Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-11-28T13:23:13.608Z Has data issue: false hasContentIssue false
  • English
  • Français

SrTiO3 films on platinized (0001) Al2O3: Characterization of texture and nonstoichiometry accommodation

Published online by Cambridge University Press:  03 March 2011

Dmitri O. Klenov ,
Troy R. Taylor  and
Susanne Stemmer
Dmitri O. Klenov*
Affiliation:
Materials Department, University of California, Santa Barbara, California 93106-5050
Troy R. Taylor
Affiliation:
Materials Department, University of California, Santa Barbara, California 93106-5050
Susanne Stemmer
Affiliation:
Materials Department, University of California, Santa Barbara, California 93106-5050
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Transmission electron microscopy and x-ray diffraction were used to study SrTiO3 films grown on platinized (0001) Al2O3 substrates. The Pt films were epitaxial with an orientation relationship described by (111)Pt‖(0001)Al2O3 and [110]Pt‖[10¯10]Al2O3. SrTiO3 films with two different Sr to Ti ratios, 1.02 and 1.4, were deposited by radio-frequency magnetron sputtering. In the film with a large amount of Sr excess, the grain sizes were smaller and a high density of planar defects was observed. The films were predominantly (111) textured, but a weaker (110) texture component was also found, independent of stoichiometry. While the (111) texture could be explained with the excellent lattice match with (111) Pt, the (110) textured grains had a large mismatch with the Pt electrode. We propose that the presence of the (110) oriented grains is due to nucleation at Pt surface defects. Planar defects in the films with a large amount of Sr excess served to accommodate the nonstoichiometry. Comparison with homoepitaxial SrTiO3 films showed that the density of planar defects in the SrTiO3 films on (111)Pt/Al2O3 is insufficient to accommodate all the excess Sr. The influence of the film microstructure on the dielectric properties is also discussed.

