Autonomous vehicles with an ability to trace chemical plumes can be instrumental in tasks such as detection of unexploded ordnance, search for undersea wreckage and environmental monitoring. As a consequence, use of autonomous vehicles to perform chemical plume tracing has received an increasing interest from the research community in recent years. Owing to the diversity of applications and ambient fluid environment of the plumes, there are numerous plume tracing strategies and approaches. This paper reviews two main approaches and a number of strategies that have been successfully implemented to track air or water borne plumes in order to locate odour sources using autonomous vehicles. The first strategy considered is the biomimetic approach that offers excellent models for the development of robotic systems. Strategies inspired by lobsters and bacterium are the main focus in this study. The second scheme considers parallelization of the search procedure by employing a multi-robot approach. This approach has the advantage of utilising a group of smaller and simpler communicating robots which are capable of performing a collaborative search of the plume.

GPS receivers have been used successfully on low Earth orbit (LEO) satellite missions for several years. The use of a GPS receiver at altitudes higher than LEO, however, is non-trivial as the receiver will be outside the main lobe of the GPS broadcast signals, and it will have to track signals from GPS satellites transmitting from the other side of the Earth. This paper will review the special hardware and software adaptations required for GPS receiver operations on a medium Earth orbit or geostationary satellite, along with preliminary results from simulations and an in-orbit experiment.

A version of this paper was first presented at the European Navigation Conference 2006, held under the auspices of the RIN at Manchester on 8–10 May 2006.

AIS is the most recent example of a major globally-introduced maritime navigation system. During its evolution, introduction and early in-service life, it has aroused a lot of negative comment. The basis for this negativity is examined, particularly in the light of the real experience that is now being gained by users of the system. The evolution of the AIS concept through the relevant international bodies – IMO, ITU, IALA and IEC – is discussed, together with the type of problems encountered during its introduction. Many of the problems would have been ameliorated if there had been better communication to users of the system. It is argued that the complexity of the system really required mandatory training to be undertaken, in parallel with the installation of the new equipment.

Integrated electronic marine systems have been put forward as one way of reducing information overload for officers of the watch and other personnel who work on ships' bridges or in fishing wheelhouses. It may be that such systems will improve safety records which, in the case of fishing, are amongst the worst in the world. This article builds on previous work about issues for the systems designer by using a small study of fishing skippers to ascertain their perceptions of using integrated electronic systems in the wheelhouse. Semi-structured interviews were used with 11 skippers from one port who were all familiar with integrated electronic marine systems but did not use them on their vessels. The main reasons for this were a perception of unreliability of both the hardware and the software, together with concerns about data integrity and user control.

This paper discusses the preliminary performance analysis result of the Asia-Pacific Global Navigation Satellite Systems (GNSS) Test Bed. Currently, seven Asia-Pacific economies are participating in the Test Bed project, namely Australia, Chinese Taipei, Indonesia, Malaysia, the Philippines, Thailand and Vietnam. The Test Bed was commissioned in May 2006. The discussion topics in this paper include Test Bed system architecture and preliminary analysis of the system performance. As presented in this paper, while current Satellite-Based Augmentation System (SBAS) algorithms can improve the accuracy performance of GPS positioning results, it cannot fulfill the integrity performance required by civil aviation community. This paper analyzes the limitation of the algorithm and proposes future research topics related to the limitation.

A version of this paper was first presented at the European Navigation Conference 2006, held under the auspices of the RIN at Manchester on 8–10 May 2006.

This paper reviews the need for the GLAs to develop a strategy for the integration of radionavigation services around the British Isles. After investigating the recent trends and forecasts for shipping and with a view towards the need for e-Navigation, the strategy formation process and initial findings for the development of a radionavigation plan are outlined.

This paper describes the air navigation techniques and drills used by Lancasters of the Pathfinder Force of Royal Air Force Bomber Command in early 1945. A brief description is given of the equipment and fixing aids available to the navigator and the environment in which he worked. The paper is based on the author's personal experience and with reference to the log and chart of an operation in which he took part. A running commentary on the navigational aspects of the operation is also given.

Currently Vessel Traffic Service (VTS) does not have enough technical capability to monitor a crowded surveillance area to maintain safety. Without an efficient alerting system, many marine accidents have occurred due to operator oversight. In this article, a new fuzzy logic method is proposed to add vessel collision avoidance capability to VTS/AIS systems for all potential collision ships in the surveillance area. Starting from the VTS standpoint and integrating AIS data into the Marine Geographic Information System (MGIS) as a platform, the calculations of ship domain and ship inertial force are utilized to generate models of a guarding ring and danger index. By this means, a precise prediction of collision time and position can be achieved using a marine GIS spatial analyst module. The proposed method is able to enhance the VTS operator's decision-making abilities by providing a collision avoidance alerting system.

