Hostname: page-component-78c5997874-dh8gc Total loading time: 0 Render date: 2024-11-03T08:39:27.317Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Intermediate Thermal Processing on Microstructural Changes of Oxygen Implanted Silicon-on-Insulator Material

Published online by Cambridge University Press:  28 February 2011

J. D. Lee ,
J. C. Park ,
S. J. Krause ,
P. Roitman  and
M. K. El-Ghor
J. D. Lee
Affiliation:
Chemical, Bio & Materials Engineering, Arizona State University, Tempe, AZ 85287
J. C. Park
Affiliation:
Chemical, Bio & Materials Engineering, Arizona State University, Tempe, AZ 85287
S. J. Krause
Affiliation:
Chemical, Bio & Materials Engineering, Arizona State University, Tempe, AZ 85287
P. Roitman
Affiliation:
National Institute of Standards and Technology, Gaithersberg, MD 20899
M. K. El-Ghor
Affiliation:
Texas Instruments Incorporation, Dallas, TX 75265
Get access

Abstract

The microstructural changes in oxygen implanted silicon-on-insulator material (SIMOX) at intermediate annealing steps and the changes by rapid thermal annealing (RTA) were studied with transmission electron microscopy. Defects found in as-implanted SIMOX, including multiply faulted defects, short stacking faults, and {113} defects, were all removed in anneals from 900°C to 1100°C. The threading dislocations in annealed material form at these temperatures during thermal ramping. RTA shows that the microstructure is significantly influenced by the ramp rate. The very high ramp rate in RTA results in very flat interfaces and a buried oxide layer with no Si islands, but significantly increases the defect density. Overall, the results show that intermediate thermal processing steps strongly affect the final microstructure of SIMOX material.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 235: Symposium A – Phase Formation and Modification by Beam-Solid Interactions , 1991 , 133
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Colinge, J.P., Extended Abstracts IEEE IEDM Meeting, 817 (1989).Google Scholar
2. Krause, S.J., Jung, C.O., Ravi, T.S., Wilson, S.R., and Burke, D.E., Mat. Res. Soc. Symp. Proc., 107, 93 (1988)Google Scholar
3. Margail, J., Stoemenos, J., Jaussaud, C., and Bruel, M., Appl. Phys. Lett., 54(6), 526 (1989).Google Scholar
4. Visitserngtrakul, S., Krause, S.J., Cordts, B.F.. and Roitman, P., Vacuum, 42(5/6), 353 (1991).Google Scholar