Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-28T17:39:52.588Z Has data issue: false hasContentIssue false

Optical Readout in Pinpi'n and Pini'p Imagers: A Comparison

Published online by Cambridge University Press:  01 February 2011

P. Louro
Affiliation:
[email protected], ISEL, DEETC, Rua Conselheiro Emidio Navarro, Lisbon, 1949-014, Portugal
M. Vieira
Affiliation:
[email protected], ISEL, DEETC, Rua Conselheiro Emidio Navarro, Lisbon, 1949-014, Portugal, +351218317290, +351218317114
Y. Vygranenko
Affiliation:
[email protected], ISEL, DEETC, Rua Conselheiro Emidio Navarro, Lisbon, 1949-014, Portugal
M. Fernandes
Affiliation:
[email protected], ISEL, DEETC, Rua Conselheiro Emidio Navarro, Lisbon, 1949-014, Portugal
A. Garção
Affiliation:
asg @ uninova.pt, FCT-UNL, CRI, Quinta da Torre, Caparica, 2829-516 Caparica, Portugal
Get access

Abstract

Optimized a-SiC:H multilayer devices based on two different tandem configurations (TCO/pinpi'n/TCO and TCO/pini'p/TCO) are compared and tested for proper image recognition and color separation process using an optical readout technique. In both configurations the doped layers are based on a-SiC:H to increase image resolution and to prevent image blurring. To profit from the light filtering properties of the active absorbers, the intrinsic layer of the front diode (i layer) is based on a-SiC:H and the back one (i'layer) on a-Si:H.

The effect of the applied voltage on the color selectivity is discussed. Results show that the relative spectral response curves demonstrate rather good separation between the red, green and blue basic colors. Combining the information obtained under positive and negative applied bias a colour image is acquired, using the same optical technique either in pinpi'n or in the pini'p configuration, without colour filters or pixel architecture.

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Cesare, G. de, Irrera, F., Lemmi, F., Palma, F., IEEE Trans. on Electron Devices, Vol. 42, No. 5, May 1995, pp. 835840.Google Scholar
[2] Zhu, A., Coors, S., Schneider, B., Rieve, P., Bohm, M., IEEE Trans. on Electron Devices, Vol. 45, No. 7, July 1998, pp. 13931398.Google Scholar
[3] Topic, M., Stiebig, H., Knipp, D., Smole, F., Furlan, J., Wagner, H., J. Non Cryst. Solids 266-269 (2000) 11781182.Google Scholar
[4] Mulato, M., Lemmi, F., Ho, J., Lau, R., Lu, J. P., Street, R. A., J. of Appl. Phys., Vol. 90, No. 3 (2001), pp. 15891599.Google Scholar
[5] Tsai, H.K., Lee, S.C., IEEE electron device letters, EDL-8, (1987) pp. 365367.Google Scholar
[6] Stiebig, H., Gield, J., Knipp, D., Rieve, P., Bohm, M., Mat. Res. Soc. Symp. Proc 337 (1995) 815821.Google Scholar
[7] Vieira, M., Fernandes, M., Louro, P., Schwarz, R., Schubert, M., J. Non Cryst. Solids 299-302 (2002) pp. 12451249.Google Scholar
[8] Vieira, M., Fernandes, M., Louro, P., Fantoni, A., Vygranenko, Y., Lavareda, G., Carvalho, C. Nunes de, Mat. Res. Soc. Symp. Proc., 862 (2005) A13.4.Google Scholar
[9] Louro, P., Vieira, M., Fantoni, A., Fernandes, M., Carvalho, C. Nunes, Lavareda, G., Sensors and Actuators A 123-124 (2005) 326330.Google Scholar
[10] Louro, P., Fernandes, M., Fantoni, A., Lavareda, G., Carvalho, C. N., Schwarz, R., Vieira, M., Thin Solid Films 511-512 (2006) 167171.Google Scholar
[11] Carvalho, C. Nunes de, Lavareda, G., Fortunato, E., Amaral, A., Thin Solid Films 427 (1-2) (2003), p. 215.Google Scholar
[12] Carvalho, C. Nunes de, Lavareda, G., Amaral, A., Conde, O. and Ramos, A. R., J. Non-Cryst. Solids 352, Issues 23-25, (2006), p. 2315 Google Scholar
[13] Schiff, E. A., Street, R. A., Weisfield, R. L., J. Non-Cryst. Solids 198-200 (1996) 1155.Google Scholar