This paper examines the recent introduction of the AIS to the ship's bridge and its potential impact on the safety of marine navigation. Research has shown that 80 to 85% of all recorded maritime accidents are directly due to human error or associated with human error. Safety is an important element of marine navigation and many people at different levels are involved in its management. The safe and efficient performance of joint systems, is heavily dependent upon how functions are allocated between the human and the machine. This paper investigates different regulations, supervision for proper use, training, and management of AIS users. It uses previous research and three separate AIS studies to identify problems. The potential of the AIS to cause problems is analysed. The classic human factor “Swiss Cheese” Model of system failure has been modified for the AIS to investigate a possible accident trajectory. The paper then concludes with recommendations and suggestions for improvements and further work.

The dynamic precise orbit determination of a Low Earth Orbit satellite using triple differenced GPS phases is presented in this study. The atmospheric drag parameters are estimated to compensate the incomplete atmosphere model for better precision of the orbit solution. In addition, the empirical force parameters, especially once- and twice-per-revolution components, along with the new IERS Conventions and models to compute the perturbing forces are introduced to absorb the remaining unmodelled forces. The optimal arc length for the parameterization and the data processing strategy are also tested and analyzed for the best orbit solutions. The triple differencing technique enables fast and efficient orbit estimation, because no ambiguity resolution and cycle slip detection are required. With the triple differenced ion-free GPS phase observables, the orbit and the velocity solutions for 24 hours of CHAMP are calculated; they compare with the published Rapid Science Orbit with the accuracy of 8 cm and 0·12 mm/s in 3D RMS for the orbit and the velocity, respectively, and are statistically consistent with the RSO when it is not better than 4 cm in terms of an absolute accuracy. The approach presented here provides an efficient and simple, but robust, alternative approach, while the solution's accuracy is still comparable to the double-difference results.

This paper introduces a “Personal Dead-reckoning” (PDR) navigation system for walking persons. The system is useful for monitoring the position of emergency responders inside buildings, where GPS is unavailable. The PDR system uses a six-axes Inertial Measurement Unit attached to the user's boot. The system's strength lies in the use of a technique known as Zero Velocity Update (ZUPT) that virtually eliminates the ill-effects of drift in the accelerometers. It works very well with different gaits, as well as on stairs, slopes, and generally on 3-dimensional terrain. The paper explains the PDR and presents extensive experimental results, which illustrate the utility and practicality of the system. Parts of this paper were presented at the 2006 International Joint Topical Meeting: “Sharing Solutions for Emergencies and Hazardous Environments,” February 12–15, 2006, Salt Lake City, Utah, USA.

Using GPS for animal tracking applications presents many significant challenges; not least the integration of the antenna in what is usually a miniature device. This paper describes a test setup that has been constructed to allow the user to perform something close to a full antenna gain pattern test using a simple turntable and relying on the GPS satellite motion to collect all angles required for a 3D gain plot. This has proved invaluable when predicting the expected performance of various antenna/packaging options for animal tags.

European Air Traffic Management is extremely safe. The drawback to this safety record is that it is very difficult to estimate what the ‘underlying’ accident rate for mid-air collisions is now, or to detect any changes over time. The aim is to see if it possible to construct simple ATM safety indicators that correlate with this underlying accident rate. A perfect indicator would be simple to comprehend and capable of being calculated by a checklist process. This problem has been examined using a combination of analogies with simple ‘defensive’ systems with Markov process properties. An important concept is that of ‘system control’: the ability to determine the outcome against reasonably foreseen changes and variations of system parameters. The statistical distribution of future incidents has been analysed by focusing on an index – the Close Proximity Index (CPI) – of separation at the Closest Point of Approach. A promising indicator is ‘Incident Not Resolved by ATC’ (INRA) incidents in which the ground ATC defences have been ‘used up’. ATM Incidents can also be categorised in other ways. Two examples are reviewed: the risk-bearing category for Airproxes and ‘risk of collision/severity’ scores. The second is more promising conceptually, but the existing scoring system has not been demonstrated to have the properties necessary to derive risk estimates. The key question is: if someone says they know how to make a good estimate of the underlying accident rate, then how could this claim be tested? If it correlates very well with INRA, then what would be the argument for saying that it is a better indicator?

The aim of the SPACE project is to develop a mobile test bed that can position to within centimetres in all conditions and environments. To achieve this goal, a number of different positioning technologies have to be integrated together including GNSS, INS, pseudolites and other technologies such as Ultra Wideband and Bluetooth ranging. The integration of these sensors is achieved by the development of a ‘plug and play’ filter that will optimally combine measurements from each sensor to form an accurate position solution. The filter has been designed so that the sensors are integrated at the measurement level wherever possible, so partial measurements from different systems can be used together.

This paper describes the development of the plug and play filter, focussing in particular on how the states are defined, how the measurements are used, and how a generic filter can be developed that can integrate all types of positioning sensor. Some early results from the filter are shown integrating GPS, INS and simulated measurements from an Ultra Wideband system. A prototype version of the mobile test bed is also described.

