Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-28T02:06:04.820Z Has data issue: false hasContentIssue false
  • English
  • Français

Operating characteristics of intense electron beam accelerator at different load conditions

Published online by Cambridge University Press:  01 August 2012

Xin-Bing Cheng ,
Jin-Liang Liu ,
Zhi-Qiang Hong  and
Bao-Liang Qian
Xin-Bing Cheng
Affiliation:
College of Opto-electronic Science and Engineering, National University of Defense Technology, Changsha, Hunan, Peoples Republic of China
Jin-Liang Liu*
Affiliation:
College of Opto-electronic Science and Engineering, National University of Defense Technology, Changsha, Hunan, Peoples Republic of China
Zhi-Qiang Hong
Affiliation:
College of Opto-electronic Science and Engineering, National University of Defense Technology, Changsha, Hunan, Peoples Republic of China
Bao-Liang Qian
Affiliation:
College of Opto-electronic Science and Engineering, National University of Defense Technology, Changsha, Hunan, Peoples Republic of China
*
Address correspondence and reprint requests to: Jin-Liang Liu, College of Opto-electronic Science and Engineering, National University of Defense Technology, Changsha, Hunan, 410073Peoples Republic of China. E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

As the development of the pulsed power technology, high voltage pulse transformer (HVPT) is usually used instead of Marx generator as a charging device for the pulse forming line (PFL) of intense electron-beam accelerator (IEBA), and which make the IEBA compact. However, during the operation of the IEBA, the HVPT may be destroyed for the failure of electrical insulation and the over-voltage. So in this paper, the output voltage characteristics of IEBA, characteristics of the voltage at the output terminal of HVPT at four kinds of load conditions are analyzed, including load matching, load short, load open, and surface flashover in the vacuum chamber. It is found that load short, load open, and surface flashover in vacuum chamber will affect the voltage at the output terminal of HVPT, and an oscillation wave could be formed, which affect the electrical insulation of HVPT and decrease the lifetime of HVPT. Meanwhile, the waveform of the load voltage is also modified, especially at the conditions of load open and surface flashover in vacuum chamber. When the load is open, the amplitude of the output main pulse of IEBA is twice the charging voltage of BPFL. However, the amplitude of the output pulse of IEBA is modified by the voltage at the output terminal of HVPT, and the resistance of main switch channel has a great effect on the amplitude of the load voltage. When surface flashover occurs in the vacuum chamber, the pulse duration of the output voltage will be decreased. So, during the operation of IEBA, load short, load open and surface flashover in vacuum chamber should be avoided.

Keywords

Blumlein pulse forming lineHigh voltage pulse transformerIntense electron-beam acceleratorLoadVoltage waveform
Type
Research Article
Information
Laser and Particle Beams , Volume 30 , Issue 4 , December 2012 , pp. 531 - 539
Copyright
Copyright © Cambridge University Press 2012

