Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-23T21:34:18.608Z Has data issue: false hasContentIssue false
  • English
  • Français

Current division between two paralleled X-pinches

Published online by Cambridge University Press:  15 July 2014

Shen Zhao ,
Xinlei Zhu ,
Ran Zhang ,
Haiyun Luo ,
Xiaobing Zou  and
Xinxin Wang
Shen Zhao
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
Xinlei Zhu
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
Ran Zhang
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
Haiyun Luo
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
Xiaobing Zou
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
Xinxin Wang*
Affiliation:
Department of Electrical Engineering, Tsinghua University, Beijing, China
*
Address correspondence and reprint requests to: Xinxin Wang, Department of Electrical Engineering, Tsinghua University, Beijing, China. E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

In order to use two paralleled X-pinches as X-ray sources for the time-resolved backlighting of wire-array Z-pinch plasma, it is necessary to make these two X-pinches emit X-rays at different but roughly preset time instants. The timing of the X-ray burst from an X-pinch independence of the current, and the wire mass of the X-pinch was investigated. The currents flowing through two paralleled X-pinches were measured and it was found that the total current is almost equally divided between these two X-pinches no matter how different the wires for these two X-pinches are. The reason for the equal current division between two paralleled X-pinches was given based on the inductance calculation of the X-pinch circuit.

Keywords

Timing of X-ray burstX-pinchX-ray backlightingZ-pinch
Type
Research Article
Information
Laser and Particle Beams , Volume 32 , Issue 3 , September 2014 , pp. 437 - 442
Copyright
Copyright © Cambridge University Press 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Deeney, C., Douglas, M.R., Spielman, R.B., Nash, T.J., Peterson, D.L., Eplattenier, P.L., Chandler, G.A., Seamen, J.F. & Struve, K.W. (1998). Enhancement of X-ray power from a z pinch using nested-wire Arrays. Phys. Rev. Lett. 81, 4883–4886.CrossRefGoogle Scholar
Douglass, J.D. & Hammer, D.A. (2008). COBRA-STAR, a five frame point-projection X-ray imaging system for 1 MA scale wire-array Z pinches. Rev. Sci. Instrum. 79, 033503.CrossRefGoogle ScholarPubMed
Grabovskii, E.V., Mitrofanov, K.N., Oleinik, G.M. & Porofeev, I.Yu. (2004). X-ray backlighting of the periphery of an imploding multiwire array in the Angara-5-1 facility. Plasma Phys. Rpts. 30, 121–127.CrossRefGoogle Scholar
Kalantar, D.H. & Hammer, D.A. (1995). The x-pinch as a point source of x rays for backlighting. Rev. Sci. Instrum. 66, 779–781.CrossRefGoogle Scholar
Lebedev, S.V., Beg, F.N., Bland, S.N., Chittenden, J.P., Dangor, A.E., Haines, M.G.., Zakaullah, M., Pikuz, S.A., Shelkovenko, T.A. & Hammer, D.A. (2001). X-ray backlighting of wire array Z-pinch implosions using X pinch. Rev. Sci. Instrum. 72, 671–673.CrossRefGoogle Scholar
Liu, R., Wang, X., Zou, X., Zeng, N., He, L. & Liu, X. (2007 a). Load section design of a pulsed power generator for X-pinch. IEEE Trans. Dielectr. Electr. Insul. 14, 889–893.Google Scholar
Liu, R., Wang, X., Zou, X., Yuan, J., Zeng, N. & He, L. (2007 b). Method for calibrating a Rogowski coil of fast time response. Rev. Sci. Instru. 78, 084702.CrossRefGoogle ScholarPubMed
Liu, R., Zou, X., Wang, X., He, L. & Zeng, N. (2008 a). X-pinch experiments with pulsed power generator (PPG-1) at Tsinghua University. Laser Part. Beams 26, 33–36.CrossRefGoogle Scholar
Liu, R., Zou, X., Wang, X., He, L. & Zeng, N. (2008 b). X-ray emission from an X-pinch and its applications. Laser Part. Beams 26, 455–460.CrossRefGoogle Scholar
Mesyats, G.A., Reutova, A.G., Sharypov, K.A., Shpak, V.G. & Shunailov, S.A. (2011). On the observed energy of runaway electron beams in air. Laser Part. Beams 29, 425–435.CrossRefGoogle Scholar
Ramirez, J.J. (1997). The X-1 Z-pinch driver. IEEE Trans. Plasma Sci. 25, 155–159.CrossRefGoogle Scholar
Shao, T., Tarasenko, V.F., Zhang, C., Baksht, E.K. & Yan, P. (2012). Repetitive nanosecond-pulse discharge in a highly nonuniform electric field in atmospheric air: X-ray emission and runaway electron generation. Laser Part. Beams 30, 369–378.CrossRefGoogle Scholar
Zhang, C., Tarasenko, V.F., Shao, T., Baksht, E.K. & Burachenko, A.G. (2013). Effect of cathode materials on the generation of runaway electron beams and X-rays in atmospheric pressure air. Laser Part. Beams 31, 353–364.CrossRefGoogle Scholar
Zhang, C., Tarasenko, V.F., Shao, T., Beloplotov, D.V. & Lomaev, M.I. (2014). Generation of super-short avalanche electron beams in SF6. Laser Part. Beams 32, 331–341.CrossRefGoogle Scholar
Zakharov, S.M., Ivanenkov, G.V., Kolomenskii, A.A., Pikuz, S.A., Samokhin, A.I. & Ulshmid, I. (1982). Wire X-pinch in a high-current diode. Sov. Tech. Phys. Lett. 8, 456–457.Google Scholar
Zhao, T., Zou, X., Wang, X., Zhao, Y., Du, Y., Zhang, R. & Liu, R. (2010). X-ray backlighting of developments of X-pinches and wire-array Z-pinches using an X-pinch. IEEE Trans. Plasma Sci. 38, 646–651.CrossRefGoogle Scholar
Zou, X., Liu, R., Zeng, N., Han, M., Yuan, J., Wang, X., Zhang, G. (2006). “A pulsed power generator for x-pinch experiments” Laser and Particle Beams, 24, 503–509.CrossRefGoogle Scholar