Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-17T03:21:30.829Z Has data issue: false hasContentIssue false
  • English
  • Français

High-Temperature Nanoindentation Measurement for Hardness and Modulus Evaluation of Low-k Films

Published online by Cambridge University Press:  01 February 2011

Jiping Ye ,
Nobuo Kojima ,
Satoshi Shimizu  and
James M. Burkstrand
Jiping Ye
Affiliation:
Research Department, NISSAN ARC, LTD., 1 Natsushima-cho, Yokosuka 237-0061, Japan
Nobuo Kojima
Affiliation:
Research Department, NISSAN ARC, LTD., 1 Natsushima-cho, Yokosuka 237-0061, Japan
Satoshi Shimizu
Affiliation:
Research Department, NISSAN ARC, LTD., 1 Natsushima-cho, Yokosuka 237-0061, Japan
James M. Burkstrand
Affiliation:
Hysitron, Inc., 10025 Valley View Rd., Minneapolis, MN 55344, U.S.A.
Get access

Abstract

A high-temperature nanoindentation measurement method has been developed for evaluating the hardness and modulus of low-k films when the temperature is raised from R.T. to 200°C. Thermal stability and chemical changes due to heating were investigated by Raman spectroscopy, Fourier transform infrared spectroscopy and thermogravimetry-differential thermal analysis, and by thermal desorption spectroscopy, respectively. Two different classes of low-k materials, organic polyarylence ether film and methyl-hydrogen-silsesquioxane film, were examined. The hardness and modulus of the former film during heating increased due to water desorption in the lower temperature range, and then decreased due to the evolution of hydrocarbon gas from some unreacted components or solvent residuals in the higher temperature range. In regard to the latter film, the hardness and modulus of a specimen (A) having a higher hydrocarbon content decreased during heating and reached the lowest value at 200°C and then constantly remained at the lowest levels during cooling. In contrast, no significant changes in hardness and modulus were observed for a specimen (B) having a lower hydrocarbon content in either the heating or cooling process. The reduction of the hardness and modulus of specimen A was attributed to thermal decomposition of most of its Si-CH3 and SiH/SiH2 chains. These results revealed that the temperature dependence of the hardness and modulus of low-k films is significantly affected by physical and/or chemical changes during heating due to moisture absorption, thermal evolution of organic residuals and thermal decomposition, rather than other factors such as thermal stress.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 863: Symposium B – Materials, Technology and Reliability of Advanced Interconnects , 2005 , B1.5
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Bohr, M., Int. Electron Device Meet. Technical Dig., (IEEE, New York, 1995) pp. 241.Google Scholar
2. The National Technology Roadmap for Semiconductors, Technology Needs, 1997 Edition, edited by Semiconductor Industry Association.Google Scholar
3. Ye, J., Kano, M., and Yasuda, Y., Tribol. Lett. 13, 41–47 (2002).Google Scholar