Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-30T21:12:18.310Z Has data issue: false hasContentIssue false

Demultiplexer/Photodetector Integrated System Based on a-SiC:H Multilayered Structures

Published online by Cambridge University Press:  01 February 2011

Paula Louro
Affiliation:
[email protected], ISEL, DEETC, Lisbon, Portugal
Manuela Vieira
Affiliation:
[email protected], ISEL, DEETC, R. Conselheiro Emídio Navarro, Lisbon, 1954-114, Portugal, +351218317180, +351218317114
M. A. Vieira
Affiliation:
[email protected], ISEL, DEETC, R. Conselheiro Emídio Navarro, Lisbon, 1954-114, Portugal, +351218317180, +351218317114
João Costa
Affiliation:
[email protected], ISEL, DEETC, R. Conselheiro Emídio Navarro, Lisbon, 1954-114, Portugal, +351218317180, +351218317114
Miguel Fernandes
Affiliation:
[email protected], ISEL, DEETC, R. Conselheiro Emídio Navarro, Lisbon, 1954-114, Portugal, +351218317180, +351218317114
Manuel Barata
Affiliation:
[email protected], ISEL, DEETC, R. Conselheiro Emídio Navarro, Lisbon, 1954-114, Portugal, +351218317180, +351218317114
Get access

Abstract

In this paper we present results on the use of multilayered a-SiC:H heterostructures as an integrated device for simultaneous wavelength-division demultiplexing and measurement of optical signals. These devices are useful in optical communications applications that use the wavelength division multiplexing technique to encode multiple signals into the same transmission medium.

The device is composed of two stacked p-i-n photodiodes, both optimized for the selective collection of photo generated carriers. Band gap engineering was used to adjust the photogeneration and recombination rates profiles of the intrinsic absorber regions of each photodiode to short and long wavelength absorption and carrier collection in the visible spectrum. The generated photocurrent signal using different input optical channels was analyzed at reverse and forward bias and under steady state illumination. A demux algorithm based on the voltage controlled sensitivity of the device was proposed and tested. An electrical model of the WDM device is presented and supported by the solution of the respective circuit equations. Other possible applications of the device in optical communication systems are also proposed.

Type
Research Article
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 as, MichaBel, Fiber Optics Handbook, Fiber, Devices and Systems for Optical Communication, Chap, 13, Mc Graw-Hill, Inc. 2002.Google Scholar
2 Louro, P., Vieira, M., Vygranenko, Yu., Fantoni, A., Fernandes, M., Lavareda, G., Carvalho, N. Mat. Res. Soc. Symp. Proc., 989 (2007) A12.04.Google Scholar
3 Vieira, M., Fernandes, M., Louro, P., Fantoni, A., Vygranenko, Y., Lavareda, G., Carvalho, C. Nunes de, Mat. Res. Soc. Symp. Proc., Vol. 862 (2005) A13.4.Google Scholar
4 Louro, P., Vieira, M., Vieira, M.A., Fernandes, M., Fantoni, A., Francisco, C., Barata, M., Physica E: Low-dimensional Systems and Nanostructures, 41 (2009) 10821085.Google Scholar
5 Louro, P., Vieira, M., Fernandes, M., Costa, J., Vieira, M. A., Caeiro, J., Neves, N., Barata, M., Phys. Status Solidi C 7, No. 3–4, 11881191 (2010).Google Scholar
6 Vieira, M. A., Vieira, M., Fernandes, M., Fantoni, A., Louro, P., Barata, M., Amorphous and Polycrystalline Thin-Film Silicon Science and Technology 2009, MRS Proceedings Vo. 1153, A08–0.Google Scholar