Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-12-03T00:28:55.105Z Has data issue: false hasContentIssue false
  • English
  • Français

Properties of Reactively Sputter Deposited SrTiO3 Films for IR Detector Readout Electronics

Published online by Cambridge University Press:  15 February 2011

S.D. Bernstein ,
T.Y. Wong ,
J.K. Rawson  and
R.W. Tustison
S.D. Bernstein
Affiliation:
Raytheon Company, Research Division, Lexington, MA.
T.Y. Wong
Affiliation:
Raytheon Company, Research Division, Lexington, MA.
J.K. Rawson
Affiliation:
Raytheon Company, Research Division, Lexington, MA.
R.W. Tustison
Affiliation:
Raytheon Company, Research Division, Lexington, MA.
Get access

Abstract

The effects of film thickness, oxygen partial pressure, electrode type, substrate temperature, and position on the room temperature and 77 K dielectric properties of SrTiO3 (ST) films were studied. The film composition and properties vary with radial position and oxygen partial pressure. A maximum in dielectric constant occurs near the same position where stoichiometric films are obtained. The room temperature and 77K dielectric constants increase with increasing thickness, while the capacitance density decreases. Capacitance densities as high as 4 fF/μm2 were observed for films deposited at low temperature and subsequently crystallized. Elevated temperature deposition, however, results in better properties than room temperature deposition followed by annealing. Dielectric constants as high as 200 with capacitance densities up to 9 fF/μ2 were observed. For optimized deposition conditions, no dielectric break-down of the capacitors was observed at 20V after 111 days of testing. The properties of capacitors with n+Si bottom electrodes were not as good as those with Ti/Pt electrodes, however, integration with Si integrated circuit processing is expected to be much simpler.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 361: Symposium I2 – Ferroelectric Thin Films IV , 1994 , 595
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Weaver, H.E., J. Phys. Chem. Solids 11, 274 (1959).Google Scholar
2. Pennebacker, W.B., IBM J. Res. Develop. Nov., 686 (1969).Google Scholar
3. Matsubara, S., Sakuma, T., Yamamichi, S., Yamaguchi, H., and Miyasaka, Y. in Ferroelectric Thin Films, edited by Myers, E.R. and Kingon, A.I. (Mater. Res. Soc. Proc. 200, Pittsburgh, PA, 1990) pp. 243–253.Google Scholar
4. Yamamichi, S., Sakuma, T., Takemura, K., and Miyasaka, Y., Jpn. J. Appl. Phys. 30, 2193 (1991).Google Scholar
5. Yamaguchi, H., Matsubara, S., Miyaska, Y., Jpn. J. Appl. Phys. 30, 2197 (1991).Google Scholar
6. Joshi, P.C., Krupanidhi, S.B., Appl. Phys. Lett. 61, 1525 (1992).Google Scholar
7. Ishizawa, N., Banno, H., Hayashi, M., Yoo, S.E., Yoshimura, M., Jpn. J. Appl. Phys. 29, 2467 (1990).Google Scholar
8. US Inc., Campbell, CA.Google Scholar
9. Rossnagel, S.M., and Cuomo, J.J., AIP Conf. Proc. 165, 106 (1988).Google Scholar
10. Levin, E.M., Robbins, C.R., and McMurdie, H.F., “Phase Diagrams for Ceramists,” American Ceramic Society, Columbus 1964, Fig. 297, 297. 1969 Supplement, Fig. 2334.Google Scholar
11. Chan, N.H., Sharma, R.K., and Smyth, D.M., J. Electrochem. Soc. 128, 1762 (1981).Google Scholar
12. The Oxide Handbook, edited by Samsonov, G.V. (Plenum, New York, 1973).Google Scholar
13. Sakuma, T., Yamamichi, S., Matubara, S., Yamaguchi, H., and Miyaska, Y., Appl. Phys. Lett. 57, 2431 (1990).Google Scholar
14. Standardized Ferroelectric Tester, Radiant Technologies, Albuquerque, NM.Google Scholar