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Adler, R.J., Miller, R.B., Prestwich, K.R. & Smith, D.L. (1983). Radial isolated Blumlein electron beam generator. Rev.Sci. Instrum. 54, 940–945.CrossRefGoogle Scholar
Apruzese, J.P., Giuliani, J.L., Wolford, M.F., Sethian, J.D., Petrov, G.M., Hinshelwood, J.D., Myers, M.C. & Ponce, D.M. (2006). Experimental evidence for the role of Xe2+ pumping the Ar-Xe infrared laser. Appl. Phys. Lett. 88, 121120.CrossRefGoogle Scholar
Cheng, X.B., Liu, J.L., Zhang, Y., Qian, B.L. & Feng, J.H. (2009 a). Effect of transition section between Blumlein line and load on the output voltage of gigawatt intense electron-beam accelerators. Phys. Rev. ST Accel. Beams. 12, 110401.CrossRefGoogle Scholar
Cheng, X.B., Liu, J.L., Qian, B.L., Zhang, Y. & Zhang, H.B. (2009 b). Effect of the change in the load resistance on the high voltage pulse transformer of the intense electron-beam accelerators. Rev. Sci. Instrum. 80, 115110.CrossRefGoogle ScholarPubMed
Cheng, X.B., Liu, J.L., Zhang, H.B., Feng, J.H. & Qian, B.L. (2010). Improving the output voltage waveform of an intense electron-beam accelerator based on helical type Blumlein pulse forming line, Phys. Rev. ST Accel. Beams. 13, 070402.CrossRefGoogle Scholar
Cheng, X.B., Liu, J.L., Zhang, H.B., Hong, Z.Q. & Qian, B.L. (2011). Surface flashover phenomenon under 180-ns quasi-square wave with voltage of several hundred kilovolts. IEEE Trans. Plasma Sci. 39, 1868–1873.CrossRefGoogle Scholar
Clark, M.C., Mardar, B.M. & Bacon, L.D. (1988). Magnetically insulated transmission line oscillator. Appl. phys. Lett. 52, 78.CrossRefGoogle Scholar
Coogan, J.J., Davanloo, F. & Collins, C.B. (1990). Production of high-energy photons from flash X-ray sources powered by stacked Blumlein generators. Rev. Sci. Intrum. 61, 1448–1456.CrossRefGoogle Scholar
Friedman, S., Limpaecher, R. & Sirchis, M. (1988). Compact energy storage using a modified-spiral PFL. In Power Modulator Symposium. New York: IEEE.Google Scholar
Han, J., Kim, J.H., Park, S.D., Yoon, M. & Park, S.Y. (2009). Coaxial-type water load for measuring high voltage, high current and short pulse of a compact Marx system for a high power microwave source. Phys. Rev. ST Accel. Beams 12, 113501.CrossRefGoogle Scholar
He, J.T., Cao, Y.B., Zhang, J.D., Wang, T. & Ling, J.P. (2011). Design of a dual-frequency high-power microwave generator. Laser Part. Beams 29, 479–485.CrossRefGoogle Scholar
Katsuki, S., Takano, D., Namihira, T. & Akiyama, H. (2001). Repetitive operation of water-filled Blumlein generator. Rev. Sci. Intrum. 72, 2759–2763.CrossRefGoogle Scholar
Kumar, R., Novac, B.M., Sarkar, P., Simith, I.R. & Greenwood, C. (2008). 300 kV Tesla transformer based pulse forming line generator. Proceedings of the 2008 IEEE International Power Modulators and High Voltage Conference. Las Vegas, 246–249.CrossRefGoogle Scholar
Kuai, B., Wu, G., Qiu, A., Wang, L., Cong, P. & Wang, X. (2009). Soft X-ray emissions from neon gas-puff Z-pinch powered by Qiang Guang-I accelerator. Laser Part. Beams 27, 569–577.CrossRefGoogle Scholar
Korovin, S.D., Gubanov, V.P., Gunin, A.V., Pegel, I.V. & Stepchenko, A.S. (2001). Respective nanoseconds high-voltage generator based on spiral forming line. IEEE, Internat.Conf. Plasma Sci. 2, 1249–1251.Google Scholar
Liu, J.L., Zhan, T.W., Zhang, J., Liu, Z.X., Feng, J.H., Shu, T., Zhang, J.D. & Wang, X.X. (2007). A Tesla pulse transformer for spiral water pulse forming line charging. Laser Part. Beams 25, 305–312.CrossRefGoogle Scholar
Liu, J.L., Cheng, X.B., Qian, B.L., Ge, B., Zhang, J.D. & Wang, X.X. (2009). Study on strip spiral Blumlein line for the pulsed forming line of intense electron-beam accelerators. Laser Part. Beams 27, 95–102.CrossRefGoogle Scholar
Miller, R.B., Prestwich, K.R., Poukey, J.W., Epstein, B.G., Freeman, J.R., Sharpe, A.W., Tucker, W.K. & Shope, S.L. (1981). Multistage linear electron acceleration using pulsed transmission lines. J. Appl. Phys. 52, 1184–1186.CrossRefGoogle Scholar
Pai, S.T. & Zhang, Q. (1995). Introduction to high power pulse technology. Singapore: Uto-Print.CrossRefGoogle Scholar
Sethian, J.D., Myers, M., Smith, I.D., Carboni, V., Kishi, J., Morton, D., Pearce, J., Bowen, B., Schlitt, L., Barr, O. & Webster, W. (2000). Pulsed power for a rep-rate, electron beam pumped KrF laser, IEEE Trans. Plasma Sci. 28, 1333–1337.CrossRefGoogle Scholar
Suthar, J.L. & Laghari, J.R. (1991). Simulation of air ore pulse transformer. Proceedings of the 2008 Eighth IEEE International Pulsed Power Conference. California, 237–240.Google Scholar
Tarasenko, V.F., Shunailov, S.A., Shpak, V.G. & Kostyrya, I.D. (2005). Super short electron beam from air filled diode at atmospheric pressure. Laser Part. Beams 23, 545–551.CrossRefGoogle Scholar
Zhang, Y., Liu, J.L., Wang, S.W., Fan, X.L., Zhang, H.B. & Feng, J.H. (2011). Effects of dielectric discontinuity on the dispersion characteristics of the tape helix slow-wave structure with two metal shields. Laser Part. Beams 29, 459–469.CrossRefGoogle Scholar