Hostname: page-component-78c5997874-ndw9j Total loading time: 0 Render date: 2024-11-02T20:40:42.481Z Has data issue: false hasContentIssue false

The Effect of Deposition and Annealing Conditions on the Microstructure of Al-Cu and Al-Cu-Si Thin Films

Published online by Cambridge University Press:  15 February 2011

M. Park
Affiliation:
Chemical, Bio and Materials Engineering Dept, Arizona State University, Tempe AZ 85287
S. J. Krause
Affiliation:
Chemical, Bio and Materials Engineering Dept, Arizona State University, Tempe AZ 85287
S. R. Wilson
Affiliation:
Advanced Technology Center, Motorola Semiconductor Products Sector, Mesa AZ 85202
Get access

Abstract

The effect of deposition temperature and the addition of Si to sputter deposited Al-Cu thin-film microstructure was studied with transmission electron microscopy. Films were studied in the as-deposited and annealed condition. The effects of thermal treatment were studied with in-situ hot stage microscopy. Al2Cu (θ) precipitated at the grain boundaries and the sublayer interface. At higher deposition temperatures, with alloy composition in single phase region (Al-1.5 wt.%Cu), Al2Cu precipitated during cooldown. At lower temperatures, in the two phase Al-0 region, Al2Cu precipitated during deposition. The addition of Si caused formation of Si precipitates and retarded Al2Cu precipitation during deposition or cooldown.

Type
Research Article
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. D'Heurle, F.M., Met. Trans., 2A, 683 (1971).Google Scholar
2. Weston, D., Wilson, S.R., and Kottke, M., J. Vac. Sci. Tech., A8, 2025 (1990).Google Scholar
3. Totta, P.A., and Sopher, R.P., IBM J. Res. & Dev. 13, 226 (1969).Google Scholar
4. Wilson, S.R., Weston, D., and Kottke, M., Mat. Res. Soc. Proc. 181, 545 (1990).Google Scholar
5. Park, M., Krause, S.J., and Wilson, S.R., XIIth ICEM Proc., 4, 972 (1990).Google Scholar
6. Thomas, M.E., Keyser, T.K., and Goo, E.K., J. Appl. Phys., 59, 3768 (1986).Google Scholar
7. Frear, D.R., Sanchez, J.E., Romig, A.D. Jr., and Morris, J.W., Met. Trans., 21A, 2449 (1990).Google Scholar
8. Mondolfo, C.F., Aluminum alloy, (Butter Worth, London, Boston, 1976), p. 513.Google Scholar
9. Tung, C.-H., Chang, C.-T., Chang, H.-C., Chiu, S., Kok, B., and Chang, L.-H., J. Appl. Phys., 68, 1592 (1990).Google Scholar
10. Wilson, S.R, Thomas, S., and Krause, S.J., Inst. Phys. Conf. Ser. No. 87, 375 (1987).Google Scholar