Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-24T16:40:15.192Z Has data issue: false hasContentIssue false
  • English
  • Français

Fabrication and Characterization of Cold Rolled Ni/Al Multilayer Foils

Published online by Cambridge University Press:  26 February 2011

Xiaotun Qiu ,
Jesse Harris Graeter ,
Laszlo Kecskes  and
Jiaping Wang
Xiaotun Qiu
Affiliation:
[email protected], Louisiana State University, Mechanical Engineering, 2508 CEBA, Louisiana State University, Baton Rouge, LA, 70803, United States
Jesse Harris Graeter
Affiliation:
[email protected], Louisiana State University, Department of Mechanical Engineering, Baton Rouge, LA, 70803, United States
Laszlo Kecskes
Affiliation:
[email protected], Army Research Laboratory, Aberdeen Proving Ground, Aberdeen, MD, 21005, United States
Jiaping Wang
Affiliation:
[email protected], Louisiana State University, Department of Mechanical Engineering, Baton Rouge, LA, 70803, United States
Get access

Abstract

Ni/Al reactive multilayer foils were fabricated by cold rolling method and self-propagating reactions in these foils were investigated. A two-stage phase formation process was observed in the ignition experiment. The first step is the lateral growth of Al3Ni phase from isolated nucleation sites and the following coalescence into a continuous layer; the second step is the growth of such Al3Ni layers in the perpendicular direction of the interface until all Al is consumed. As there is still Ni available, Al3Ni will continuously react with Ni until no Ni is left, and the final reaction product turns out to be ordered B2 AlNi compound. X-ray diffraction (XRD) experiments showed that the reaction product of the cold rolled foil was the same as the physical vapor deposition (PVD) foil. The reaction process was studied by differential scanning calorimetry (DSC). Three peaks can be identified from the DSC curve. Cold rolled foils were heated to different peak temperatures obtained from DSC curve with the same heating rate as DSC. XRD results for such foils showed that the first two peaks were the exothermic formation of Al3Ni, while the last one was for the formation of AlNi. The enthalpy of the reaction for the cold rolled foil was calculated to be -57.5 KJ/mol, which was in good agreement with the formation enthalpy of AlNi (-59 KJ/mol). The reaction velocities of the first formation stage were measured to be 7mm/s for cold rolled foils, which were much smaller than the reaction velocities of PVD foils (which range between 1-30 m/s).

Keywords

energetic materialcombustion synthesislayered
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 977: Symposium FF – Processing-Structure-Mechanical Property Relations in Composite Materials , 2006 , 977-FF01-02
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Ma, E., Thompson, C. V., Clevenger, L. A., Tu, K. N., Appl. Phys. Lett. 57, 1262 (1990).10.1063/1.103504Google Scholar
2. Reiss, M. E., Esber, C. M., Van Heerden, D., Gavens, A. J., Williams, M. E., Weihs, T. P., Mater. Sci. Eng. A261 217 (1999).Google Scholar
3. Wang, J., Besnoin, E., Duckham, A., Spey, S. J., Reiss, M. E., Knio, O. M., Weihs, T. P., J. Appl. Phys. 95, 248 (2004).Google Scholar
4. Wang, J., Besnoin, E., Knio, O. M., Weihs, T. P., J. Appl. Phys. 97, 4307 (2005).Google Scholar
5. Duckham, A., Spey, S. J., Wang, J., Reiss, M. E., Weihs, T. P., J. Appl. Phys. 96, 2336 (2004).10.1063/1.1769097Google Scholar
6. Wang, J., Besnoin, E., Duckham, A., Spey, S. J., Reiss, M., Knio, O. M., Powers, M., Whitener, M., Weihs, T. P., Appl. Phys. Lett. 83, 3987 (2003).10.1063/1.1623943Google Scholar
7. Swiston, A. J. Jr, Hufnagel, T. C., Weihs, T. P., Scripta. Mater. 48, 1575 (2003).Google Scholar
8. Battezzati, L., Pappalepore, P., Purbiano, F., Gallino, I., Acta. Mater. 47, 1901 (1999).10.1016/S1359-6454(99)00040-3Google Scholar
9. Sieber, H., Park, J. S., Weissmüller, J., Perepezko, H, Acta. Mater. 49, 1139 (2001).Google Scholar
10. Qiu, X., Graeter, J., Kecskes, L., Wang, J., to be submitted to J. Mater Res. Google Scholar
11. Ma, E., Thompson, C. V., J. Appl. Phys. 69, 2211 (1991).10.1063/1.348722Google Scholar
12. Qiu, X., Wang, J., submitted to Scripta. Mater. Google Scholar
13. Pretorius, R., Vredenberg, A. M., Saris, F. W., de Reus, R., J. Appl. Phys. 70, 3636 (1991).Google Scholar
14. Mann, A. B., Gavens, A. J., Reiss, M. E., Van Heerden, D., Bao, G., Weihs, T. P., J. Appl. Phys. 82, 1178 (1997).Google Scholar
15. Gavens, A. J., Van Heerden, D., Mann, A. B., Reiss, M. E., Weihs, T. P., J. Appl. Phys. 87, 1255 (2000).Google Scholar