Direct solar energy conversion with photovoltaic devices

doi:10.1017/CBO9780511718786.022

18 - Direct solar energy conversion with photovoltaic devices

from Part 3 - Renewable energy sources

Published online by Cambridge University Press: 05 June 2012

David S. Ginley ,

Reuben Collins and

David Cahen

Edited by

David S. Ginley and

David Cahen

Show author details

David S. Ginley: Affiliation:
Process Technology and Advanced Concepts, National Renewable Energy Laboratory, Golden, CO, USA
Reuben Collins: Affiliation:
Physics Department and Renewable Energy Materials Research Science and Engineering Center, Colorado School of Mines, Garden, CO, USA
David Cahen: Affiliation:
Department of Materials and Interfaces, Weizmann Institute of Science, Rehovot Israel
David S. Ginley: Affiliation:
National Renewable Energy Laboratory, Colorado
David Cahen: Affiliation:
Weizmann Institute of Science, Israel

Book contents

Get access

Summary

Focus

During the last decade the direct conversion of solar energy to electricity by photovoltaic cells has emerged from a pilot technology to one that produced 11 GWp of electricity generating capacity in 2009. With production growing at 50%–70% a year (at least until 2009) photovoltaics (PV) is becoming an important contributor to the next generation of renewable green power production. The question is that of how we can move to the terawatt ( TW ) scale [1].

Synopsis

The rapid evolution of PV as an alternative means of energy generation is bringing it closer to the point where it can make a significant contribution to challenges posed by the rapid growth of worldwide energy demand and the associated environmental issues. Together with the main existing technology, which is based on silicon (Si), the growth of the field is intertwined with the development of new materials and fabrication approaches. The PV industry, which was, until recently, based primarily on crystalline, polycrystalline, and amorphous Si, grew at an average annual rate of 50% during 2000–2010. This rate was increasing, at least until the 2008 economic crisis, with production of ~11 gigawatts (GWp) per year in 2009 [2]. While this may seem a very large number, PV installations in total are still supplying only <0.03% of all the world's power needs (~14–15 TW) [2]. As production increases, increasing individual cell efficiency and translating that to modules, as well as reducing manufacturing expenses and increasing system lifetimes, are all critical to achieving grid parity, the point at which the cost of PV power is equal to the price of grid electricity.

Type: Chapter
Information: Fundamentals of Materials for Energy and Environmental Sustainability , pp. 216 - 237

DOI: https://doi.org/10.1017/CBO9780511718786.022 [Opens in a new window]

Publisher: Cambridge University Press

Print publication year: 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Book purchase

Temporarily unavailable

References

Hermann, W. A. 2006 “Quantifying global exergy resources,”Energy 31 1685CrossRef Google Scholar

Shyam Mehta“26th Annual Data Collection Results: Another bumper year for manufacturing Masks turmoil.”PVNews 29 2010 11Google Scholar

von Roedern, B.Zweibel, K.Ullal, H. S. 2005 “The role of polycrystalline thin-film PV technologies for achieving mid-term market-competitive PV modules,”Proceedings of the 31st IEEE Photovoltaics Specialists Conference and ExhibitionLake Buena VistaFLGoogle Scholar

Ginley, D.Green, M.Collins, R. 2008 “Solar energy conversion toward 1 terawatt,”MRS Bull. 33 355CrossRef Google Scholar

Green, M. A.Emery, K.Hishikawa, Y.Warta, W. 2011 “Solar cell efficiency tables (version 37),”Prog. Photovoltaics: Res. Appl. 19 84CrossRef Google Scholar

Kazmerski, L.http://en.wikipedia.org/wiki/File:PVeff(rev100921).jpg

Becquerel, E. 1839 “Mémoires sur les effets électriques produits sous l'influence des rayons,”Comptes Rendues 9 561Google Scholar

Smith, W. 1873

Adams, W. G.Day, R. E. 1877 “The action of light on selenium,”Proc. Roy. Soc. A 25 113CrossRef Google Scholar

Einstein, A. 1905 “Über einen die Erzeugung und Verwandlung des Lichtes betreffenden heuristischen Gesichtspunkt” [“On a heuristic viewpoint concerning the production and transformation of light”]Ann. Phys. 17 132CrossRef Google Scholar

Kennard, E. H.Dietrich, E. O. 1917 “An effect of light upon the contact potential of selenium and cuprous oxide,”Phys. Rev. 9 58CrossRef Google Scholar

Grondahl, L. O. 1933 “The copper–cuprous oxide rectifier and photoelectric cell,”Rev. Mod. Phys. 5 141CrossRef Google Scholar

Ohl, R. S. 1946

Ohl, R. S. 1948

Rappaport, P. 1954 “The electron voltaic effect in p–n junctions induced by beta-particle bombardment,”Phys. Rev. 93 246CrossRef Google Scholar

Chapin, D. M.Fuller, C. S.Pearson, G. L. 1954 “A new silicon photocell for converting solar radiation into electrical power,”J. Appl. Phys. 25 676CrossRef Google Scholar

Reynolds, D. C.Leies, G.Antes, L. L.Marburger, R. E. 1954 “Photovoltaic effect in cadmium sulfide,”Phys. Rev. 96 533CrossRef Google Scholar

Jenny, D. A.Loferski, J. J.Rappaport, P. 1956 “Photovoltaic effect in GaAs p–n junctions and solar energy conversion,”Phys. Rev. 101 1208CrossRef Google Scholar

Loferski, J. 1993 “The first forty years: a brief history of the modern photovoltaic age,”Prog. Photovoltaics: Res. Appl. 1 67CrossRef Google Scholar

