Hostname: page-component-cd9895bd7-gbm5v Total loading time: 0 Render date: 2024-12-19T11:09:17.008Z Has data issue: false hasContentIssue false
  • English
  • Français

Preparation of PVP-coated copper oxide nanosheets as antibacterial and antifungal agents

Published online by Cambridge University Press:  11 November 2013

Mahdi Shahmiri ,
Nor Azowa Ibrahim ,
Fatemeh Shayesteh ,
Nilofar Asim  and
Nabi Motallebi
Mahdi Shahmiri
Affiliation:
Department of Chemistry, Faculty of Science, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia
Nor Azowa Ibrahim*
Affiliation:
Department of Chemistry, Faculty of Science, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia
Fatemeh Shayesteh
Affiliation:
School of Environmental Science and Natural Resources, Faculty of science and technology, University Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia
Nilofar Asim
Affiliation:
Solar Energy Research Institute, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia
Nabi Motallebi
Affiliation:
ACECR (Academic Center for Education, Culture and Research), 14155-4364 Tehran, Iran
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Copper oxide (CuO) nanosheets synthesized in polyvinylpyrrolidone (PVP) were characterized with respect to antimicrobial activity by quick precipitation method. Different sizes and shapes of CuO nanosheets were obtained by simple variations of PVP concentrations. The x-ray diffraction results revealed the formation of pure-phase CuO with monoclinic structure. Transmission electron microscopy analysis showed that the average ratio of length to width of these nanosheets increased with increasing PVP concentrations. Due to the quantum size effect, CuO nanosheets exhibit a blue shift in the ultraviolet-visible spectra. Field emission scanning electron microscopy results showed that as the concentration of PVP increased, well-defined morphologies were formed on the surface of the products. Energy dispersive analysis of x-ray clearly confirmed the presence of Cu and O with an atomic ratio of 1:1. Fourier transform infrared spectroscopy results showed that C=O in PVP coordinated with CuO and formed a protective layer. The mechanism of the reaction was also discussed. CuO nanosheets in suspension showed activity against a range of bacterial pathogens and fungi with minimum bactericidal concentrations (MBCs) ranging from 100 to 5000 µg/mL. The extent of the inhibition zones and the MBCs was found to be size-dependent.

