No CrossRef data available.
Article contents
Electrical Properties of Photoconductor Using Ga2O3/CuGaSe2 Heterojunction
Published online by Cambridge University Press: 28 August 2013
Abstract
The feasibility of using a photoconductor with a Ga2O3/CuGaSe2 heterojunction for visible light sensors was investigated. CIGS chalcopyrite semiconductors have both a high absorption coefficient and high quantum efficiency. However, their dark current is too high for image sensors. In this study, we applied gallium oxide (Ga2O3) as a hole-blocking layer for CIGS thin film to reduce the dark current. Experimental results showed that the dark current was drastically reduced, and an avalanche multiplication phenomenon was observed at an applied voltage of over 6 V. However, this structure had sensitivity only in the ultraviolet light region because its depletion region was almost completely spread in the Ga2O3 layer since the carrier density of the Ga2O3 layer was much lower than that of the CIGS layer. These results indicate that the Ga2O3/CuGaSe2 heterojunction has potential for use in visible light sensors but that we also need to increase the carrier density of the Ga2O3 layer to shift the depletion region to the CIGS film.
Keywords
- Type
- Articles
- Information
- Copyright
- Copyright © Materials Research Society 2013