Published online by Cambridge University Press: 05 July 2018
Steady-state tremolite dissolution rates, at far-from-equilibrium conditions, were measured as a function of aqueous silica and magnesium activity, pH from 1.9 to 6.7, and temperature from 25 to 150ºC. Calcium is released from tremolite faster than either Mg or Si throughout most of the experiments even after these latter elements attained steady-state release rates. The preferential removal of Ca releases fine Mg-Si rich needle-like fibres from the tremolite, probably promoting its toxicity. In contrast, Mg was released in stoichiometric or near to stoichiometric proportion to Si once steady-state was attained. Measured steady-state tremolite dissolution rates based on Si release can be described using
where r+ signifies the BET surface area-normalized forward tremolite steady-state dissolution rate, AA refers to a pre-exponential factor = 6610–3 mol cm–2 s–1, EA designates an activation energy equal to 80 kJ mol–1, R represents the gas constant, T denotes absolute temperature, and ai refers to the activity of the subscripted aqueous species. This rate expression is consistent with tremolite dissolution rates at acidic pH being controlled by the detachment of partially liberated silica tetrahedra formed from the exchange of Mg2+ for two protons near the mineral surface after the near-surface Ca has been removed. Nevertheless, Mg release rates from tremolite are ~3 orders of magnitude slower than those from forsterite and enstatite suggesting that tremolite carbonation will be far less efficient than the carbonation of these other Mg-silicate minerals.
Present address: Barr Consulting, Duluth MN, USA