Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-30T22:00:56.841Z Has data issue: false hasContentIssue false
  • English
  • Français

Mechanisms of Ti nanocluster formation by inert gas condensation

Published online by Cambridge University Press:  25 September 2013

Ahmad I. Ayesh ,
Haya A. Ahmed ,
Falah Awwad ,
Samir I. Abu-Eishah  and
Saleh T. Mahmood
Ahmad I. Ayesh*
Affiliation:
Department of Physics, United Arab Emirates University, Al Ain, United Arab Emirates
Haya A. Ahmed
Affiliation:
Department of Chemical and Petroleum Engineering, United Arab Emirates University, Al Ain, United Arab Emirates
Falah Awwad
Affiliation:
Department of Electrical Engineering, United Arab Emirates University, Al Ain, United Arab Emirates
Samir I. Abu-Eishah
Affiliation:
Department of Chemical and Petroleum Engineering, United Arab Emirates University, Al Ain, United Arab Emirates
Saleh T. Mahmood
Affiliation:
Department of Physics, United Arab Emirates University, Al Ain, United Arab Emirates
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The mechanisms involved in the formation of titanium (Ti) nanoclusters produced by sputtering and inert gas condensation were investigated experimentally and numerically. Ti nanoclusters were generated inside an ultrahigh vacuum compatible system under different source parameters, i.e., inert gas flow rate (fAr), length of the aggregation region (L), and sputtering discharge power (P). Nanocluster size and yield were measured using a quadrupole mass filter (QMF). The variation of the above source parameters enabled fine-tuning of the nanocluster size and yield. Herein, Ti nanoclusters were produced within the size range 3.0–10.0 nm. The combination between the nanocluster size and yield as a function of source parameters enabled understanding Ti nanocluster formation mechanisms, i.e., three-body and two-body collisions. The results show that two-body collisions dominate nanocluster production at low fAr while the three-body collisions dominate at high fAr. In addition, nanocluster size increases as L increases due to the increase in nanocluster nucleation and growth times. The maximum nanocluster yield was obtained at fAr that maximize the probability of three-body and two-body collisions. Nanoclusters could be produced within an optimum range of the sputtering discharge power wherein the nanocluster size and yield increase with increasing the discharge power as a result of increasing the amount of sputtered material. The experimental results were compared with a theoretical model of nanocluster formation via three-body collision. Detailed understanding of the evolution of size and yield of Ti (and Ti-oxide) nanoclusters is essential for producing nanoclusters that can be utilized for environmental applications such as conversion of carbon dioxide and water vapor into hydrocarbons.

Keywords

nanoscalenanostructuresputtering
Type
Articles
Information
Journal of Materials Research , Volume 28 , Issue 18 , 28 September 2013 , pp. 2622 - 2628
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Yamamuro, S., Sumiyama, K., Sakurai, W., and Suzuki, K.: Cr cluster deposition by plasma-gas-condensation method. Supramol. Sci. 5, 239 (1998).CrossRefGoogle Scholar
Ayesh, A.I., Qamhieh, N., Ghamlouche, H., Thaker, S., and EL-Shaer, M.: Fabrication of size-selected Pd nanoclusters using a magnetron plasma sputtering source, J. Appl. Phys. 107, 034317 (2010).CrossRefGoogle Scholar
Ayesh, A.I.: Electronic transport in Pd nanocluster devices, Appl. Phys. Lett. 98, 133108 (2011).Google Scholar
Haberland, H., Karrais, M., Mall, M., and Thurner, Y.: Thin films from energetic cluster impact: A feasibility study, J. Vac. Sci. Technol., A 10, 3266 (1992).CrossRefGoogle Scholar
Sánchez-López, J.C. and Fernández, A.: The gas-phase condensation method for the preparation of quantum-sized ZnS nanoparticles, Thin Solid Films 317, 497–499 (1998).CrossRefGoogle Scholar
Lehtinen, K.E.J. and Kulmala, M.: A model for particle formation and growth in the atmosphere with molecular resolution in size, Atmos. Chem. Phys. 3, 251–257 (2003).CrossRefGoogle Scholar
Simchi, A., Ahmadi, R., Seyed Reihani, S.M., and Mahdavi, A.: Kinetics and mechanisms of nanoparticle formation and growth in vapor phase condensation process, Mater. Des. 28, 850–856 (2007).CrossRefGoogle Scholar
Ikezawa, S., Homyara, H., Kubota, T., Suzuki, R., Koh, S., Mutuga, F., Yoshioka, T., Nishiwaki, A., Ninomiya, Y., Takahashi, M., Baba, K., Kida, K., Hara, T., and Famakinwa, T.: Applications of TiO2 film for environmental purification deposited by controlled electron beam-excited plasma, Thin Solid Films 386, 173–176 (2001).CrossRefGoogle Scholar
Liqiang, J., Xiaojun, S., Weimin, C., Zili, X., Yaoguo, D., and Honggang, F.: The preparation and characterization of nanoparticle TiO2/Ti films and their photocatalytic activity, J. Phys. Chem. Solids 64, 615–623 (2003).CrossRefGoogle Scholar
Ayesh, A.I., Thaker, S., Qamhieh, N., and Ghamlouche, H.: Size-controlled Pd nanocluster grown by plasma gas-condensation method, J. Nanopart. Res. 13, 1125 (2011).CrossRefGoogle Scholar
Ayesh, A.I., Qamhieh, N., Mahmoud, S.T., and Alawadhi, H.: Fabrication of size-selected bimetallic nanoclusters using magnetron sputtering, J. Mater. Res. 27(18), 2441–2446 (2012).CrossRefGoogle Scholar
Banerjee, A.N., Krishna, R., and Das, B.: Size controlled deposition of Cu and Si nano-clusters by an ultra-high vacuum sputtering gas aggregation technique. Appl. Phys. A 90, 299 (2008).CrossRefGoogle Scholar
Haberland, H.: Nanoclusters of Atoms and Molecules (Springer, Berlin, 1995).Google Scholar
Hihara, T. and Sumiyama, K.: Formation and size control of a Ni cluster by plasma gas condensation. J. Appl. Phys. 84, 5270 (1998).CrossRefGoogle Scholar
Pratontep, S., Carroll, S.J., Xirouchaki, C., Streun, M., and Palmer, R.E.: Size-selected cluster beam source based on radio frequency magnetron plasma sputtering and gas condensation, Rev. Sci. Instrum. 76, 045103 (2005).CrossRefGoogle Scholar
Lushnikov, A.A. and Kulmala, M.: Dimers in nucleating vapors, Phys. Rev. E 58, 3157 (1998).CrossRefGoogle Scholar
Lehtinen, K.E.J., Backman, U., Jokiniemi, J.K., and Kulmala, M.: Three-body collisions as a particle formation mechanism in silver nanoparticle synthesis, J. Colloid Interface Sci. 274, 526–530 (2004).CrossRefGoogle ScholarPubMed
Fuchs, N.A. and Sutugin, A.G.: High dispersed aerosols, in Topics in Current Aerosol Research, Part 2, edited by Hidy, G.M. and Brock, J.R. (Pergamon, New York, 1971).Google Scholar
Jokiniemi, J.K., Lazaridis, M., Lehtinen, K.E.J., and Kauppinen, E.I.: Numerical simulation of vapour-aerosol dynamics in combustion processes, J. Aerosol Sci. 25, 429 (1994).CrossRefGoogle Scholar