Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-28T06:13:14.617Z Has data issue: false hasContentIssue false

Structure and mineralisation density of antler and pedicle bone in red deer (Cervus elaphus L.) exposed to different levels of environmental fluoride: a quantitative backscattered electron imaging study

Published online by Cambridge University Press:  01 January 2000

UWE KIERDORF
Affiliation:
Institute of General and Systematic Zoology, Justus-Liebig-University of Giessen, Giessen, Germany
HORST KIERDORF
Affiliation:
Zoological Institute, University of Cologne, Cologne, Germany
ALAN BOYDE
Affiliation:
Department of Anatomy and Developmental Biology, University College London, London, UK
Get access

Abstract

The structure and relative degree of mineralisation of antler and pedicle bone of yearling red deer stags exposed either to low or high levels of environmental fluoride were determined by digital quantitative backscattered electron (BSE) imaging. Bone fluoride content (BFC) in antlers (845±86 mg F/kg ash, arithmetic mean±S.E.M.) and pedicles (1448±154 mg F/kg ash) of deer from a highly fluoride polluted area in North Bohemia (Czech Republic) were significantly higher (P < 0.001) than those of controls from uncontaminated regions in West Germany (antlers: 206±41, pedicles: 322±52 mg F/kg ash). Mean (56.5±4.5%) and maximum (84.9±2.1%) mineralised bone area of the control antlers significantly (P < 0.05 and P < 0.001, respectively) exceeded the corresponding values for the N. Bohemian deer (43.3±1.3 and 73.3±1.9%, respectively), while the pedicles from the 2 groups did not differ significantly. In the pooled antler samples (n = 18), negative correlations existed between BFC and mean (rs = −0.62, P < 0.01) as well as maximum (rs = −0.69, P < 0.01) mineralised bone area. Morphological imaging revealed a decreased width and an increased porosity of the antler cortex in the N. Bohemian specimens. Mean (148.5±1.7) and maximum (154.2±1.7) BSE-signal intensities (= grey levels; range between a monobrominated (grey level 0) and a monoiodinated (grey level 255) dimethacrylate resin standard) of the antlers from the controls were significantly higher than those of the N. Bohemian deer (140.7±2.1 and 145.7±2.2, respectively ; P < 0.05 for both comparisons). In the pooled antler samples, negative correlations between BFC and mean (rs = −0.51, P < 0.05) as well as maximum (rs = −0.52, P < 0.05) BSE-signal intensities were observed. No significant differences in mineralisation density parameters were found for the 2 pedicle samples, and BFC and mineralisation density of the pooled pedicles were uncorrelated. Morphological imaging revealed bone mottling (denoting increased remodelling activity) and frequent occurrence of apparently increased osteocyte lacunae in some of the pedicles from the N. Bohemian deer. It is concluded that the reduced amount of mineralised bone in, and the lower mineralisation density of, the N. Bohemian antlers resulted from a fluoride induced disturbance of bone mineralisation. The rapid growth of antlers leads both to a high mineral demand and a high rate of fluoride uptake during antlerogenesis. This, and the limited lifespan of antlers, which does not allow for a compensation of a delay in the onset or progression of the mineralisation process, renders antler bone particularly susceptible to fluoride. Antlers are therefore considered a useful model for studying fluoride effects on bone formation. Furthermore, analysis of cast antlers enables a noninvasive monitoring of environmental pollution by fluorides.

Type
Research Article
Copyright
© Anatomical Society of Great Britain and Ireland 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)