Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-24T19:20:45.458Z Has data issue: false hasContentIssue false
  • English
  • Français

Sensitive, Selective, & Tunable Porous Silicon Gas Sensor

Published online by Cambridge University Press:  01 February 2011

Stephen Lewis ,
James Gole  and
Peter J. Hesketh
Stephen Lewis
Affiliation:
School of Physics, Georgia Institute of Technology, Atlanta, GA 30332
James Gole
Affiliation:
School of Physics, Georgia Institute of Technology, Atlanta, GA 30332
Peter J. Hesketh
Affiliation:
School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, GA 30332
Get access

Abstract

Hybrid porous silicon, consisting of a microporous framework whose walls are covered with a thin nanoporous layer, proves to be an inexpensive and robust platform for fabrication of rapid, reversible, and sensitive semiconductor sensors. An extremely high surface area provides a mechanism for the detection of ppm and ppb levels of a range of gases including ammonia, NOx, and CO. A general method of coating electroless metal onto the surface provides a basis for nanostructure induced selectivity between these gases. Further, the introduction of FFT analysis to the rapidly reversible and linear response of the porous silicon gas sensor allows the gas response to be acquired and filtered on a drifting baseline.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 828: Symposium A – Semiconductor Materials for Sensing , 2004 , A1.7
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Seals, L., Tse, L.A., Hesketh, P.J. and Gole, J.L., “Rapid, Reversible, Sensitive Porous Silicon Gas Sensor,” J. Applied Physics, 91, pp. 2519–2523 (2002).Google Scholar
2. Gole, J.L., Devincentis, J.A., Seals, L., “Chloride Sale Enhancement and Stabilization of the Photoluminescence from a Porous Silicon Surface” Physical Review B, 61, pp. 5165–5631 (2000).Google Scholar
3. Foucaran, A., Pascalk-Delannoy, F., Giani, A., Sackda, A., Comette, P., and Boyer, A., “Porous Silicon Layers Used for Gas Sensor Applications”, Thin Solid Films, 297, pp. 317–320 (1997).Google Scholar
4. Moseley, P.T., “Solid State Gas Sensors” Review Article, Meas. Sci. Technol. 8, pp. 223–237 (1997).Google Scholar
5. Schechter, I., Ben-Chorin, M., and Kuz, A., “Gas-sensing Properties of Porous Silicon”, Analytical Chemistry 67, 3727 (1995).Google Scholar
6. Lewis, S. E., DeBoer, J. R., Gole, J. L., and Hesketh, P. J., “Sensitive, Selective, and Analytical Improvements to a Porous Silicon Gas Sensor,” Sensors and Actuators, in press.Google Scholar
7. Dudel, F., Grantier, D.R., Gole, J.L., and Dixon, D.A. “On the origin of porous silicon photoluminescence-evidence for an oxyhydride-like emitter,” Physical Review; Part B, 56, 2137 (1997).Google Scholar
8. Gole, J.L. and Dixon, D.A. “A suggested correlation between the visible photoluminescence and the Fourier transform infrared spectrum of a porous silicon surface,” Journal of Physical Chemistry, 101, 8096 (1997)Google Scholar
9. Gole, J.L. and Dixon, D.A. “On the transformation, green to orange-red of a porous silicon photoluminescent surface,” Journal of Physical Chemistry: Part B, 102, 33 (1998)Google Scholar
10. Gole, J. L., Seals, L.T., and Lillehei, Peter T., “Patterned Metallization of Porous Silicon from Electroless Solution for Direct Electrical Contact” Journal of the Electro Chemical Society, 147, pp. 3785–3789 (2000).Google Scholar
11. DeBoer, J., Lewis, S., Hesketh, P. J., Gole, J. L., “Method for signal extraction from chemical sensor response,” Journal of Applied Physics, submitted.Google Scholar