We report on how the effects of mechanical compaction and clay mineral diagenesis have affected the alignment of phyllosilicates in a suite of Miocene-Pliocene mudstones buried to sub-seabed depths of between 1.8 and 5.8 km in the deep-water Gulf of Mexico. Mechanical compaction has reduced the porosity of the samples to 15% at 5 km, with modal pore sizes between 10 and 20 nm. High-resolution X-ray texture goniometry data show that the intense mechanical compaction has not resulted in a strongly aligned phyllosilicate fabric. The muds were apparently deposited with a weak or isotropic phyllosilicate fabric which was not substantially realigned by mechanical compaction. Unusually, X-ray diffraction of <0.2 µm separates shows that: (1) there is no illitization trend between 90 and 120°C; and (2) discrete smectite persists to ∼120°C, coexisting with R1 I-S or R0 I-S with 30–40% expandable layers. Between 120 and 130°C, discrete smectite disappears and the expandability of I-S decreases to ∼25–30%. We propose a two-stage diagenetic process involving (1) the alteration of volcanic glass to smectite and (2) the illitization of smectite and I-S; the alteration of glass results in smectite without a preferred orientation and retards the illitization reaction. We suggest that the lack of a strongly aligned phyllosilicate fabric reflects the apparently limited extent of illitization, and thus recrystallization, to which these mudstones have been subjected.

Under closed geochemical conditions, the weathering of a serpentinite rock composed of serpentine (70–85%) and magnesian chlorite (10–15%) associated with magnetite and chromite leads to the complete replacement of serpentine and chlorite by 2:1 layer silicates and produces new Fe oxides. The serpentine minerals crystallize under different habits issued from the serpentinization processes: mesh and hourglass pseudomorphic textures were formed from olivine, and thin-bladed pseudomorphic textures from pyroxene and amphibole crystals. Serpentine veins crosscut the whole rock with locally non-pseudomorphic interpenetrating and interlocking serpentines.

Specific weathering microsystem habits with specific clay mineral crystallizations originate from these different habits: a poorly aluminous saponite in thin-bladed textures, two Fe-rich montmorillonites in mesh and hourglass (MH) textures, and in veins (V) which differentiate on Al, Mg and Fe contents. Magnesian chlorites, isolated from serpentine by hand-picking under a stereomicroscope, are found to weather to trioctahedral vermiculite. Magnetite and chromite extracted from the bulk samples are replaced by newly formed Fe oxides, maghemite, goethite and hematite, which give way to specific Fe accumulation habits in the regolith zone of the weathering profile.

Adsorption isotherms and differential heats of adsorption of water vapor by muscovite were measured at 303 K. The heats of adsorption are stepwise and each step corresponds to the stoichiometric formation of adsorption complexes of H2O molecules with K+ ions, (H2O)n/K+, (n = 1–6), which are located on the basal and lateral (edge) faces. At saturation, the ditrigonal cavities of the basal faces are fully occupied by hexameric clusters. It is suggested that half of the K+ ions on the basal faces come from neighboring layers by migration under the influence of the adsorbed H2O at the initial stage of adsorption. Similar migration of K+ to the edges was also hypothesized, suggesting that only every second site can be occupied by a cluster. At the final stage of adsorption, H2O molecules are believed to form H-bonded bridges between the hexameric water/cation clusters on the basal faces, whereas on the edge faces no such effect is believed to occur. The mean molar integral adsorption entropy of water is ∼−7 J/mol K less than the molar entropy of the bulk liquid. The mobility of H2O on muscovite is slightly less than in bulk water. Migration of K+ cations under the influence of adsorbed H2O both on the basal and lateral faces of muscovite is reversible.

Chlorite is one of the most common Fe-bearing minerals and is susceptible to weathering in loess and soils. The conventional method for analyzing chlorite, based on XRD with the Rietveld technique, is quantitative, but very time consuming and expensive. In this paper we develop a new methodology based on diffuse reflectance spectroscopy (DRS) and selective chemical extractions to identify chlorite qualitatively in the Chinese loess sequence and present evidence suggesting that DRS may be used to quantify chlorite content. The spectral signature of chlorite in loess is obscured by Fe oxides, but becomes obvious when they are removed. Changes in the ferrous absorption band near 1140 nm vary consistently with changing chlorite content. Using this spectral feature, DRS can distinguish chlorite contents as small as 1 wt.% in loess sediments. Future possibilities for this method in other soil and sediment types need to be explored.

