Hostname: page-component-cd9895bd7-dzt6s Total loading time: 0 Render date: 2024-12-26T09:07:33.415Z Has data issue: false hasContentIssue false
  • English
  • Français

Laboratory Note. Obtaining Powders with the Aid of a Slow Speed Diamond Saw

Published online by Cambridge University Press:  10 January 2013

F.X. Kayser
F.X. Kayser
Affiliation:
Materials Science and Engineering Department, Iowa State University, Ames, Iowa 50011, U.S.A.
Get access Rights & Permissions [Opens in a new window]

Extract

Powder samples for diffraction studies of selected materials have been prepared in this laboratory during the past 15 years using a commercial, slow-speed, diamond saw. The materials powdered include a wide range of ferrous and transition metal alloys as well as geological substances. Before sectioning begins, fresh oil is poured into the oil tray of the saw and the diamond, rim-impregnated, copper blade thoroughly cleaned. A typical blade is 10 cm in diameter and 3 mm thick. Powder produced as the blade cuts through the sample collects in and settles to the bottom of the oil tray. The oil, which bathes the sample surface during cutting and surrounds the powder debris after discharge into the tray, serves to prevent oxidation of most materials.

Type
Research Article
Information
Powder Diffraction , Volume 3 , Issue 4 , December 1988 , pp. 255
Copyright
Copyright © Cambridge University Press 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)