Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-24T09:48:53.122Z Has data issue: false hasContentIssue false
  • English
  • Français

Tribological Properties of Motor Oil with Nanodiamond Additive tested for steel friction surfaces with different hardnesses

Published online by Cambridge University Press:  26 November 2013

M. Ivanov ,
S. Smirnov ,
S. Pavlyshko ,
D. Ivanov ,
D. Brenner  and
O. Shenderova
M. Ivanov*
Affiliation:
Ural Federal University, Yekaterinburg, Russian Federation
S. Smirnov
Affiliation:
Institute of Engineering Science Ural Branch RAS, Yekaterinburg, Russian Federation
S. Pavlyshko
Affiliation:
Institute of Engineering Science Ural Branch RAS, Yekaterinburg, Russian Federation
D. Ivanov*
Affiliation:
Ural Federal University, Yekaterinburg, Russian Federation
D. Brenner
Affiliation:
North Carolina State University, Raleigh, USA
O. Shenderova
Affiliation:
International Technology Center, Raleigh, USA
*
*Email: [email protected]
Get access

Abstract

Synergistic compositions of detonation nanodiamond (ND) particles in the form of 100nm aggregates in combination with molybdenum dialkyldithiophosphate were used as additives to 10W40 oils. Ring-on-disk tribological tests were performed under high load conditions using friction pairs with different hardnesses, namely normalized-normalized (“soft/soft”) and normalized-quenched (“soft/hard”) steel samples. For the “soft/hard” steel friction pair NDs provide significant reduction in both the coefficient of friction and wear as well as demonstrate polishing. For the “soft/soft” steel friction pair, however, no difference in the coefficients of friction was observed when the base oil was used with or without ND. In the test with oil containing the ND additive, the wear scar in the disk was wider, but more shallow, than in the test with pure oil. Current tests indicate that the significance of the reduction of friction and wear of the sliding surfaces in the presence of the ND additive in oil strongly depends on the hardness of the friction surfaces and most probably is connected with ND polishing effect.

Keywords

diamondnanoscalelubricant
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1597: Symposium N – Nanodiamond-From Basics to Medical and Other Potential Applications , 2014 , jsapmrs-13-1597
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Neville, A. Morina, T. Haque, M. Voong,Tribology International 40 (2007) 1680–1695; “Nanolubricants,” Eds. Martin, J.-M. and Ohmae, N., Wiley, 2008 Google Scholar
Ivanov, M., Ivanov, D., Ch.8 in Ultrananocrystalline Diamond, 2nd Edition, Eds. Shenderova, O., Gruen, D., Elsevier, 2012 Google Scholar
Yu, Dolmatov V.. J.Superhard Materials, 32, 14–20 (2010)Google Scholar
Zhornik, V.I., Kukareko, V.A., Belotserkovsky, M.A. Nova Science Publishers, 2011 Google Scholar
Schrand, A. M. et al. . in Safety of Nanoparticles. Nanostructure Science and Technology (ed. Webster, T. J.) 159–187, Springer, 2009 CrossRefGoogle Scholar
Ivanov, M.G., Kharlamov, V.V., Buznik, V.M., Ivanov, D.M., Pavlushko, S.G., Tsvetnikov, A.K., Friction and Wear, 25(1), 99 (2004)Google Scholar
Ivanov, M. G., Pavlyshko, S. V., Ivanov, D. M., Shenderova, O., Mater. Res. Soc. Symp. Proc. Vol. 1203, 1203-J17-16 (2010)Google Scholar
Ivanov, M. G., Pavlyshko, S. V., Ivanov, D. M., Petrov, I., Shenderova, O., JVST B, 28, 4, 869–876 (2010)Google Scholar
Ivanov, M., Ivanov, D., Pavlyshko, S.V., Koscheev, A. and Shenderova, O., MRS Proceedings, 1452, mrss12-1452-ff08-05 doi:10.1557/opl.2012.1228 (2012).CrossRefGoogle Scholar
Ivanov, M., Ivanov, D., Pavlushko, S.V., Petrov, I., Vargas, A., McGuire, G., Shenderova, O.. Fuller. Nanotub. Carbon Nanost., 20, 4–7, 606-610 (2012)CrossRefGoogle Scholar