Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-27T23:58:43.129Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Cu on the corrosion resistance and electrochemical response of a Ni–Co–Cr–Mo alloy in acidic chloride solution

Published online by Cambridge University Press:  02 October 2018

Biaobiao Yang ,
Chenying Shi ,
Yunping Li ,
Qian Lei  and
Yan Nie
Biaobiao Yang
Affiliation:
School of Materials Science and Engineering, Central South University, Changsha 410083, China
Chenying Shi
Affiliation:
State Key Lab for Powder Metallurgy, Central South University, Changsha 410083, China
Yunping Li*
Affiliation:
State Key Lab for Powder Metallurgy, Central South University, Changsha 410083, China
Qian Lei*
Affiliation:
Powder Metallurgy Research Institute, Central South University, Changsha 410083, China
Yan Nie
Affiliation:
YuanMeng Precision Technology (Shenzhen) Institute, Shenzhen 518000, China
*
a)Address all correspondence to these authors. e-mail: [email protected]
b)e-mail: [email protected]
Get access

Abstract

The effect of Cu addition varied from 0 to 4 mass% on the corrosion resistance and electrochemical response in Ni–Co–Cr–Mo alloys was investigated using potentiodynamic polarization, electrochemical impedance spectroscopy, and Mott–Schottky analysis. Results indicate that the Ni–Co–Cr–Mo alloy with 2 mass% Cu exhibited the most superior corrosion resistance, and the presence of Cu greatly influenced the outer porous layer. The Ni–Co–Cr–Mo alloys’ corrosion resistance was not simply increasing with copper addition increasing from 0 to 4 mass%. The X-ray photoelectron spectroscopy etching analysis was also conducted to illustrate the fraction of Cu at various depths in the passive film, and the results reveal that a maximum limit on Cu content (appropriately 3.10 mass%) existed in the outermost surface in the present condition. Among the studied alloys, the Ni–Co–Cr–Mo–2%Cu alloy formed the thickest passive film with the lowest donor density.