Keywords

CuOquick precipitation methodnanosheetsantibacterial activitypolyvinylpyrrolidonecopper oxide
Type
Articles
Information
Journal of Materials Research , Volume 28 , Issue 22 , 28 November 2013 , pp. 3109 - 3118
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Matijevi, E.: Fine Particles in Medicine and Pharmacy (Springer, New York, 2011).Google Scholar
Morones, J.R., Elechiguerra, J.L., Camacho, A., Holt, K., Kouri, J.B., RamÃrez, J.T., and Yacaman, M.J.: The bactericidal effect of silver nanoparticles. Nanotechnology 16, 2346–2353 (2005).CrossRefGoogle ScholarPubMed
Xie, L., Chu, W., Sun, J., Wu, P., and Tong, D.: Synthesis of copper oxide vegetable sponges and their antibacterial, electrochemical and photocatalytic performance. J. Mater. Sci. 46, 2179–2184 (2011).CrossRefGoogle Scholar
Jadhav, S., Gaikwad, S., Nimse, M., and Rajbhoj, A.: Copper oxide nanoparticles: Synthesis, characterization and their antibacterial activity. J. Cluster Sci. 22, 121–129 (2011).CrossRefGoogle Scholar
Yates, H., Brook, L., Ditta, I., Evans, P., Foster, H., Sheel, D., and Steele, A.: Photo-induced self-cleaning and biocidal behaviour of titania and copper oxide multilayers. J. Photochem. Photobiol., A 197, 197–205 (2008).CrossRefGoogle Scholar
Wang, X., Hu, C., Liu, H., Du, G., He, X., and Xi, Y.: Synthesis of CuO nanostructures and their application for nonenzymatic glucose sensing. Sens. Actuators, B 144, 220–225 (2010).CrossRefGoogle Scholar
Huang, T.J. and Tsai, D.H.: CO oxidation behavior of copper and copper oxides. Catal. Lett. 87, 173–178 (2003).CrossRefGoogle Scholar
Zou, H.B., Chen, S.Z., Liu, Z.L., and Lin, W.M.: Selective CO oxidation over CuO-CeO2 catalysts doped with transition metal oxides. Powder Technol. 207, 238–244 (2011).CrossRefGoogle Scholar
Wang, H., Pan, Q., Zhao, J., and Chen, W.: Fabrication of CuO/C films with sisal-like hierarchical microstructures and its application in lithium ion batteries. J. Alloys Compd. 476, 408–413 (2009).CrossRefGoogle Scholar
Liu, Y., Zhong, L., Peng, Z., Song, Y., and Chen, W.: Field emission properties of one-dimensional single CuO nanoneedle by in situ microscopy. J. Mater. Sci. 45, 3791–3796 (2010).Google Scholar
He, L., Jia, Y., Meng, F., Li, M., and Liu, J.: Development of sensors based on CuO-doped SnO2 hollow spheres for ppb level H2S gas sensing. J. Mater. Sci. 44, 4326–4333 (2009).CrossRefGoogle Scholar
Zhang, H. and Zhang, M.: Synthesis of CuO nanocrystalline and their application as electrode materials for capacitors. Mater. Chem. Phys. 108, 184–187 (2008).CrossRefGoogle Scholar
Han, D.Y., Yang, H.Y., Zhu, C.Y., and Wang, F.H.: Controlled synthesis of CuO nanoparticles using TritonX-100-based water-in-oil reverse micelles. Powder Technol. 185, 286–290 (2008).CrossRefGoogle Scholar
Dar, M.A., Kim, Y.S., Kim, W.B., Sohn, J.M., and Shin, H.S.: Structural and magnetic properties of CuO nanoneedles synthesized by hydrothermal method. Appl. Surf. Sci. 254, 7477–7481 (2008).CrossRefGoogle Scholar
Kaur, M., Muthe, K., Despande, S., Choudhury, S., Singh, J., Verma, N., Gupta, S., and Yakhmi, J.: Growth and branching of CuO nanowires by thermal oxidation of copper. J. Cryst. Growth 289, 670–675 (2006).CrossRefGoogle Scholar
Zhu, H.T., Zhang, C.Y., Tang, Y.M., and Wang, J.X.: Novel synthesis and thermal conductivity of CuO nanofluid. J. Phys. Chem. C 111, 1646–1650 (2007).CrossRefGoogle Scholar
Zhu, J., Li, D., Chen, H., Yang, X., Lu, L., and Wang, X.: Highly dispersed CuO nanoparticles prepared by a novel quick-precipitation method. Mater. Lett. 58, 3324–3327 (2007).CrossRefGoogle Scholar
Ren, G., Hu, D., Cheng, E.W.C., Vargas-Reus, M.A., Reip, P., and Allaker, R.P.: Characterisation of copper oxide nanoparticles for antimicrobial applications. Int. J. Antimicrob. Agents 33, 587–590 (2009).CrossRefGoogle ScholarPubMed
Seil, J.T. and Webster, T.J.: Antibacterial effect of zinc oxide nanoparticles combined with ultrasound. Nanotechnology 23, 495101 (2012).CrossRefGoogle ScholarPubMed
Zhang, W., Shi, X., Huang, J., Zhang, Y., Wu, Z., and Xian, Y.: Bacitracina-conjugated superparamagnetic iron oxide nanoparticles: Synthesis, characterization and antibacterial activity. ChemPhysChem 13, 3388–3396 (2012).CrossRefGoogle ScholarPubMed
Bauer, A., Kirby, W., Sherris, J.C., and Turck, M.: Antibiotic susceptibility testing by a standardized single disk method. Am. J. Clin. Pathol. 45, 493 (1966).CrossRefGoogle ScholarPubMed
Wang, X., Gao, Q., Wu, C., Hu, J., and Ruan, M.: Preparation, channel surface hydroxyl characterization and photoluminescence properties of nanoporous nickel phosphate VSB-1. Microporous Mesoporous Mater. 85, 355–364 (2005).CrossRefGoogle Scholar
Chen, X., Cui, H., Liu, P., and Yang, G.: Shape-induced ultraviolet absorption of CuO shuttlelike nanoparticles. Appl. Phys. Lett. 90, 183118–183118-3 (2007).CrossRefGoogle Scholar
Wang, H., Qiao, X., Chen, J., Wang, X., and Ding, S.: Mechanisms of PVP in the preparation of silver nanoparticles. Mater. Chem. Phys. 94, 449–453 (2005).CrossRefGoogle Scholar
Tu, W., Zuo, X., and Liu, H.: Study on the interaction between polyvinylpyrrolidone and platinum metals during the formation of the colloidal metal nanoparticles. Chin. J. Polym. Sci. 26, 23–29 (2008).CrossRefGoogle Scholar
Rao, C.N.R.: Chemical Applications of Infrared Spectroscopy (Academic Press, New York, 1963).Google Scholar
Soltani, N., Saion, E., Erfani, M., Rezaee, K., Bahmanrokh, G., Drummen, G.P., Bahrami, A., and Hussein, M.Z.: Influence of the polyvinyl pyrrolidone concentration on particle size and dispersion of ZnS nanoparticles synthesized by microwave irradiation. Int. J. Mol. Sci. 13, 12412–12427 (2012).CrossRefGoogle Scholar
Oskam, G.: Metal oxide nanoparticles: synthesis, characterization and application. J. Sol-Gel Sci. Technol. 37, 161–164 (2006).CrossRefGoogle Scholar
Rodriguez-Clemente, R., Serna, C.J., Ocana, M., and MatijeviÄ, E.: The relationship of particle morphology and structure of basic copper (II) compounds obtained by homogeneous precipitation. J. Cryst. Growth 143, 277–286 (1994).CrossRefGoogle Scholar
Wu, R., Ma, Z., Gu, Z., and Yang, Y.: Preparation and characterization of CuO nanoparticles with different morphology through a simple quick-precipitation method in DMAC–water mixed solvent. J. Alloys Compd. 504, 45–49 (2010).CrossRefGoogle Scholar
Zhang, H. and Cui, Z.: Solution-phase synthesis of smaller cuprous oxide nanocubes. Mater. Res. Bull. 43, 1583–1589 (2008).CrossRefGoogle Scholar
Azam, A., Ahmed, A.S., Oves, M., Khan, M., and Memic, A.: Size-dependent antimicrobial properties of CuO nanoparticles against Gram-positive and -negative bacterial strains. Int. J. Nanomed. 2012, 3527–3535 (2012).CrossRefGoogle Scholar
Kim, J.S., Kuk, E., Yu, K.N., Kim, J.H., Park, S.J., Lee, H.J., Kim, S.H., Park, Y.K., Park, Y.H., and Hwang, C.Y.: Antimicrobial effects of silver nanoparticles. Nanomed. Nanotechnol. Biol. Med. 3, 95–101 (2007).CrossRefGoogle ScholarPubMed
Ruparelia, J.P., Chatterjee, A.K., Duttagupta, S.P., and Mukherji, S.: Strain specificity in antimicrobial activity of silver and copper nanoparticles. Acta Biomater. 4, 707–716 (2008).CrossRefGoogle ScholarPubMed