Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-28T17:55:11.309Z Has data issue: false hasContentIssue false

Fabrication and Optimization of a-Si:H n-i-p Single-junction Solar Cells with 8 Å/s Intrinsic Layers of Protocrystalline Si:H Materials

Published online by Cambridge University Press:  01 February 2011

Xinmin Cao
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, 2801 West Bancroft St., Toledo, OH, 43606, United States
Wenhui Du
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, Toledo, OH, 43606, United States
Y. Ishikawa
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, Toledo, OH, 43606, United States
Xianbo Liao
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, Toledo, OH, 43606, United States
Robert W. Collins
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, Toledo, OH, 43606, United States
Xunming Deng
Affiliation:
[email protected], University of Toledo, Department of Physics and Astronomy, Toledo, OH, 43606, United States
Get access

Abstract

At the University of Toledo (UT), we have investigated hydrogenated amorphous silicon (a-Si:H) n-i-p solar cells with intrinsic layers deposited at high rates, ~ 8 Å/s, using our UT multi-chamber load-locked PECVD system. a-Si:H i-layers were grown with a VHF plasma density of ~ 0.2 W/cm2 and a frequency of 70 MHz using various hydrogen dilution levels. It is observed from the current-voltage (I-V) device performance characteristics that the open-circuit voltage (Voc) increases with increasing hydrogen dilution reaching a maximum and then decreasing. This drop in Voc can be attributed to the transition region (or protocrystalline regime) from an amorphous phase into a mixed amorphous+nanocrystalline (a + nc) phase for the i-layer. An initial efficiency of 9.99% (Voc = 0.986 V, Jsc = 13.98 mA/cm2, FF = 72.5%) was obtained. Quantum efficiency (QE) measurement has shown that the blue light response increases as the hydrogen dilution increases. Very good blue light spectral response with QE values over 0.7 at the wavelength of 400 nm have been obtained for a-Si:H cells made under specific deposition conditions in which tailored protocrystalline silicon materials were incorporated at the i/p interface region.

Type
Research Article
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Deng, X. and Schiff, E., a chapter in The Handbook of Photovoltaic Science and Engineering, edited by Luque, A. & Hegedus, S., (John Willey & Sons, Ltd., 2003).Google Scholar
2 Wronski, C. R. and Collins, R. W., Solar Energy 77, 877885 (2004).Google Scholar
3 Collins, R. W., Ferlauto, A. S., Ferreira, G. M., Chen, C., Koh, J., Koval, R. J., Lee, Y., Pearce, J. M., and Wronski, C. R., Solar Energy Materials & Solar Cells 78, 143 (2003).Google Scholar
4 Du, W., Liao, X., Yang, X., Povolny, H., Xiang, X., Deng, X., and Sun, K., Solar Energy Materials and Solar Cells 90, 10981104 (2006).Google Scholar
5 Yan, B., Yang, J., Yue, G., and Guha, S., 2003 MRS Spring Meeting, (San Francisco, CA; USA; 22-25 Apr. 2003), pp. 363368 (2003).Google Scholar
6 Guha, S., Yang, J., Banerjee, A., Yan, B., and Lord, K., Solar Energy Materials and Solar Cells 78, 329347 (2003).Google Scholar
7 Cao, X., Du, W., Yang, X., and Deng, X., 4th World Conference on Photovoltaic Energy Conversion, May 2006, Waikoloa HI (IEEE, Piscataway NJ, 2006).Google Scholar