Keywords

alloyCupassivation
Type
Article
Information
Journal of Materials Research , Volume 33 , Issue 22 , 28 November 2018 , pp. 3801 - 3808
Copyright
Copyright © Materials Research Society 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Hou, B.R., Li, X.G., Ma, X.M., Du, C.W., Zhang, D.W., Zheng, M., Xu, W.C., Lu, D.Z., and Ma, F.B.: The cost of corrosion in China. NPG Mater. Degrad. 1, 1 (2017).Google Scholar
Xu, Q.F., Gao, K.W., Lv, W.T., and Pang, X.L.: Effects of alloyed Cr and Cu on the corrosion behavior of low-alloy steel in a simulated groundwater solution. Corros. Sci. 102, 114 (2016).CrossRefGoogle Scholar
Chen, W., Lei, Q., Jia, Y., Yi, J., and Derby, B.: Effect of addition of Ni and Si on the microstructure and mechanical properties of Cu–Zn alloys. J. Mater. Res. 32, 3137 (2017).CrossRefGoogle Scholar
Qiang, Y.J., Zhang, S.T., Guo, L., Zheng, X.W., Xiang, B., and Chen, S.J.: Experimental and theoretical studies of four allyl imidazolium-based ionic liquids as green inhibitors for copper corrosion in sulfuric acid. Corros. Sci. 119, 68 (2017).CrossRefGoogle Scholar
Xie, L., Lei, Q., Wang, M., Sheng, X., and Li, Z.: Effects of aging mechanisms on the exfoliation corrosion behavior of a spray deposited Al–Zn–Mg–Cu–Zr aluminum alloy. J. Mater. Res. 32, 1105 (2017).CrossRefGoogle Scholar
Chen, X.H., Li, J., Cheng, X., Wang, H.M., and Huang, Z.: Effect of heat treatment on microstructure, mechanical and corrosion properties of austenitic stainless steel 316 L using arc additive manufacturing. Mater. Sci. Eng., A 715, 307 (2018).CrossRefGoogle Scholar
Beom, W.J., Kalubarme, R.S., Yun, K.S., and Park, C.J.: Effects of platinum nano electrodeposits on corrosion of carbon substrate. Appl. Surf. Sci. 257, 9694 (2011).CrossRefGoogle Scholar
Hong, J.H., Lee, S.H., Kim, J.G., and Yoon, J.B.: Corrosion behaviour of copper containing low alloy steels in sulphuric acid. Corros. Sci. 54, 174 (2012).CrossRefGoogle Scholar
Hao, X.H., Dong, J.H., Wei, J., Etim, I.N., and Ke, W.: Effect of Cu on corrosion behavior of low alloy steel under the simulated bottom plate environment of cargo oil tank. Corros. Sci. 121, 84 (2017).CrossRefGoogle Scholar
Zhang, C., Li, Y.P., Hou, Y.H., Tang, N., Ohmura, K., Koizumi, Y., and Chiba, A.: Corrosion resistance of Cu- and Fe-modified Ni–30Co–16Cr–15Mo alloy in aqueous hydrofluoric acid. Corros. Sci. 89, 81 (2014).CrossRefGoogle Scholar
Li, Y.P., Xu, X.D., Hou, Y.H., Zhang, C., Wang, F.L., Omura, K., Koizumi, Y., and Chiba, A.: Regulating the passive film of NiCoCrMo alloy in hydrofluoric acid by small addition of Cu. Corros. Sci. 98, 119 (2015).CrossRefGoogle Scholar
Liu, Y., Li, Z., Jiang, Y., Zhang, Y., Zhou, Z., and Lei, Q.: The microstructure evolution and properties of a Cu–Cr–Ag alloy during thermal-mechanical treatment. J. Mater. Res. 17, 1342 (2017).Google Scholar
Li, P., Zhao, Y., Liu, Y.Z., Zhao, Y., Xu, D.K., Yang, C.G., Zhang, T., Gu, T.Y., and Yang, K.: Effect of Cu addition to 2205 duplex stainless steel on the resistance against pitting corrosion by the Pseudomonas aeruginosa biofilm. J. Mater. Sci. Technol. 33, 723 (2017).CrossRefGoogle Scholar
Pardo, A., Merino, M.C., Carboneras, M., Coy, A.E., and Arrabal, R.: Pitting corrosion behaviour of austenitic stainless steels with Cu and Sn additions solution by small addition of Cu. Corros. Sci. 49, 510 (2007).CrossRefGoogle Scholar
Jiang, J., Xu, D.K., Xi, T., Shahzad, M.B., Khan, M.S., Zhao, J.L., Fan, X.M., Yang, C.G., Gu, T.Y., and Yang, K.: Effects of aging time on intergranular and pitting corrosion behavior of Cu-bearing 304L stainless steel in comparison with 304L stainless steel. Corros. Sci. 113, 46 (2016).CrossRefGoogle Scholar
Zhang, X.G., Zagidulin, D., and Shoesmith, D.W.: Characterization of film properties on the Ni–Cr–Mo alloy C-2000. Electrochim. Acta 89, 814 (2013).CrossRefGoogle Scholar
Ujiro, T., Satoh, S., Staehle, R.W., and Smyrl, W.H.: Effect of alloying Cu on the corrosion resistance of stainless steels in chloride media. Corros. Sci. 43, 2185 (2001).CrossRefGoogle Scholar
Oguzie, E.E., Li, J.B., Liu, Y.Q., Chen, D.M., Li, Y., Yang, K., and Wang, F.H.: The effect of Cu addition on the electrochemical corrosion and passivation behavior of stainless steels. Electrochim. Acta 55, 5028 (2010).CrossRefGoogle Scholar
