Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-08T05:21:35.610Z Has data issue: false hasContentIssue false

The Effects of Interfacial Reactions in the Formation of Ohmic Contacts to GaAs

Published online by Cambridge University Press:  25 February 2011

Verlyn Fischer
Affiliation:
Dept. of Materials Science and Engineering, University of Florida, Gainesville, FL 32611;
P.E. Viljoen
Affiliation:
Dept. of Materials Science and Engineering, University of Florida, Gainesville, FL 32611; Permanent Address: Dept. of Physics, University of the Orange Free State, Bloemfontein, Republic of South Africa;
E. Ristolainen
Affiliation:
Dept. of Materials Science and Engineering, University of Florida, Gainesville, FL 32611; Permanent Address: Center for Chemical Analysis, Helsinki University of Technology, Helsinki, Finland;
P.H. Holloway
Affiliation:
Dept. of Materials Science and Engineering, University of Florida, Gainesville, FL 32611;
W.V. Lampert
Affiliation:
Materials Directorate, Wright Laboratory, Wright Patterson Air Force Base, OH 45433-6533;
T.W. Haas
Affiliation:
Materials Directorate, Wright Laboratory, Wright Patterson Air Force Base, OH 45433-6533;
J.M. Woodall
Affiliation:
Dept. of Electrical Engineering, Purdue University, West Lafayette, IN 47907
Get access

Abstract

The effect of heat treatments between 400°C and 500°C on electrical contacts of In, Ga, Pb, and AU to n- or p-GaAs, and Ni to n-GaAs have been studied using current-voltage (I-V), Auger electron spectroscopy and scanning electron microscopy. Ohmic contacts were formed between In and GaAs upon heating due to formation of an InGaAs surface layer with low interfacial transport barriers. The contacts between Ga or Pb and n- and p-GaAs remained rectifying due to a lack of interfacial reaction. Films of Au reacted with both n-and p-type GaAs resulting in rectangular "pits". This led to ohmic contacts only on n-type substrates due to segregation of the Si dopants to the surface of the decomposed GaAs "pits". Dopant segregation did not occur when Au reacted with p-GaAs or Ni reacted with n-GaAs, thus these contacts remained rectifying at lower doping densities (4 x 1017 cm-3).

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Shen, T.C., Gao, G.B. and Morkoc, H., J. Vac. Sci. Technol. B10, 2113 (1992).CrossRefGoogle Scholar
2 See chapters 1,2 and 6 in Contacts to Semiconductors. Fundamentals and Technology, Ed. by Brillson, L.J. (Noyes Publ., New York, 1993).Google Scholar
3 Holloway, P.H., Liu, Lu-Min Yeh, David, H. Powell and Alan Brown, Appl. Phys. Lett. 59, 947 (1991).CrossRefGoogle Scholar
4 Sze, S.M.. Physics of Semiconductor Devices, Second Edition (John Wiley and Sons, New York, 1981).Google Scholar
5 Liu, Lu-Min Yeh, Metallurgical and Electrical Properties of Au/GaAs Electrical Contacts, PhD Dissertation, University of Florida, 1988.Google Scholar
6 Freeouf, J.L., Warren, A.C., Kirchner, P.D., Woodall, J.M. and Melloch, M.R., J. Vac. Sci. Technol. B9, 2355 (1991).CrossRefGoogle Scholar
7 Vieland, L.J. and Skalsi, S. in Metallurgy of Elemental and Compound Semiconductors, edited by Grubal, R.O. (Interscience, New York, 1961) p.303.Google Scholar
8 Solomon, J.S. and Smith, S.R., J. Vac. Sci. Technol. A5, 1809 (1987).CrossRefGoogle Scholar
9 Chambers, S.A. and Loebs, V.A., Appl. Phys. Lett. 60, 38 (1992).CrossRefGoogle Scholar
10 ASM Handbook: Alloy Phase Diagrams, Volume 3, Edited by Baker, H. (ASM International, Metals Park, OH, 1992).Google Scholar
11 Liu, Lu-Min Yeh and Holloway, P.H., Mat. Res. Soc. Symp. Proc. Vol. 144, p. 607 (1989).Google Scholar
12 Mueller, C.M., Holloway, P.H. and Connell, R.G., in Advanced Metallization and Processing of Semiconductor Devices, Ed. by Katz, A., Nissim, Y.I., Murarka, S.P. and Harper, J.M.E. (MRS, Pittsburgh, PA, 1992) Vol. 260, p. 481.Google Scholar