Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-28T07:30:31.975Z Has data issue: false hasContentIssue false
  • English
  • Français

Recent Advances in the STM-based Luminescence Microscopy of Cu(In,Ga)Se2 thin films

Published online by Cambridge University Press:  31 January 2011

Manuel J. Romero ,
Miguel A. Contreras ,
Ingrid Repins ,
Chun-Sheng Jiang  and
Mowafak Al-Jassim
Manuel J. Romero
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Miguel A. Contreras
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Ingrid Repins
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Chun-Sheng Jiang
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Mowafak Al-Jassim
Affiliation:
[email protected], National Renewable Energy Laboratory, Golden, Colorado, United States
Get access

Abstract

We report on recent advances in the development of a luminescence spectroscopy based on scanning tunneling microscopy (STM) and its application to fundamental aspects of Cu(In,Ga)Se2 (CIGS) thin films. Relevant to our discussion is the specifics of the surface electronics. The CIGS shows pronounced stoichiometric deviations at the surface and, consequently, distinct surface electronics that has been shown to be critical in achieving high efficiency. Cathodoluminescence (CL), a luminescence spectrum imaging mode in scanning electron microscopy (SEM), provides a direct correlation between the microstructure of the CIGS and its electronic properties. As such, cathodoluminescence can resolve the emission spectrum between grain boundaries and grain interiors or be used to investigate the influence of local orientation and stoichiometry on the electronic properties of the CIGS at the microscale. Cathodoluminescence is not a surface microscopy, however, and resolving the electronic structure of the CIGS surface remains elusive to all luminescence microscopies. With this motivation, we have developed a luminescence microscopy based on STM, in which tunneling electrons are responsible for the excitation of luminescence (scanning tunneling luminescence or STL). The hot-tunneling-electron excitation is confined to the surface and, consequently, the tunneling luminescence spectrum reveals the electronic states near the surface. The STM is integrated inside the SEM and, therefore, both CL and STL can be measured over the same location and compared. Using this setup, the transition from the grain interior to the surface can be investigated. We have improved the collection of our optics to a level in which tunneling luminescence spectrum imaging can be performed. Here we present a detailed account on our investigation of the surface electronics in CIGS deposited in the regime of selenium deficiency as defined by <Se>/(<Cu> + <In> + < Ga >) = 1.

Keywords

photovoltaicscanning tunneling microscopy (STM)luminescence
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1165: Symposium M – Thin-Film Compound Semiconductor Photovoltaics–2009 , 2009 , 1165-M09-11
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Repins, I. Contreras, M. A. Egaas, B. DeHart, C. Scharf, J. Perkins, C.L. To, B. and Noufi, R.. Prog. Photovol.: Res. and Appl. 16, 235(2008).Google Scholar
[2] Zhang, S. B. Wei, S.H. and Zunger, A. Phys. Rev. Lett. 78, 4059(1997); S. B. Zhang, S.H. Wei, A. Zunger, and H. Katayama-Yoshida, Phys. Rev. B 57, 9642(1998).Google Scholar
[3] Persson, C. and Zunger, A. Phys. Rev. Lett. 91, 266401(2003).Google Scholar
[4] Yan, Y. Jones, K. M. Abushama, J. Young, M. Asher, S. Al-Jassim, M. M., and Noufi, R. Appl. Phys. Lett. 81, 1008(2002).Google Scholar
[5] Jiang, C.S. Hasoon, F. S. Moutinho, H. R. Al-Thani, H. A., Romero, M. J. and Al-Jassim, M. M., Appl. Phys. Lett. 82, 127(2003).Google Scholar
[6] Romero, M. J. Liu, F. Kunz, O. Wong, J. Jiang, C.S. Al-Jassim, M. M., and Aberle, A. G. in these proceedings, Symposium A.Google Scholar
[7] Romero, M. J. Ramanathan, K. Contreras, M. A. Al-Jassim, M. M., Noufi, R. and Sheldon, P. Appl. Phys. Lett. 83, 4770(2003).Google Scholar
[8] Contreras, M. A. Repinds, I. Metzger, W. K. Romero, M. J. and Abou-Ras, D.. Physica Status Solidi, in press (2009).Google Scholar
[9] Romero, M. J. Jiang, C.S. Noufi, R. and Al-Jassim, M., Appl. Phys. Lett. 87, 172016(2005).Google Scholar
[10] Contreras, M. A. Romero, M. J. and Noufi, R.. Thin Solid Films 511, 51(2006).Google Scholar