Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-24T20:52:31.197Z Has data issue: false hasContentIssue false
  • English
  • Français

Stress gradients observed in Cu thin films induced by capping layers

Published online by Cambridge University Press:  31 January 2011

Conal E. Murray ,
Paul R. Besser ,
Christian Witt  and
Jean L. Jordan-Sweet
Conal E. Murray*
Affiliation:
IBM T.J. Watson Research Center, Yorktown Heights, New York 10598
Paul R. Besser*
Affiliation:
Advanced Micro Devices, Sunnyvale, California 94088
Christian Witt
Affiliation:
GlobalFoundries, T.J. Watson Research Center, Yorktown Heights, New York 10598
Jean L. Jordan-Sweet
Affiliation:
IBM T.J. Watson Research Center, Yorktown Heights, New York 10598
*
a)Address all correspondence to this author. e-mail: [email protected]
b)Present address: Unity Semiconductor, Sunnyvale, CA.
Get access

Abstract

Glancing-incidence x-ray diffraction (GIXRD) has been applied to the investigation of depth-dependent stress distributions within electroplated Cu films due to overlying capping layers. Cu films, 0.65 μm thick, plated on conventional barrier and seed layers received a chemical vapor deposited (CVD) SiCxNyHz cap, an electrolessly deposited CoWP layer, or a CoWP layer followed by a SiCxNyHz cap. GIXRD and conventional x-ray diffraction measurements revealed that strain gradients were created in Cu films possessing a SiCxNyHz cap, where a greater in-plane tensile stress of approximately 180 MPa was generated near the film/cap interface as a result of constraint imposed by the SiCxNyHz layer during cooling from the cap deposition temperature. Although Cu films possessing a CoWP cap without a SiCxNyHz layer did not exhibit depth-dependent stress distributions, subsequent annealing introduced stress gradients and increased the bulk Cu stress. However, a thermal excursion to liquid-nitrogen temperatures significantly reduced tensile stresses in the Cu films.

Keywords

Thermal stressesX-ray diffraction (XRD)Cu
Type
Outstanding Symposium Papers
Information
Journal of Materials Research , Volume 25 , Issue 4 , April 2010 , pp. 622 - 628
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Vinci, R.P., Zielinski, E.M., Bravman, J.C.Thermal strain and stress in copper thin films. Thin Solid Films 262, 142 (1995)CrossRefGoogle Scholar
2.Keller, R-M., Baker, S.P., Arzt, E.Quantitative analysis of strengthening mechanisms in thin Cu films: Effects of film thickness, grain size, and passivation. J. Mater. Res. 13, 1307 (1998)CrossRefGoogle Scholar
3.Hu, C.K., Rosenberg, R., Lee, K.Y.Electromigration path in Cu thin-film lines. Appl. Phys. Lett. 74, 2945 (1999)CrossRefGoogle Scholar
4.Parratt, L.G.Surface studies of solids by total reflection of x-rays. Phys. Rev. 95, 359 (1954)CrossRefGoogle Scholar
5.Doerner, M.F., Brennan, S.Strain distribution in thin aluminium films using x-ray depth profiling. J. Appl. Phys. 63, 126 (1988)CrossRefGoogle Scholar
6.Schute, C.J., Cohen, J.B.Strain gradients in Al–2% Cu thin films. J. Appl. Phys. 70, 2104 (1991)CrossRefGoogle Scholar
7.Himuro, T., Takayama, S.Temperature dependence of stress distribution in depth for Cu thin filmsStability of Thin Films and Nanostructures edited by R.P. Vinci, R. Schwaiger, A. Karim, and V. Shenoy (Mater. Res. Soc. Symp. Proc. 854E, Warrendale, PA 2005)U11.11Google Scholar
8.Takayama, S., Oikawa, M., Himuro, T.Thermal stability and internal stress for strongly (111) oriented Cu filmsThin Films—Stresses and Mechanical Properties X edited by S.G. Corcoran, Y-C. Joo, N.R. Moody, and Z. Suo (Mater. Res. Soc. Symp. Proc. 795, Warrendale, PA 2004)U5.11Google Scholar
9.Murray, C.E., Besser, P.R., Witt, C., Jordan-Sweet, J.L.Stress gradients induced in Cu films by capping layers. Appl. Phys. Lett. 93, 221901 (2008)CrossRefGoogle Scholar
10.Toney, M.F., Brennan, S.Observation of the effect of refraction on x rays diffracted in a grazing-incidence asymmetric Bragg geometry. Phys. Rev. B 39, 7963 (1989)CrossRefGoogle Scholar
11.Noyan, I.C., Cohen, J.B.Residual Stress (Springer-Verlag, NY 1987)68122CrossRefGoogle Scholar
12.Kröner, E.The elastic constants of polycrystals calculated using the single crystal constants. Z. Phys. 151, 504 (1958)CrossRefGoogle Scholar
13.Welzel, U., Leoni, M., Mittemeijer, E.J.The determination of stresses in thin films modeling elastic grain interaction. Philos. Mag. 83, 603 (2003)CrossRefGoogle Scholar
14.Gan, D., Ho, P.S., Pang, Y., Huang, R., Leu, J., Maiz, J., Scherban, T.Effect of passivation on stress relaxation in electroplated copper films. J. Mater. Res. 21, 1512 (2006)CrossRefGoogle Scholar
15.Flinn, P.A.Measurement and interpretation of stress in copper films as a function of thermal history. J. Mater. Res. 6, 1500 (1991)CrossRefGoogle Scholar
16.Shen, Y-L., Ramamurty, U.Temperature-dependent inelastic response of passivated copper films: Experiments, analyses and implications. J. Vac. Sci. Technol., B 21, 1258 (2003)CrossRefGoogle Scholar
17.Florando, J.N., Nix, W.D.Study of the yielding and strain hardening behavior of a copper thin film on a silicon substrate using microbeam bendingDislocations and Deformation Mechanisms in Thin Films and Small Structures edited by K. Schwarz, O Kraft, S.P. Baker, L.B. Freund, and R. Hull (Mater. Res. Soc. Symp. Proc. 673, Warrendale, PA 2001)P1.9Google Scholar