Crossref Citations
This article has been cited by the following publications. This list is generated based on data provided by
Crossref.
Clement, J.J.
2001.
Electromigration modeling for integrated circuit interconnect reliability analysis.
IEEE Transactions on Device and Materials Reliability,
Vol. 1,
Issue. 1,
p.
33.
Ege, E. S.
and
Shen, Y. -L.
2003.
Thermomechanical response and stress analysis of copper interconnects.
Journal of Electronic Materials,
Vol. 32,
Issue. 10,
p.
1000.
Gan, C. L.
Thompson, C. V.
Pey, K. L.
and
Choi, W. K.
2003.
Experimental characterization and modeling of the reliability of three-terminal dual-damascene Cu interconnect trees.
Journal of Applied Physics,
Vol. 94,
Issue. 2,
p.
1222.
Suo, Z.
2003.
Comprehensive Structural Integrity.
p.
265.
SUO, Z.
2003.
Comprehensive Structural Integrity.
p.
303.
Goldberg, C.K.
and
Wang, V.S.
2003.
Interlayer Dielectrics for Semiconductor Technologies.
p.
77.
Hau-Riege, Christine S.
Hau-Riege, Stefan P.
and
Marathe, Amit P.
2004.
The effect of interlevel dielectric on the critical tensile stress to void nucleation for the reliability of Cu interconnects.
Journal of Applied Physics,
Vol. 96,
Issue. 10,
p.
5792.
Hau-Riege, Christine S.
2004.
An introduction to Cu electromigration.
Microelectronics Reliability,
Vol. 44,
Issue. 2,
p.
195.
Yao, C.H.
Huang, T.C.
Chi, K.S.
Wan, W.K.
Lin, H.H.
Hsia, C.C.
and
Liang, M.S.
2004.
Numerical characterization of the stress induced voiding inside via of various Cu/low k interconnects.
p.
24.
He, Jun
Suo, Z.
Marieb, T. N.
and
Maiz, J. A.
2004.
Electromigration lifetime and critical void volume.
Applied Physics Letters,
Vol. 85,
Issue. 20,
p.
4639.
Zhang, Zhen
Suo, Zhigang
and
He, Jun
2005.
Saturated voids in interconnect lines due to thermal strains and electromigration.
Journal of Applied Physics,
Vol. 98,
Issue. 7,
Cher Ming Tan
Roy, A.
Vairagar, A.V.
Krishnamoorthy, A.
and
Mhaisalkar, S.G.
2005.
Current crowding effect on copper dual damascene via bottom failure for ULSI applications.
IEEE Transactions on Device and Materials Reliability,
Vol. 5,
Issue. 2,
p.
198.
Choi, Z.S.
Chang, C. W.
Lee, J. H.
Gan, C. L.
Thompson, C. V.
Pey, K. L.
and
Choi, W. K.
2005.
Multi-Via Electromigration Test Structures for Identification and Characterization of Different Failure Mechanisms.
MRS Proceedings,
Vol. 863,
Issue. ,
Alam, S.M.
Gan, C.L.
Wei, F.L.
Thompson, C.V.
and
Troxel, D.E.
2005.
Circuit-level reliability requirements for Cu metallization.
IEEE Transactions on Device and Materials Reliability,
Vol. 5,
Issue. 3,
p.
522.
Hsia, Chin C.
2006.
The quest of porous ELK materials for high performance logic technologies.
Microelectronic Engineering,
Vol. 83,
Issue. 11-12,
p.
2055.
Wang, G.
Zhang, H.
Cargill III, G. S.
Hu, C. -K.
Ge, Y.
and
Maniatty, A.
2006.
Thermal and Electromigration-Induced Strains in Copper Conductor Lines: X-ray Microbeam Measurements and Analysis.
MRS Proceedings,
Vol. 914,
Issue. ,
Tan, Cher Ming
and
Roy, Arijit
2007.
Electromigration in ULSI interconnects.
Materials Science and Engineering: R: Reports,
Vol. 58,
Issue. 1-2,
p.
1.
Alam, Syed M.
Gan, Chee Lip
Thompson, Carl V.
and
Troxel, Donald E.
2007.
Reliability computer-aided design tool for full-chip electromigration analysis and comparison with different interconnect metallizations.
Microelectronics Journal,
Vol. 38,
Issue. 4-5,
p.
463.
Tan, Cher Ming
and
Hou, Yuejin
2007.
Lifetime modeling for stress-induced voiding in integrated circuit interconnections.
Applied Physics Letters,
Vol. 91,
Issue. 6,
Zhang, Hongqing
Cargill, G. S.
Ge, Youzhang
Maniatty, A. M.
and
Liu, Wenjun
2007.
Grain-Scale Strain and Orientation Measurements during Electromigration in Al Conductor Lines by Synchrotron X-Ray Microbeam Diffraction.
MRS Proceedings,
Vol. 1027,
Issue. ,