from Part II - Architectures, Protocols, and Performance Analysis
Published online by Cambridge University Press: 01 December 2016
Introduction
Energy harvesting has emerged as one of the enabling technologies for Green Communication. As the name suggests, energy harvesting is a technique by which energy of ambient sources, for example, solar, wind, and thermal, is converted into electrical energy and used to power network equipment or mobile devices [1, 2]. This technology makes use of perpetual renewable energy sources, which reduces the consumption of high-cost constant energy sources. Lately, wireless power transfer has gained much attention in the field of energy harvesting since wireless signal is also an ambient source of energy in itself [3, 4]. Owing to the lower range of harvested energy, RF energy harvesting has potential for powering smaller network nodes.
Wireless energy harvesting technology has been studied in two different paradigms of wireless communication networks. The first is simultaneous wireless information and power transfer (SWIPT) in downlink [5–7]. The SWIPT technique is used to transmit wireless energy to user equipments (UEs) whilst carrying out downlink information transmission to them as shown in Figure 4.1. The technological requirements necessary to enable this simultaneous information and energy transmission at the receiver circuit will be discussed later in this chapter. The SWIPT technique increases the energy efficiency of the network since the energy cost decreases for UEs capable of harvesting energy from the received information signal [8]. In other words, energy spent at the information transmitter is partially reused at the receiver. The reuse of energy is partial mainly because of the path-loss and non-ideal energy harvesting efficiency.
On the other hand, when the UEs are carrying out uplink transmission, it is not possible to transmit energy to them using the SWIPT technique. Hence, another important paradigm of wireless energy harvesting networks is wireless-powered communication (WPC) in the uplink [9, 10]. In this technique, some fraction of the uplink transmission duration is dedicated to downlink energy transmission (DET) from the access point (AP) to the UEs. The energy harvested during this time is utilized by the UEs for uplink information transmission (UIT) to the AP in the remaining fraction of time as shown in Figure 4.2.
To save this book to your Kindle, first ensure [email protected] is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about saving to your Kindle.
Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.
Find out more about the Kindle Personal Document Service.
To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Dropbox.
To save content items to your account, please confirm that you agree to abide by our usage policies. If this is the first time you use this feature, you will be asked to authorise Cambridge Core to connect with your account. Find out more about saving content to Google Drive.