O'Regan, B.Grätzel, M. 1991 “A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films,”Nature 353 737CrossRef Google Scholar

Tang, C. W. 1986 “Two-layer organic photovoltaic cell,”Appl. Phys. Lett. 48 183CrossRef Google Scholar

Würfel, P. 2009 Physics of Solar Cells: From Basic Principles to Advanced ConceptsWeinheimWiley-VCHGoogle Scholar

Green, M. A. 2002 “Photovoltaic principles,”Physica E 14 11CrossRef Google Scholar

Nelson, J. 2003 The Physics of Solar CellsLondonImperial College PressCrossRef Google Scholar

Green, M. A. 2007 “Thin film solar cells: review of materials, technologies and commercial status,”J. Mater. Sci. Mater. Electron. 18 515CrossRef Google Scholar

Günes, S.Neugebauer, H.Sariciftci, N. S. 2007 “Conjugated polymer-based organic solar cells,”Chem. Rev. 107 1324CrossRef Google Scholar

Grätzel, M. 2003 “Dye-sensitized solar cells,”J. Photochem. Photobiol. C: Photochem. Rev. 4 145CrossRef Google Scholar

Yamaguchi, M.Takamoto, T.Araki, K.Ekins-Daukes, N. 2005 “Multi-junction III–V solar cells,”Solar Energy 79 78CrossRef Google Scholar

DOE 2009 http://www.eia.doe.gov/oiaf/ieo/electricity.html

Green, M. A. 2001 “Third generation photovoltaics: ultra-high conversion efficiency at low cost,”Prog. Photovoltaics: Res. Appl. 9 123CrossRef Google Scholar

Green, M. A. 2001 “Photovoltaics for the 21st century II,”Electrochem. Soc. Proc. 2001 30Google Scholar

Surek, T. 2005 “Crystal growth and materials research in photovoltaics: progress and challenges,”J. Cryst. Growth 275 292CrossRef Google Scholar

Margolis, R. M. 2003

Trina Solarhttp://media.corporate-ir.net/media_files/IROL/20/206405/Supplemental_Presentation_Q3_2010_nov_30_1730hr_v5_cy_ir_ty.pdf

SunPower Corp 2010 http://files.shareholder.com/downloads/SPWR/1159074174x0x420687/fefb453b-9d20-42f8-a27f-a22d31b6c0df/2010%20Analyst%20Day%20Final%20v4.pdf

First Solarhttp://phx.corporate-ir.net/phoenix.zhtml?c=201491&p=irol-newsArticle&ID=1454084&highlight=

Shockley, W.Queisser, H. J. 1961 “Detailed balance limit of efficiency of p–n junction solar cells,”J. Appl. Phys. 32 510CrossRef Google Scholar

Taira, S.Yoshimine, Y.Baba, T. 2007 932

SunPower Corp 2010 http://investors.sunpowercorp.com/releasedetail.cfm?ReleaseID=482133

Slaoui, A.Collins, R. T. 2007 “Advanced inorganic materials for photovoltaics,”MRS Bull. 32 211CrossRef Google Scholar

Yan, B.Yue, G.Owens, J. M.Yang, J.Guha, S. 2006 1477

Staebler, D. L.Wronski, C. R. 1980 “Optically induced conductivity changes in discharge-produced hydrogenated amorphous silicon,”J. Appl. Phys. 51CrossRef Google Scholar

Contreras, M. A.Romero, M. J.Noufi, R. 2006 “Characterization of Cu(In,Ga)Se2 materials used in record performance solar cells,”Thin Solid Films 511–512 51CrossRef Google Scholar

Wu, X. 2004 “High-efficiency polycrystalline CdTe thin-film solar cells,”Solar Energy 77 803CrossRef Google Scholar

Contreras, M. A.Egaas, B.Ramanathan, K. 1999 Prog. Photovoltaics: Res. Appl. 7 3113.0.CO;2-G>CrossRef

AbuShama, J.Noufi, R.Yan, Y. 2001 “Cu(In,Ga)Se2 thin-film evolution during growth from (In,Ga)2Se3 precursors,”Mater. Res. Soc. Symp. Proc. 664Google Scholar

Kronik, L.Cahen, D.Schock, H. W. 1998 “Effect of Na on CuInSe2 and its solar cell performance,”Adv. Mater. 10 313.0.CO;2-3>CrossRef Google Scholar

Romeo, A.Terheggen, M.Abou-Ras, D. 2004 “Development of thin-film Cu(In,Ga)Se2 and CdTe solar cells,”Prog. Photovoltaics: Res. Appl. 12 93CrossRef Google Scholar

Shaheen, S. E.Ginley, D. S.Jabbour, G. E. 2005 “Organic-based photovoltaics: toward low-cost power generation,”MRS Bull. 30 10CrossRef Google Scholar

Solarmer Energy, Inc 2010 http://www.solarmer.com/newsevents.php

Collins, G. 2004 “Next stretch for plastics electronics,”Sci. Am. 291 74CrossRef Google Scholar

de Leeuw, D. M. 1999 “Plastic electronics,”Phys. World 12 31CrossRef Google Scholar

Brabec, C. J.Gowrisanker, S.Halls, J. J. M. 2010 “Polymer–fullerence bulk-heterojunction solar cells,”Adv. Mater. 22 3839CrossRef Google Scholar

Bony, L.Doig, S.Hart, C.Maurer, E.Newman, S. 2010 Achieving Low-Cost Solar PV: Industry Workshop Recommendations for Near-Term Balance of System Cost ReductionsRocky Mountain Institute5Google Scholar