Ningshen, S., Mudali, U.K., Mittal, V.K., and Khatak, H.S.: Semiconducting and passive film properties of nitrogen-containing type 316LN stainless steels. Corros. Sci. 49, 481 (2007).CrossRefGoogle Scholar
Zagidulin, D., Zhang, X.R., Zhou, J.G., Noël, J.J., and Shoesmith, D.W.: Characterization of surface composition on alloy 22 in neutral chloride solutions. Surf. Interface Anal. 45, 1014 (2013).CrossRefGoogle Scholar
Li, Y.P., Fan, X.R., Tang, N., Bian, H.K., Hou, Y.H., Koizumi, Y., and Chiba, A.: Effects of partially substituting cobalt for nickel on the corrosion resistance of a Ni–16Cr–15Mo alloy to aqueous hydrofluoric acid. Corros. Sci. 78, 101 (2014).CrossRefGoogle Scholar
Ries, L.A.S., Belo, M.D.C., Ferreira, M.G.S., and Muller, I.L.: Chemical composition and electronic structure of passive films formed on alloy 600 in acidic solution. Corros. Sci. 50, 676 (2008).CrossRefGoogle Scholar
Ter-Ovanessian, B., Alemany-Dumont, C., and Normand, B.: Electronic and transport properties of passive films grown on different Ni–Cr binary alloys in relation to the pitting susceptibility. Electrochim. Acta 133, 373 (2014).CrossRefGoogle Scholar
Yang, B.B., Li, J.X., Gong, X.J., Nie, Y., and Li, Y.P.: Effects of Cu addition on the corrosion behavior of NiCoCrMo alloys in neutral chloride solution. RSC Adv. 7, 40779 (2017).CrossRefGoogle Scholar
Thermo-Calc Software, Ni-based alloy database, TCW 5.0 (2013). Available at: http://www.thermocalc.com (accessed December 15, 2017).Google Scholar
Cao, C.N.: Principles of Electrochemistry of Corrosion (Chemical Industry Press, Beijing, 2008).Google Scholar
Osório, W.R., Freitas, E.S., and Garcia, A.: EIS parameters and cell spacings of an Al–Bi alloy in NaCl solution. Electrochim. Acta 108, 781 (2013).CrossRefGoogle Scholar
Shukla, A.K. and Balasubramaniam, R.: Effect of surface treatment on electrochemical behavior of CP Ti, Ti–6Al–4V and Ti–13Nb–13Zr alloys in simulated human body fluid. Corros. Sci. 48, 1696 (2006).CrossRefGoogle Scholar
Mohammadi, F., Nickchi, T., Attar, M.M., and Alfantazi, A.: EIS study of potentiostatically formed passive film on 304 stainless steel. Electrochim. Acta 56, 8727 (2011).CrossRefGoogle Scholar
Osório, W.R., Peixoto, L.C., and Garcia, A.: The effects of Ag content and dendrite spacing on the electrochemical behavior of Pb–Ag alloys for Pb–acid battery components. J. Power Sources 238, 324 (2013).CrossRefGoogle Scholar
Cvijović-Alagić, I., Cvijović, Z., Bajat, J., and Rakin, M.: Composition and processing effects on the electrochemical characteristics of biomedical titanium alloys. Corros. Sci. 83, 245 (2014).CrossRefGoogle Scholar
Hwang, M.J., Park, E.J., Moon, W.J., Song, H.J., and Park, Y.J.: Characterization of passive layers formed on Ti–10 wt% (Ag, Au, Pd, or Pt) binary alloys and their effects on galvanic corrosion. Corros. Sci. 96, 152 (2015).CrossRefGoogle Scholar
Bott, A.W.: Electrochemistry of semiconductors. Curr. Sep. 17, 87 (1998).Google Scholar
Macdonald, D.D. and Sun, A.: An electrochemical impedance spectroscopic study of the passive state on alloy-22. Electrochim. Acta 51, 1767 (2006).CrossRefGoogle Scholar
Macdonald, D.D., Sun, A., Priyantha, N., and Jayaweera, P.: An electrochemical impedance study of alloy-22 in NaCl brine at elevated temperature: II. Reaction mechanism analysis. J. Electroanal. Chem. 572, 421 (2004).CrossRefGoogle Scholar
Fattah-alhosseini, A., Masomi, Z., and Mirzaei, M.: Investigation of the electrochemical behavior of alloy C in NaOH solutions. Anal. Bioanal. Electrochem. 6, 646 (2014).Google Scholar
Marconnet, C., Wouters, Y., Miserque, F., Dagbert, C., Petit, J.P., Galerie, A., and Feron, D.: Chemical composition and electronic structure of the passive layer formed on stainless steels in a glucose-oxidase solution. Electrochim. Acta 54, 123 (2008).CrossRefGoogle Scholar
Fattah-alhosseini, A., Naseri, M., Gashti, S.O., Vafaeian, S., and Keshavarz, M.K.: Effect of anodic potential on the electrochemical response of passive layers formed on the surface of coarse- and fine-grained pure nickel in borate buffer solutions. Corros. Sci. 131, 81 (2018).CrossRefGoogle Scholar
San, X.Y., Zhang, B., Wu, B., Wei, X.X., Oguzie, E.E., and Ma, X.L.: Investigating the effect of Cu-rich phase on the corrosion behavior of super 304H austenitic stainless steel by TEM. Corros. Sci. 130, 143 (2018).CrossRefGoogle Scholar