magnetic field on the microstructure in a directionally solidified Al-Al2Cu eutectic alloy. Acta Mater. 54, 5349 (2006).CrossRefGoogle Scholar
Brody, H.D. and Flemings, M.C.: Solute redistribution in dendritic solidification. Trans. Metall. Soc. AIME 236, 615 (1966).Google Scholar
Li, X., Fautrelle, Y., Ren, Z.M., Gagnoud, A., Moreau, R., Zhang, Y.D., and Esling, C.: Effect of a high magnetic field on the morphological instability and irregularity of the interface of a binary alloy during directional solidification. Acta Mater. 57, 1689 (2009).CrossRefGoogle Scholar
Sadigh, B., Lenosky, T.J., Caturla, M.J., Quong, A.A., and Benedict, L.X.: Large enhancement of boron solubility in silicon due to biaxial stress. Appl. Phys. Lett. 80, 4738 (2002).CrossRefGoogle Scholar
Hong, S.Q., Hong, Q.Z., and Mayer, J.W.: Effects of grown in stress on the metastable solid solubility limits in Sb implanted Ge0.1Si0.9 alloys. Appl. Phys. Lett. 63, 2054 (1993).CrossRefGoogle Scholar
Li, X., Gagnoud, A., Fautrelle, Y., Ren, Z.M., Cao, G.H., Moreau, R., Zhang, Y.D., and Esling, C.: Investigation of thermoelectric magnetic force in solid and its effect on morphological instability in directional solidification. J. Cryst. Growth 324, 217 (2011).Google Scholar
Boettinger, W.J., Biancaniello, F., and Coriell, S.: Solutal convection induced macrosegregation the dendrite to composite transition in off-eutectic alloys. Metall. Mater. Trans. A 12, 321 (1981).CrossRefGoogle Scholar
Tewari, S.N., Shah, R., and Song, H.: Effect of magnetic field on the microstructure and macrosegregation in directionally solidified Pb-Sn alloys. Metall. Mater. Trans. A 25, 1535 (1994).CrossRefGoogle Scholar
Alboussiere, T. and Moreau, R.: Influence of a magnetic-field on the solidification of metallic alloys. C. R. Acad. Sci. 313, 749 (1991).Google Scholar
Li, X., Gagnoud, A., Ren, Z.M., Fautrelle, Y., and Moreau, R.: Investigation of thermoelectric magnetic convection and its effect on solidification structure during directional solidification under a low axial magnetic field. Acta Mater. 57, 2180 (2009).CrossRefGoogle Scholar