Recent navigation systems integrating GPS with Micro-Electro-Mechanical Systems (MEMS) Inertial Measuring Units (IMUs) have shown promising results for several applications based on low-cost devices such as vehicular and personal navigation. However, as a trend in the navigation market, some applications require further reductions in size and cost. To meet such requirements, a MEMS full IMU configuration (three gyros and three accelerometers) may be simplified. In this context, different partial IMU configurations such as one gyro plus three accelerometers or one gyro plus two accelerometers could be investigated. The main challenge in this case is to develop a specific navigation algorithm for each configuration since this is a time-consuming and costly task. In this paper, a universal approach for processing any MEMS sensor configuration for land vehicular navigation is introduced. The proposed method is based on the assumption that the omitted sensors provide relatively less navigation information and hence, their output can be replaced by pseudo constant signals plus noise. Using standard IMU/GPS navigation algorithms, signals from existing sensors and pseudo signals for the omitted sensors are processed as a full IMU. The proposed approach is tested using land-vehicle MEMS/GPS data and implemented with different sensor configurations. Compared to the full IMU case, the results indicate the differences are within the expected levels and that the accuracy obtained meets the requirements of several land-vehicle applications.

Satellite based navigation system integrity monitoring is essential both for liability and safety critical services. The threats to system integrity are the potential failure modes that could occur at system, operational and user sensor levels. Research on identification, characterisation and modelling of such failure modes, suggests that failures that grow slowly over time (e.g. ramp error less than 2 m/s), also referred to as slowly growing errors (SGE) are the most difficult to detect early. Conventional snapshot algorithms detect SGEs when the test statistic crosses the threshold usually after relatively long periods of time. A recent concept based on the average of residuals over time has been found to have a significant weakness. This paper proposes a “difference test” algorithm capable of detecting SGEs early. In this method, the test statistic is the difference between the norm of current residuals and the norm of the residuals at a previous epoch. The distribution of the test statistic is over-bounded by a normal distribution whose parameters are derived from two Chi-distributions. Results show that the new algorithm results in a significant reduction in detection time compared to conventional methods.

Ionospheric plasma irregularities or bubbles, that are regions with depleted density, are generated at the magnetic equator after sunset due to plasma instabilities, and as they move upward they map along the magnetic field lines to low latitudes. To analyse the temporal and spatial evolution of the bubbles over Brazilian territory, the mapping of ionospheric plasma bubbles for the night of 17/18 March 2002 was generated using data collected from one GPS receiver array, and applying interpolation techniques. The impact on the performance of Global Navigation Satellites System (GNSS) and on the Space Based Augmentation System (SBAS) in the tropical regions of the GPS signal losses of lock and of the signal amplitude fades during ionospheric irregularities is presented.

Traditionally, GNSS receiver autonomous integrity monitoring (RAIM) has been based upon single epoch solutions. RAIM can be improved considerably when available dynamic information is fused together with the GNSS range measurements in a Kalman filter. However, while the Kalman filtering technique is widely accepted to provide optimal estimates for the navigation parameters of a dynamic platform, assuming the state and observation models are correct, it is still susceptible to unmodelled errors. Furthermore, significant deviations from the assumed models for dynamic systems may also occur. It is therefore necessary that the state estimation procedure is complemented with effective and reliable integrity measures capable of identifying both measurement and modelling errors. Within this paper, fundamental equations required for the effective detection and identification of outliers in a kinematic GNSS positioning and navigation system are described together with the reliability and separability measures. These quality measures are implemented using a Kalman filtering procedure formulated with Gauss-Markov models where the state estimates are derived from least squares principles. Detailed simulations and analyses have been performed to assess the impact of the dynamic information on GNSS RAIM with respect to outlier detection and identification, reliability and separability. The ability of the RAIM algorithms to detect and identify dynamic modelling errors is also investigated.

For certain applications such as E911/E999/E112, GPS chipset receiver manufacturers will possibly have to test their products to ensure these fulfill mandated performance specifications for a variety of outdoor and indoor conditions. As opposed to testing in the field, laboratory testing is totally repeatable and controllable, and may be less costly. Hardware GPS signal simulators are now able to simulate signals under a variety of attenuation and multipath conditions. In indoor environments, GPS signals suffer not only from severe attenuation and multipath but from complex variations thereof. A method to simulate indoor GPS signals such that the stochastic characteristics of the simulated signals match those of actual GPS signals received in situ by a high sensitivity GPS receiver in various indoor environments is presented. Probability density functions and correlation coefficients are used to demonstrate the similarity between field and simulated data in terms of signal power fading and estimated pseudorange error. The results clearly demonstrate the feasibility of the approach.

The rapid development of positioning technology, wireless communication and mobile devices has given rise to the exciting Location Based Services (LBS) thus significantly influencing existing navigational procedures. Motivated by the increasing need to search efficiently through a huge number of service locations (e.g. restaurants, hotels, shops, and more), this paper presents an efficient spatial index QR-tree, a hybrid index structure of Quadtree and R-tree, instead of the exhaustive search to improve the performance in response to user queries. QR-tree consists of two levels: the upper level is a Quadtree residing in the main memory which partitions the data space and the lower level is disk-resident R-trees assigned to the subspaces resulting from the partitioning process. Computational experiments show that the hybrid index structure is able to reduce query response time by up to 30% and achieve significant improvement on data update over the conventional indexing methods, thereby providing an effective option for efficient navigation services.