Water-vapor sorption experiments were conducted to quantify bulk volume change of compacted expansive clay specimens resulting from interlayer hydration and dehydration in the crystalline swelling regime. Effects of interlayer cation type and pore fabric are examined by comparing results for natural Na+-smectite and Ca2+-smectite specimens compacted over a range of initial bulk densities. Transitions in interlayer hydration states are reflected in the general shape of the sorption isotherms and corresponding relationships between humidity and volume change. Hysteresis is observed in both the sorption and volume-change response. Volume change for Ca2+-smectite specimens is significantly greater than for Na+-smectite over the entire range of packing densities considered. Loosely compacted specimens result in less volume change for both clays. Results are interpreted in light of a conceptual framework based on previous SEM and TEM observations of particle and pore fabric for Na+ and Ca2+ smectite at high suctions. A pore-scale microstructural model is developed to quantitatively assess changes in interlayer and interparticle void volume during hydration. Modeling suggests that the relatively small volume changes observed for Na+-smectite are attributable to a reduction of interparticle void volume as expanding quasicrystals encroach into surrounding larger-scale pores. Volume change hysteresis is attributed to unrecovered alterations in interparticle fabric required to accommodate the swelling process. The results provide new insight to address volume change upscaling, hysteresis, and the general evolution of bi-modal pore fabric during crystalline swelling.

The Weches Formation of the Claiborne Group (Eocene) in northeast Texas consists of clayey sandstones and mudrocks, both with variable proportions of dark green to brown clay peloids deposited in a marginal to open marine setting on the Gulf Coast margin. The composition of the dark green peloids, from two localities, has been investigated using X-ray diffraction, back-scattered electron microscopy with X-ray analysis, electron energy-loss spectroscopy (EELS), Mössbauer spectroscopy, chemical analysis and Fourier transform infrared spectroscopy. These peloids were previously described on the basis of their color as glauconite (Yancey and Davidoff, 1994); our results, however, show that the dark green indurated pellets are predominantly composed of mixed-layer clays with a high proportion of Fe-rich 7 Å serpentine layers coexisting with a mixed-layer phase containing glauconite, nontronite and vermiculite layers, in addition to discrete illite and kaolinte. Analyses by EELS of single particles with a chemical composition consistent with them being the Fe-rich clay indicate that the Fe is >95% ferric, while Mössbauer analyses of the bulk magnetically separated fraction for the same samples indicates a ferric iron content of ∼60–70%, despite the variable relative proportions of expandable and 7 Å layers. Taking into account that there is a significant amount of 2:1 layers containing ferric Fe, we interpret these data as indicating that the Fe in the 7 Å layers has a significant amount of Fe2+ even taking into account the high ferric Fe ratio from the EELS analysis when the coexisting 2:1 layers are considered. Thus, these 1:1 layers are closer to berthierine in composition than to odinite. The vermiculite layers in the Texas clay may indicate partial ‘verdinization’ of expandable 2:1 clay. A possible reaction is smectite → vermiculite → berthierine-like phase. We estimate a temperature of 20°C for the seawater in which the Texas clay formed, the lower end of the range for modern occurrences of odinite.

Burial-induced and hydrothermal-related illitization in bentonites and in sandstones can be modeled on the basis of isotopic studies of fundamental particles separated from mixed-layer illitesmectite. The model envisages different reaction rates and durations relative to the varied impacts of temperature, considering that the water:rock ratio also has an influence. The different pathways for illitization are suggested on the basis of the K-Ar, Rb-Sr and δ18O compositions of previously studied materials.

New information is provided on why fundamental particles separated from mixed-layer illite-smectite in shales yield K-Ar age data that are systematically greater than the ages of the fundamental particles from associated bentonites and/or sandstones, and greater than the reported stratigraphic ages. The study of pure authigenic, recent to present-day smectite from Pacific sediments shows that (1) those collected from active hydrothermal vents have 40Ar/36Ar ratios identical to that of the atmosphere, and (2) those of mud sediments have 40Ar/36Ar ratios above the atmospheric value, indicating addition of 40Ar not generated in situ by radioactive decay. A preliminary but detailed analysis of the noble-gas (Ar, Xe, Kr) contents of authigenic smectite-rich size fractions from Pacific deep-sea red clays suggests trapping of these gases by smectite. Therefore, the results point to the fact that fundamental particles can incorporate excess 40Ar into their structure when nucleating in restricted to closed systems, such as shales. This excess 40Ar, which represents radiogenic 40Ar released from nearby altered silicates, might be temporarily adsorbed at the surface of the rock pore spaces and is therefore available for incorporation in nucleating and growing particles.