Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-28T16:01:38.352Z Has data issue: false hasContentIssue false
  • English
  • Français

Bioreactor Based Bone Tissue Engineering: Influence of Wall Collision on Osteoblast Cultured on Polymeric Microcarrier Scaffolds in Rotating Bioreactors

Published online by Cambridge University Press:  01 February 2011

Xiaojun Yu ,
Edward A. Botchwey ,
Elliot M. Levine ,
Solomon R. Pollack  and
Cato T. Laurencin
Xiaojun Yu
Affiliation:
Department of Orthopaedic Surgery, University of Virginia, Charlottesville, VA
Edward A. Botchwey
Affiliation:
Department of Biomedical Engineering, University of Virginia, Charlottesville, VA
Elliot M. Levine
Affiliation:
The Wistar Institute, Philadelphia, PA 19104, U.S.A.
Solomon R. Pollack
Affiliation:
Department of Bioengineering, University of Pennsylvania, Philadelphia, PA 19104
Cato T. Laurencin*
Affiliation:
Department of Orthopaedic Surgery, University of Virginia, Charlottesville, VA Department of Biomedical Engineering, University of Virginia, Charlottesville, VA Department of Chemical Engineering, University of Virginia, Charlottesville, VA
*
Corresponding author: Cato T. Laurencin M.D., Ph.D., University Professor, Lillian T.Pratt Distinguished Professor and Chair of Orthopaedic Surgery, Professor of Biomedical and Chemical Engineering, 400. Ray C.Hunt Drive, Suite 330, University of Virginia, Charlottesville, VA 22908, Ph: 1-434-243-0250, Fax: 1-434-243-0242, Email address:[email protected]
Get access

Abstract

Rotating bioreactors have been used to overcome the limitations of passive nutrient diffusion in three-dimensional (3D) constructs for tissue engineering of bone. It is hypothesized that conventional scaffolds undergo repeated wall collisions in rotating bioreactors, which may disrupt bone tissue formation. In this study, we investigated the effects of wall collision on osteoblastic cells cultured on a microsphere based scaffold of varying densities in comparison to water. The conventional heavier than water (HTW; density > 1 g/cm3) scaffolds were fabricated by sintering HTW microspheres of 85:15 poly (lactide-co-glycolide) (PLAGA), and mixed scaffolds were designed by mixing lighter than water (LTW; density < 1 g/cm3) and HTW microspheres of PLAGA. We quantified average velocities of the two types of scaffolds using a particle tracking system, and no significant difference in average velocities was observed between the two types of scaffolds. However, HTW scaffolds have frequent wall collision and mixed scaffolds can avoid wall collision in bioreactors. When human Saos-2 osteoblast like cells were cultured on the scaffolds in bioreactors for 16 days, bone cell proliferation and cell differentiation on HTW scaffolds were significantly inhibited as compared to those cultured on mixed scaffolds in rotating bioreactors. These results indicate that collision between scaffolds and bioreactor wall is a confounding factor in osteoblastic cell proliferation and differentiation. These studies provide a foundation for development of 3D scaffolds for tissue engineering of bone in rotating bioreactors.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 845: Symposium AA – Nanoscale Materials Science in Biology and Medicine , 2004 , AA5.38
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Goldstein, A. S., Juarez, T. M., Helmke, C. D., Gustin, M. C., and Mikos, A. G., Biomaterials. 22, 1279 (2001).Google Scholar
2. Sikavitsas, V. I., Bancroft, G. N., and Mikos, A. G., J. Biomed. Mater. Res. 62, 136 (2002).Google Scholar
3. Cherry, R. S., and Papoutsakis, E. T., Biotechnology and Bioengineering. 32(8), 1001 (1988).Google Scholar
4. Yu, X., Botchwey, E. A., Levine, E. M., Pollack, S. R., and Laurencin, C.T., PNAS. 106, 22145 (2004).Google Scholar
5. Botchwey, E. A., Dupree, M. A., Pollack, S. R., Levine, E. M., and Laurencin, C.T., J. Biomed. Mater. Res. 67A(1), 357 (2003).Google Scholar
6. Botchwey, E. A., Pollack, S. R., Levine, E. M, Johnston, E. D., and Laurencin, C. T., J Biomed Mater Res. 69A(2), 205 (2004).Google Scholar
7. Botchwey, E. A., Pollack, S. R., El-Amin, S., Levine, E. M., Tuan, R. S., and Laurencin, C. T., Biorheology. 40, 299 (2003).Google Scholar
8. Botchwey, E. A., Pollack, S. R., Levine, E. M., and Laurencin, C. T., J. Biomed. Mat. Res. 55, 242 (2001).Google Scholar
9. Pollack, S. R., Meaney, D.F., Levine, E. M., Litt, M., and Johnston, E. D., Tissue Eng. 6, 519 (2000).Google Scholar