Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-28T13:59:04.539Z Has data issue: false hasContentIssue false
  • English
  • Français

Room-Temperature UHV-Deposited Titanium Monoxide Films on Oxidized Polycrystalline Copper

Published online by Cambridge University Press:  21 March 2011

V. M. Fuenzalida ,
C. R. Grahmann ,
C. Herrera ,
R. A. Zárate ,
C. Avila  and
M.E. Pilleux
V. M. Fuenzalida
Affiliation:
Departamento de Física, Av. Blanco Encalada 2008, Santiago 6511226, Chile
C. R. Grahmann
Affiliation:
Departamento de Física, Av. Blanco Encalada 2008, Santiago 6511226, Chile
C. Herrera
Affiliation:
Departamento de Física, Av. Blanco Encalada 2008, Santiago 6511226, Chile
R. A. Zárate
Affiliation:
Departamento de Física, Av. Blanco Encalada 2008, Santiago 6511226, Chile
C. Avila
Affiliation:
IDIEM, Plaza Ercilla 883, Santiago 6511226, Chile
M.E. Pilleux
Affiliation:
Universidad de ChileFacultad de Ciencias Físicas y Matemáticas
Get access

Abstract

Polycrystalline copper films thicker than 100 nm were evaporated on silicon wafers with their native oxide under ultrahigh vacuum conditions leading to an rms roughness of ~2 nm of the copper film. X-ray photoelectron spectroscopy (XPS) revealed a clean copper surface with only traces of oxygen. The samples were exposed to air, leading to an oxide film consisting of CuO. TiO films were subsequently deposited onto the oxidized copper films from a resistively heated tungsten boat with the substrate at room temperature. The TiO films exhibited good adherence and were amorphous. XPS measurements revealed that the TiO films were contamination-free and that the first layers of TiO reduced the thin native oxide of the copper substrate from Cu(II) into Cu(I) or Cu(0) and transformed the TiO into TiO2 at the interface.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 672: Symposium O – Mechanisms of Surface and Microstructure Evolution in Deposited Films and Film Structures , 2001 , O8.25
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Pan, J-M., Maschhoff, B., Diebold, Ulrike and Madey, T., Surf. Sci. 291 (1993) 381.Google Scholar
2. Diebold, U., Pan, J. M., and Madey, T. E., Surf. Sci. 331–333 (1995) 845.Google Scholar
3.Mater. Res. Soc. Bull., special issue on "Copper Metallization", June (1993).Google Scholar
4. Wu, Y. M. and Nix, R. M., J. Mater. Chem. 4 [9] (1994) 1403.Google Scholar
5. Li, J., Mayer, J. W., Shacham-Diamand, Y., and Colgan, E.G., Appl. Phys. Lett. 60 (1992) 2983.Google Scholar
6 Li, J. and Mayer, J. W., Mater. Res. Soc. Bull., June (1993) 52.Google Scholar
7. Li, J., Mayer, J. W., and Colgan, E.G., J. Appl. Phys. 70 (1991) 2820.Google Scholar
8. Fuenzalida, V. M., Zárate, R. A., Ignat, M., Avila, C., and Pilleux, M. E., International Conference on Metallurgical Coatings and Thin Films (ICMCTF), San Diego, California, FP-30 (2000).Google Scholar
9. Fuenzalida, V. M., Grahmann, C. R., and Herrera, C., Rev. Sci. Instrum. 69 (1998) 3077.Google Scholar
10. Chastain, J., Ed., “Handbook of X-Ray Photoelectron Spectroscopy”, Physical Electronics, Eden Prairie, Minnesota (1992).Google Scholar