Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-28T13:41:31.957Z Has data issue: false hasContentIssue false

Phosphorus and Boron Doping Effect on Nanocrystalline Formation in Hydrogenated Amorphous and Nanocrystalline Mixed-phase Silicon Thin Films

Published online by Cambridge University Press:  31 January 2011

Chunsheng Jiang
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Yanfa Yan
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Helio R. Moutinho
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Mowafak Al-Jassim
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Baojie Yan
Affiliation:
[email protected], United Solar Ovonic LLC, Troy, Michigan, United States
Laura Sivec
Affiliation:
[email protected], United Solar Ovonic LLC, Troy, Michigan, United States
Jeff Yang
Affiliation:
[email protected], United Solar Ovonic LLC, Troy, Michigan, United States
Subhendu Guha
Affiliation:
[email protected], United States
Get access

Abstract

Phosphorus and Boron doping effects on the microstructure of nanocrystallites in hydrogenated amorphous and nanocrystalline mixed-phase silicon films were investigated using Raman spectroscopy, secondary ion mass spectrometry, cross-sectional transmission electron microscopy, atomic force microscopy, and conductive atomic force microscopy. The characterizations revealed the following observations. First, the mixed-phase Si:H films can be heavily doped in ˜1021/cm3 by adding PH3 and BF3 in the precursor gases. Second, the intrinsic and doped films can be made in a similar crystalline volume fraction by adjusting hydrogen dilution ratio. The hydrogen dilution ratio is much higher for P-doped films than for the intrinsic film with the similar crystallinity. Third, the doping impacts the nanostructures in the films significantly. Nanograins aggregate to form cone-shaped clusters in the intrinsic and B-doped films but isolate and randomly distribute in amorphous tissues in the P-doped films. The cones in the intrinsic and B-doped films are also different. The cone-angle is smaller and the nanograin density is lower in the B-doped films than in the intrinsic films. These P- and B-doping effects on the nanocrystalline formation are interpreted in terms of diffusions of Si-related radicals during the film growth.

Type
Research Article
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Nakayama, S. Kawashima, I. and Murota, J. J. Electrochem. Soc: Solid State Science & Technol. 133, 1721(1986).Google Scholar
[2] Saleh, R. and Nickel, N.H. Thin Solid Films 427, 266(2003).Google Scholar
[3] Kumar, P. and Schroeder, B. Thin Solid Films 516, 580(2008).Google Scholar
[4] Matsui, T. Kondo, M. and Matsuda, A. J. Non-Cryst. Solids 338340, 646(2004).Google Scholar
[5] Yan, B. Jiang, C.S. Teplin, C.W. Moutinho, H.R. Al-Jassim, M.M., Yang, J. and Guha, S. J. Appl. Phys. 101, 033712(2007).Google Scholar
[6] Jiang, C.S. Yan, B. Moutinho, H.R. Al-Jassim, M.M., Yang, J. and Guha, S. Mater. Res. Soc. Symp. Proc. 989, 15(2007).Google Scholar
[7] For a review, see Shah, A. V. Meier, J. Vallat-Sauvain, E., Wyrsch, N. Kroll, U. Droz, C. and Graf, U. Sol. Energy Mater. Sol. Cells 78, 469(2003).Google Scholar
[8] Collins, R.W. Ferlauto, A.S. Ferreira, G.M. Chen, C. Koh, J. Koval, R.J. Lee, Y. Pearce, J.M. and Wronski, C.R. Sol. Energy Mater. Sol. Cells 78, 143(2003).Google Scholar
[9] Teplin, C.W. Iwaniczko, E. To, B. Moutinho, H. Stradins, P. and Branz, H.M. Phys. Rev. B 74, 235428(2006).Google Scholar
[10] Matsuda, A. Thin Solid Films 337, 1(1999).Google Scholar
[11] Teplin, C.W. Jiang, C.S. Stradins, P. and Branz, H.M. Appl. Phys. Lett. 92, 093114(2008).Google Scholar
[12] For a review, see Kamins, T.I. Polycrystalline Silicon for Integrated Circuit Applications (Kluwer Academic, Boston, 1997), p.32.Google Scholar
[13] Toyama, T. Yoshida, W. Sobajima, Y. and Okamoto, H. J. Non-Cryst. Solids 354, 2204(2008).Google Scholar