Hostname: page-component-cd9895bd7-q99xh Total loading time: 0 Render date: 2024-12-18T13:24:05.510Z Has data issue: false hasContentIssue false
  • English
  • Français

Novel proton conductive hybrid membranes based on sulfonated polysulfone and benzotriazole

Published online by Cambridge University Press:  06 August 2012

Irfan Gustian ,
Sevim Ünügür Çelik  and
Ayhan Bozkurt
Irfan Gustian
Affiliation:
Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Bengkulu, 38371 Jl. Raya Kandang Limun-Bengkulu, Indonesia
Sevim Ünügür Çelik*
Affiliation:
Department of Chemistry, Fatih University, 34500 Büyükçekmece-Istanbul, Turkey
Ayhan Bozkurt
Affiliation:
Department of Chemistry, Fatih University, 34500 Büyükçekmece-Istanbul, Turkey
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

As anhydrous proton conductive membranes, sulfonated polysulfone (SPSU) and 1H-1,2,3-benzotriazole (BTri) hybrid membranes were prepared. The sulfonation of polysulfone was performed with trimethylsilyl chlorosulfonate, and high degree of sulfonation (134%) was obtained. The polymer electrolyte membranes, SPSU–BTriX, were prepared by blending of 1H-1,2,3-benzotriazole in SPSU. FTIR confirmed the sulfonation of PSU and the ionic interaction between sulfonic acid and benzotriazole units. Thermogravimetric analysis (TGA) analysis showed that the polymer electrolyte membranes are thermally stable up to approximately 200 °C. Scanning electron microscopy analysis indicated the homogeneity of the membranes. The maximum proton conductivity has been measured for SPSU–BTri2 as 3.6 × 10−3S/cm at 150 °C.

Keywords

sulfonated polysulfone1H-benzotriazolepolymer electrolyte membraneproton conductivity
Type
Articles
Information
Journal of Materials Research , Volume 27 , Issue 20 , 28 October 2012 , pp. 2650 - 2656
Copyright
Copyright © Materials Research Society 2012

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Çelik, S.Ü. and Bozkurt, A.: Proton conduction promoted by 1H-1,2,3-benzotriazole in non-humidified polymer membranes. Electrochim. Acta 56, 5961 (2011).CrossRefGoogle Scholar
Celik, S.Ü., Bozkurt, A., and Hosseini, S.S.: Alternatives toward proton conductive anhydrous membranes for fuel cells: Heterocyclic protogenic solvents comprising polymer electrolytes. Prog. Polym. Sci. (2012, in press).http://dx.doi.org/10.1016/j.progpolymsci.2011.11.006.Google Scholar
Yamada, M. and Honma, I.: Anhydrous proton conducting polymer electrolytes based on poly(vinylphosphonic acid)-heterocycle composite material. Polymer 46, 2986 (2005).CrossRefGoogle Scholar
Göktepe, F., Bozkurt, A., and Günday, Ş.T.: Synthesis and proton conductivity of poly(styrene sulfonic acid)/heterocycle-based membranes. Polym. Int. 57, 133 (2008).CrossRefGoogle Scholar
Günday, S.T., Bozkurt, A., Meyer, W.H., and Wegner, G.: Effects of different acid functional groups on proton conductivity of polymer-1,2,4-triazole blends. J. Polym. Sci., Part B: Polym. Phys. 44, 3315 (2006).CrossRefGoogle Scholar
Sen, U., Çelik, S.Ü., Ata, A., and Bozkurt, A.: Anhydrous proton conducting membranes for PEM fuel cells based on nafion/azole composites. Int. J. Hydrogen Energy 33, 2808 (2008).CrossRefGoogle Scholar
Kim, J.D., Mori, T., Hayashi, S., and Honma, I.: Anhydrous proton-conducting properties of nafion–1,2,4-triazole and nafion–benzimidazole membranes for polymer electrolyte fuel cells. J. Electrochem. Soc. 154, A290 (2007).CrossRefGoogle Scholar
Boroglu, M.S., Celik, S.U., Bozkurt, A., and Boz, I.: The synthesis and characterization of anhydrous proton conducting membranes based on sulfonated poly(vinyl alcohol) and imidazole. J. Membr. Sci. 375, 157 (2011).CrossRefGoogle Scholar
Katritzky, A.R., Rachwal, S., and Hitchings, G.J.: Benzotriazole: A novel synthetic auxiliary. Tetrahedron 16–17, 2683 (1991).CrossRefGoogle Scholar
Lufrano, F., Gatto, I., Staiti, P., Antonucci, V., and Passalacqua, E.: Sulfonated polysulfone ionomer membranes for fuel cells. Solid State Ionics 145, 47 (2001).CrossRefGoogle Scholar
Lufrano, F., Baglio, V., and Staiti, P.: Development and characterization of sulfonated polysulfone membranes for direct methanol fuel cells. Desalination 199, 283 (2006).CrossRefGoogle Scholar
Chen, S.L., Bocarsly, A.B., and Benziger, J.: Nafion-layered sulfonated polysulfone fuel cell membranes. J. Power Sources 152, 27 (2005).CrossRefGoogle Scholar
Smitha, B., Devi, D.A., and Sridhar, S.: Proton-conducting composite membranes of chitosan and sulfonated polysulfone for fuel cell application. Int. J. Hydrogen Energy 33, 4138 (2008).CrossRefGoogle Scholar
Li, S., Zhou, Z., Zhang, Y., and Liu, M.: 1H-1,2,4-Triazole: An effective solvent for proton-conducting electrolytes. Chem. Mater. 17, 5884 (2005).CrossRefGoogle Scholar
Fu, Y., Li, W., and Manthiram, A.: Sulfonated polysulfone with 1,3–1H-dibenzimidazole-benzene additive as a membrane for direct methanol fuel cells. J. Membr. Sci. 310, 262 (2008).CrossRefGoogle Scholar
Coates, J.: Interpretation of infrared spectra, a practical approach, in Encyclopedia of Analytical Chemistry, edited by Meyers, R.A. (John Wiley and Sons Ltd., Chichester, UK, 2000); pp. 10815–10837.Google Scholar
Lufrano, F., Baglio, V., Staiti, P., Arico, A.S., and Antonucci, V.: Polymer electrolytes based on sulfonated polysulfone for direct methanol fuel cells. J. Power Sources 179, 34 (2008).CrossRefGoogle Scholar
Park, H.B., Shin, H-S., Lee, Y.M., and Rhim, J-W.: Annealing effect of sulfonated polysulfone ionomer membranes on proton conductivity and methanol transport. J. Membr. Sci. 247, 103 (2005).CrossRefGoogle Scholar