Hostname: page-component-78c5997874-t5tsf Total loading time: 0 Render date: 2024-11-08T00:32:28.818Z Has data issue: false hasContentIssue false
  • English
  • Français

Mechanical Property Evaluation of Electroplated High Aspect Ratio Microstructures

Published online by Cambridge University Press:  10 February 2011

L. S. Stephens ,
K.W. Kelly ,
E.I. Meletis  and
S. Simhadri
L. S. Stephens
Affiliation:
Mechanical Engineering Department, Louisiana State University, Baton Rouge, LA 70803 [email protected]
K.W. Kelly
Affiliation:
Mechanical Engineering Department, Louisiana State University, Baton Rouge, LA 70803 [email protected]
E.I. Meletis
Affiliation:
Mechanical Engineering Department, Louisiana State University, Baton Rouge, LA 70803 [email protected]
S. Simhadri
Affiliation:
Mechanical Engineering Department, Louisiana State University, Baton Rouge, LA 70803 [email protected]
Get access

Abstract

High aspect ratio microstructures (HARMs) with a height of hundreds of micrometers and a width of a few tens of micrometers present high promise in a number of challenging fields. At LSU, a number of applications are being developed in which nickel HARMs are electroplated on metal surfaces (mold insert fabrication for the LIGA process, HARMs on mechanical seal faces, HARMs on heat exchange surfaces, etc.). In some of these applications, the HARMs are subjected to high stresses and the mechanical properties are particularly important. These properties can be used to adjust processing parameters to optimize properties of the HARMS.

This paper presents a method for measuring the strength properties of cantilevered nickel HARMs constructed by LIGA. Experimentally measured values are reported for modulus of rupture (1280 MPa), Young's modulus (153 GPa) and Knoop hardness (500 Hk) for HARMs with an overplated base. SEM micrographs clearly indicate that failure of the beams is brittle and most frequently occurs at the interface of the beam and overplated base.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 518: Symposium N – Microelectromechanical Structures for Materials Research , 1998 , 173
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Zou, Z.L. Quanbo and Liu, Litian, International Conference on Solid-State and Integrated Circuit Technology, 1995, pp. 488–490.Google Scholar
2 Sato, M.S. Kazuo, Yamasaki, Masanori, and Yoshioka, Tetsuo, The Ninth International Workshop on MEMS, IEEE Catalog Number 96CH35856, 1996, pp. 360–364.Google Scholar
3 Sharpe, W.N. Jr., Yuan, B. and Vaidyanathan, R., Proceeding of SPIE, Microlithography nad Metrology in Micromachining-II, vol. 2880, 1996, pp. 78–91 Google Scholar
4 Sharpe, W.N. Jr., LaVan, D.A. and McAleavey, A., ASME J. of MEMS, DSC-vol. 62/HTD- vol. 354, 1997, pp. 93–97 Google Scholar
5 Mazza, E., Abel, S., Dual, J., “Experimental Determination of Mechanical Properties of Ni and Ni-Fe Microbars”, Micro System Technologies, Springster International, 1996 Google Scholar
6 Metals Handbook American Society for Metals, 1985 Google Scholar