Keywords

TextureTransmission electron microscopy (TEM)Thin film
Type
Articles
Information
Journal of Materials Research , Volume 19 , Issue 5 , May 2004 , pp. 1477 - 1486
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Pertsev, N.A., Zembilgotov, A.G., Hoffmann, S., Waser, R. and Tagantsev, A.K., Ferroelectric thin films grown on tensile substrates: Renormalization of the Curie-Weiss law and apparent absence of ferroelectricity. J. Appl. Phys. 85, 1698 (1999).CrossRefGoogle Scholar
2Streiffer, S.K., Basceri, C., Parker, C.B., Lash, S.E. and Kingon, A.I., Ferroelectricity in thin films: The dielectric response of fiber-textured (BaxSr1–x)Ti1+yO3+z thin films grown by chemical vapor deposition. J. Appl. Phys. 86, 4565 (1999).CrossRefGoogle Scholar
3Shaw, T.M., Suo, Z., Huang, M., Liniger, E., Laibowitz, R.B. and Baniecki, J.D., The effect of stress on the dielectric properties of barium strontium titanate thin films. Appl. Phys. Lett. 75, 2129 (1999).CrossRefGoogle Scholar
4Stemmer, S., Streiffer, S.K., Browning, N.D. and Kingon, A.I., Accommodation of nonstoichiometry in (100) fiber-textured (BaxSr1-x)Ti1+yO3+z thin films grown by chemical vapor deposition. Appl. Phys. Lett. 74, 2432 (1999).CrossRefGoogle Scholar
5Suzuki, T., Nishi, Y. and Fujimoto, M., Defect structure in homoepitaxial non-stoichiometric strontium titanate thin films. Philos. Mag. A 80, 621 (2000).CrossRefGoogle Scholar
6Fuchs, D., Adam, M., Schweiss, P., Gerhold, S., Schuppler, S., Schneider, R. and Obst, B., Structural properties of slightly off-stoichiometric homoepitaxial SrTixO3-∂ thin films. J. Appl. Phys. 88, 1844 (2000).CrossRefGoogle Scholar
7Tian, W., Pan, X.Q., Haeni, J.H. and Schlom, D.G., Transmission electron microscopy study of n = 1–5 Srn+TinO3n+1 epitaxial thin films. J. Mater. Res. 16, 2013 (2001).CrossRefGoogle Scholar
8Wu, J.S., Jia, C.L., Urban, K., Hao, J.H. and Xi, X.X., Microstructure and misfit relaxation in SrTiO3/SrRuO3 bilayer films on LaAlo3(100) substrates. J. Mater. Res. 16, 3443 (2001).CrossRefGoogle Scholar
9Li, H.C., Si, W.D., West, A.D. and Xi, X.X., Near single crystal-level dielectric loss and nonlinearity in pulsed laser deposited SrTiO3 thin films. Appl. Phys. Lett. 73, 190 (1998).CrossRefGoogle Scholar
10Christen, H.M., Mannhart, J., Williams, E.J. and Gerber, C., Dielectric-properties of sputtered SrTiO3 films. Phys. Rev. B 49, 12095 (1994).CrossRefGoogle ScholarPubMed
11Fuchs, D., Schneider, C.W., Schneider, R. and Rietschel, H., High dielectric constant and tunability of epitaxial SrTiO3 thin film capacitors. J. Appl. Phys. 85, 7362 (1999).CrossRefGoogle Scholar
12Hwang, C.S., Vaudin, M.D. and Schenck, P.K., Influence of the microstructure of Pt/Si substrates on textured growth of barium titanate thin films prepared by pulsed laser deposition. J. Mater. Res. 13, 368 (1998).CrossRefGoogle Scholar
13Kotecki, D.E., Baniecki, J.D., Shen, H., Laibowitz, R.B., Saenger, K.L., Lian, J.J., Shaw, T.M., Athavale, S.D., Cabral, C., Duncombe, P.R., Gutsche, M., Kunkel, G., Park, Y.J., Wang, Y.Y. and Wise, R., (Ba,Sr)TiO3 dielectrics for future stacked-capacitor DRAM. IBM J. Res. Develop. 43, 367 (1999).CrossRefGoogle Scholar
14Bilodeau, S.M., Carl, R., Van Buskirk, P.C., Roeder, J.F., Basceri, C., Lash, S.E., Parker, C.B., Streiffer, S.K. and Kingon, A.I., Dielectric properties and microstructure of thin BST films. J. Kor. Phys. Soc. 32 S1591 (1998).Google Scholar
15Taylor, T.R., Hansen, P.J., Pervez, N., Acikel, B., York, R.A. and Speck, J.S., Influence of stoichiometry on the dielectric properties of sputtered strontium titanate thin films. J. Appl. Phys. 94, 3390 (2003).CrossRefGoogle Scholar
16Ramanathan, S., Clemens, B.M., McIntyre, P.C. and Dahmen, U., Microstructural study of epitaxial platinum and permalloy/platinum films grown on 0001 sapphire. Philos. Mag. A 81, 2073 (2001).CrossRefGoogle Scholar
17Farrow, R.F.C., Harp, G.R., Marks, R.F., Rabedeau, T.A., Toney, M.F., Weller, D. and Parkin, S.S.P., Epitaxial-growth of Pt on basal-plane sapphire—a seed film for artificially layered magnetic metal structures. J. Cryst. Growth 133, 47 (1993).CrossRefGoogle Scholar
18Nefedov, A., Abromeit, A., Morawe, C. and Stierle, A., High-resolution x-ray scattering study of platinum thin films on sapphire. J. Phys.: Condens. Matter 10, 717 (1998).Google Scholar
19Hildner, M.L., Minvielle, T.J. and Wilson, R.J., Epitaxial growth of ultrathin Pt films on basal-plane sapphire: the emergence of a continuous atomically flat film. Surf. Sci. 396, 16 (1998).CrossRefGoogle Scholar
20Tarsa, E.J., Hachfeld, E.A., Quinlan, F.T., Speck, J.S. and Eddy, M., Growth-related stress and surface morphology in homoepitaxial SrTiO3 films. Appl. Phys. Lett. 68, 490 (1996).CrossRefGoogle Scholar
21Sturm, S., Recnik, A., Scheu, C. and Ceh, M., Formation of ruddlesden-Popper faults and polytype phases in SrO-doped SrTiO3. J. Mater. Res. 15, 2131 (2000).CrossRefGoogle Scholar
22Levi, C.G., Metastability and microstructure evolution in the synthesis of inorganics from precursors. Acta Mater. 46, 787 (1998).CrossRefGoogle Scholar
23Muralt, P., Maeder, T., Sagalowicz, L., Hiboux, S., Scalese, S., Naumovic, D., Agostino, R.G., Xanthopoulos, N., Mathieu, H.J., Patthey, L. and Bullock, E.L., Texture control of PbTiO3 and Pb(Zr,Ti)O3 thin films with TiO2 seeding. J. Appl. Phys. 83, 3835 (1998).CrossRefGoogle Scholar
24Asthagiri, A., Niederberger, C., Francis, A.J., Porter, L.M., Salvador, P.A. and Sholl, D.S., Thin Pt films on the polar SrTiO3(111) surface: an experimental and theoretical study. Surf. Sci. 537, 134 (2003).CrossRefGoogle Scholar
25Tilley, R.J.D., An electron microscope study of perovskite-related oxides in Sr-Ti-O system. J. Solid State Chem. 21, 293 (1977).CrossRefGoogle Scholar
26McCoy, M.A., Grimes, R.W. and Lee, W.E., Phase stability and interfacial structures in the SrO-SrTiO3 system. Philos. Mag. A 75, 833 (1997).CrossRefGoogle Scholar
27Witek, S., Smyth, D.M. and Pickup, H., Variability of the Sr/Ti ratio in SrTiO3. J. Am. Ceram. Soc. 67, 372 (1984).CrossRefGoogle Scholar
28Ruddlesden, S.N. and Popper, P., The compound Sr3Ti2O7 and its structure. Acta Crystallogr. 11, 54 (1958).CrossRefGoogle Scholar
29Kamba, S., Samoukhina, P., Kadlec, F., Pokorny, J., Petzelt, J., Reaney, I.M. and Wise, P.L., Composition dependence of the lattice vibrations in Srn+1TinO3n+1 Ruddlesden-Popper homologous series. J. Eur. Ceram. Soc. 23, 2639 (2003).CrossRefGoogle Scholar
30Wise, P.L., Reaney, I.M., Lee, W.E., Price, T.J., Iddles, D.M. and Cannell, D.S., Structure-microwave property relations of Ca and Sr titanates. J. Eur. Ceram. Soc. 21, 2629 (2001).CrossRefGoogle Scholar