Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-24T13:58:02.106Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of Processing Parameters on Zinc Oxide Thin Films Prepared by Single Solution Deposition

Published online by Cambridge University Press:  11 May 2016

Manuel F. Martinez ,
Shaimum Shahriar ,
Donato Kava ,
Cheik Sana ,
Vanessa Castaneda ,
Jose Galindo  and
Deidra R. Hodges
Manuel F. Martinez
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Shaimum Shahriar
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Donato Kava
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Cheik Sana
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Vanessa Castaneda
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Jose Galindo
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
Deidra R. Hodges*
Affiliation:
Electrical and Computer Engineering, The University of Texas at El Paso, El Paso, TX 79968, U.S.A.
*
*(Email: [email protected])
Get access

Abstract

Zinc oxide thin films were prepared via the sol-gel spin-coating method with the use of a spin processor. The film’s annealing parameters were varied to study their impact on the final film morphology and electrical properties. Characterization of the structural properties of the samples was carried on a X-ray diffractometer (XRD) and scanning electron microscopy. Electrical characterization was obtained with the use of a four point probe. Optical characterization of the samples was carried on a UV-Vis-NIR Spectrophotometer. Samples annealed under a cover are observed to have a higher transmission percentage on the visible light range while having a very small grain size and small relative resistivity. Samples annealed under standard atmospheric conditions show a larger grain size and resistivity, and correlated to it, a smaller transmission percentage. Samples annealed under vacuum prove to have a much more reduced optical, electrical, and structural properties when compared to the rest of the samples.

Keywords

optical propertiesmorphologyelectrical properties
Type
Articles
Information
MRS Advances , Volume 1 , Issue 47: Electronics and Photonics , 2016 , pp. 3199 - 3205
Copyright
Copyright © Materials Research Society 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Liu, D. and Kelly, T. L., “Perovskite solar cells with a planar heterojunction structure prepared using room-temperature solution processing techniques,” Nat. Photonics, vol. 8, no. 2, pp. 133–138, 2013.Google Scholar
Beek, W. J. E., Wienk, M. M., Kemerink, M., Yang, X., and Janssen, R. A. J., “Hybrid zinc oxide conjugated polymer bulk heterojunction solar cells,” J.Phys.Chem.B, vol. 109, pp. 9505–9516, 2005.Google Scholar
Kim, H.-S., Lee, C.-R., Im, J.-H., Lee, K.-B., Moehl, T., Marchioro, A., Moon, S.-J., Humphry-Baker, R., Yum, J.-H., Moser, J. E., Grätzel, M., and Park, N.-G., “Lead Iodide Perovskite Sensitized All-Solid-State Submicron Thin Film Mesoscopic Solar Cell with Efficiency Exceeding 9%,” Sci. Rep., vol. 2, pp. 1–7, 2012.Google Scholar
Ball, J. M., Lee, M. M., Hey, A., and Snaith, H. J., “Low-temperature processed meso-superstructured to thin-film perovskite solar cells,” Energy Environ. Sci., vol. 6, no. 6, p. 1739, 2013.CrossRefGoogle Scholar
Kamaruddin, S. A., Chan, K.-Y., Yow, H.-K., Zainizan Sahdan, M., Saim, H., and Knipp, D., “Zinc oxide films prepared by sol–gel spin coating technique,” Appl. Phys. A, vol. 104, no. 1, pp. 263–268, 2011.CrossRefGoogle Scholar
Li, X. D., Chen, T. P., Liu, P., Liu, Y., and Leong, K. C., “Effects of free electrons and quantum confinement in ultrathin ZnO films: a comparison between undoped and Al-doped ZnO,” Opt. Express, vol. 21, no. 12, pp. 14131–14138, 2013.Google Scholar
Ohyama, M., “Sol – Gel Preparation of Transparent and Conductive Aluminum-Doped Zinc Oxide Films with Highly Preferential Crystal Orientation,” J. Am. Ceram. Soc., vol. 32, pp. 1622–1632, 1998.Google Scholar
Nunes, P., Malik, A., Fernandes, B., Fortunato, E., Vilarinho, P., and Martins, R., “Influence of the doping and annealing atmosphere on zinc oxide thin films deposited by spray pyrolysisn zinc oxide thin films deposited by spray pyrolysis,” Vacuum, vol. 52, no. 1–2, pp. 45–49, 1999.Google Scholar
Ladanov, M., “ZnO Nanostructures : Growth, Characterization and Applications,” no. January, 2012.Google Scholar
Li, H., Wang, J., Liu, H., Yang, C., Xu, H., Li, X., and Cui, H., “Sol - Gel preparation of transparent zinc oxide films with highly preferential crystal orientation,” Vacuum, vol. 77, no. 1, pp. 57–62, 2004.Google Scholar
Sahoo, T., Kim, M., Lee, M. H., Jang, L. W., Jeon, J. W., Kwak, J. S., Ko, I. Y., and Lee, I. H., “Nanocrystalline ZnO thin films by spin coating-pyrolysis method,” J. Alloys Compd., vol. 491, no. 1–2, pp. 308–313, 2010.Google Scholar
Zhao, X., Lee, J. Y., Kim, C. R., Heo, J., Shin, C. M., Leem, J. Y., Ryu, H., Chang, J. H., Lee, H. C., Jung, W. G., Son, C. S., Shin, B. C., Lee, W. J., Tan, S. T., Zhao, J., and Sun, X., “Dependence of the properties of hydrothermally grown ZnO on precursor concentration,” Phys. E Low-Dimensional Syst. Nanostructures, vol. 41, no. 8, pp. 1423–1426, 2009.Google Scholar