Hostname: page-component-745bb68f8f-5r2nc Total loading time: 0 Render date: 2025-01-27T03:20:08.009Z Has data issue: false hasContentIssue false
  • English
  • Français

Direct Ion Beam Deposition of Diamond-Like Films From RF Inductively Coupled (IC) Plasma Source: Mechanical, Electrical, and Optical Properties

Published online by Cambridge University Press:  10 February 2011

B. Druz ,
I. Zaritskiy ,
K. Williams ,
A. Hayes ,
V.I. Polyakov ,
A.V. Kchomich ,
Xiodung Li  and
Bharat Bhushan
B. Druz
Affiliation:
Veeco Instruments, Inc., Plainview, NY 11803
I. Zaritskiy
Affiliation:
Veeco Instruments, Inc., Plainview, NY 11803
K. Williams
Affiliation:
Veeco Instruments, Inc., Plainview, NY 11803
A. Hayes
Affiliation:
Veeco Instruments, Inc., Plainview, NY 11803
V.I. Polyakov
Affiliation:
Institute of Radio Eng. & Electronics, 11 Mohovaya str,103907 Moscow, Russia
A.V. Kchomich
Affiliation:
Institute of Radio Eng. & Electronics, 11 Mohovaya str,103907 Moscow, Russia
Xiodung Li
Affiliation:
The Ohio State University, 206 W 18 Av. Ohio 43210-1107
Bharat Bhushan
Affiliation:
The Ohio State University, 206 W 18 Av. Ohio 43210-1107
Get access

Abstract

Diamond-like carbon (DLC) films were deposited on various substrates using direct ion beam deposition from an RF IC hydrocarbon plasma source. Combinations of gases such as CH4. CH4–N2 were used to form plasma. The mechanical, electrical and optical properties of the films were examined as a function of deposition conditions and N2 content in gas mixture. A small amount of N2 (<8 sccm) did not markedly change hardness and stress, while electrical conductivity was significantly increased. In addition, a small amount of N2 improved wear performance of the films reducing amount of debris and wear track size. Introduction of high N2 flow into the system significantly deteriorates value of these parameters. It was found that N2 essentially increases absorption coefficient, and reduces optical band gap. Analysis of the experimental results shows that observed effects can be explained by incorporation of N2 into carbon-strained network that induces structural changes and. in turn, leads to an increase of sp2 fraction in the DLC films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 593: Symposium U – Amorphous & Nanostructured Carbon , 1999 , 273
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Druz, B., Ostan, E., DiStefano, S., Hayes, A., Kanarov, V., Polyakov, V.I., Rukovishnikov, A.I., Rossukanyi, N.M., Khomich, A.V., Diamond and Related Materials 7, 965 (1998)Google Scholar
2. Druz, B., DiStefano, S., Hayes, A., Ostan, E., Williams, K., Wang, L., Surface Coating Technol 86–87 708 (1996).Google Scholar
3. Druz, B., Polyakov, V.I., Hayes, A., Ostan, E., Rukovishnikov, A.I., Rossukanyi, N.M., Khomich, A.V., in Amorphous and Crystalline Insulating Thin Films, Mat Res Soc Symp :Proc 446, 413 (1996).Google Scholar
4. Argon, A. S., Gupta, V., Landis, H. S., and Cornie, J. A., Mater. Sci. Eng., 107, 41 (1989).Google Scholar
5. Bhushan, B. and Li, X., Journal of Materials Research, 12, 54 (1997).Google Scholar
6. Dishler, B., Proc. European. Mater. Res. Symp. 17, 18 (1987).Google Scholar
7. Kaufman, H., Metin, S., and Saperstein, D.D., Phys. Rev. B 39, 1353 (1989)Google Scholar
8. Silva, S.R.P., Robertson, J., Amaratunga, G.A.J., Rafferty, B., Brown, L.M., Schwan, J., Franceschini, D.F., Mariotto, G., J. Appl. Phys. 81, 2626 (1997).Google Scholar