Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-28T10:02:31.904Z Has data issue: false hasContentIssue false

Reaction Dynamics for Gold Nanoparticles Synthesis in Solution Plasma

Published online by Cambridge University Press:  01 February 2011

Junko Hieda
Affiliation:
[email protected], Graduate School of Engineering, Nagoya University, Department of Materials, Physics and Energy Engineering, Furo-cho, Chikusa, Nagoya, 464-8603, Japan
Nagahiro Saito
Affiliation:
[email protected], Graduate School of Engineering, Nagoya University, Department of Molecular Design and Engineering, Furo-cho, Chikusa, Nagoya, 464-8603, Japan
Osamu Takai
Affiliation:
[email protected], EcoTopia Science Research Institute, Nagoya University, Furo-cho, Chikusa, Nagoya, 464-8603, Japan
Get access

Abstract

We describe the dynamics of the synthesis of gold nanoparticles by glow discharge in aqueous solutions. Initial [AuCl4] concentration and the voltage applied between the electrodes were varied. Reduction rates were calculated from changes in concentration of [AuCl4] vs. discharge time. A pulsed power supply was used to generate discharges in the aqueous solutions. The morphology of the nanoparticles obtained was observed by transmission electron microscopy (TEM). [AuCl4] was reduced by H radicals or electrons generated by the discharge. Dendrite-shaped nanoparticles ∼150 nm in size were formed after discharge for 1 min. The pH of the solution decreased gradually with increasing discharge time. The decrease in pH led to dissolution of gold nanoparticles. The reduction and dissolution rates increased proportionately with the applied voltage. The size of gold nanoparticles decreased during discharge and was 20 nm after discharge for 45 min. When the reduction rate lowered as a result of dissolution, anisotropic nanoparticles were formed and continued to grow in the solution.

Type
Research Article
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Lung, J.K., Huang, J.C., Tien, D.C., Liao, C.Y., Tseng, K.H., Tsung, T.T., Kao, W.S., Tsai, T.H., Jwo, C.S., Lin, H.M., Stobinski, L., J. Alloys and Compounds 434–435, 655 (2007).Google Scholar
2. Cushing, B. L., Kolesnichenko, V. L., O’Connor, C. J., Chem. Rev. 104, 3893 (2004).Google Scholar
3. Mafune, F., Kohno, J., Takeda, Y., Kondow, T., J. Phys. Chem. B 105, 5114 (2001).Google Scholar
4. Daniel, M., Astruc, D., Chem. Rev. 104, 293 (2004).Google Scholar
5. Terasaki, N., Yamamoto, N., Tamada, K. et al. , Biochim. Biophy. Acta 1767, 653 (2007).Google Scholar
6. Murphy, C. J., Sau, T. K., Gole, A. M., Orendorff, C.J., Gao, J., Gou, L., Hunyadi, S. E., Li, T., J. Phys. Chem. B 109,13857 (2005).Google Scholar
7. Mizukoshi, Y., Okitsu, K., Bandow, H., Nagata, Y. and Maeda, Y., Bunseki-Kagaku. Jpn. 45, 327 (1996).Google Scholar
8. Tsuji, M., Miyamae, N., Hashimoto, M., Nishio, M., Hikino, S., Ishigami, N., Tanaka, I., Colloids and Surfaces A: Physicochem. Eng. Aspects 302, 587 (2007).Google Scholar