Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-28T15:17:40.307Z Has data issue: false hasContentIssue false
  • English
  • Français

Piezoelectric nanoindentation

Published online by Cambridge University Press:  01 March 2006

Andrei Rar ,
G.M. Pharr ,
W.C. Oliver ,
E. Karapetian  and
Sergei V. Kalinin
Andrei Rar*
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831;and Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996
G.M. Pharr
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831;and Department of Materials Science and Engineering, University of Tennessee, Knoxville, Tennessee 37996
W.C. Oliver
Affiliation:
MTS Corporation, Oak Ridge, Tennessee 37831
E. Karapetian
Affiliation:
Suffolk University, Boston, Massachusetts 02108
Sergei V. Kalinin*
Affiliation:
Condensed Material Science Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831
*
a)Address all correspondence to these authors. e-mail: [email protected]
b)Address all correspondence to these authors. e-mail: [email protected]
Get access

Abstract

Piezoelectric nanoindentation (PNI) has been developed to quantitatively address electromechanical coupling and pressure-induced dynamic phenomena in ferroelectric materials on the nanoscale. In PNI, an oscillating voltage is applied between the back side of the sample and the indenter tip, and the first harmonic of bias-induced surface displacement at the area of indenter contact is detected. PNI is implemented using a standard nanoindentation system equipped with a continuous stiffness measurement system. The piezoresponse of polycrystalline lead zirconate titanate (PZT) and BaTiO3 piezoceramics was studied during a standard nanoindentation experiment. For PZT, the response was found to be load independent, in agreement with theoretical predictions. In polycrystalline barium titanate, a load dependence of the piezoresponse was observed. The potential of piezoelectric nanoindentation for studies of phase transitions and local structure-property relations in piezoelectric materials is discussed.

Keywords

FerroelectricPiezoresponseStress/strain relations
Type
Rapid Communications
Information
Journal of Materials Research , Volume 21 , Issue 3 , March 2006 , pp. 552 - 556
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Oliver, W.C., Pharr, G.M.: An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments. J. Mater. Res. 7, 1564 (1992).CrossRefGoogle Scholar
2.Mann, A.B., van Heerden, D., Pethica, J.B., Weihs, T.P.: Size-dependent phase transformations during point loading of silicon. J. Mater. Res. 15, 1754 (2000).CrossRefGoogle Scholar
3.Volinsky, A.A., Vella, J.B., Gerberich, W.W.: Fracture toughness, adhesion and mechanical properties of low-K dielectric thin films measured by nanoindentation. Thin Solid Films 429, 201 (2003).Google Scholar
4.Nanoscale Phenomena in Ferroelectric Thin Films, edited by Hong, S. (Kluwer, 2004).Google Scholar
5.Nanoscale Characterization of Ferroelectric Materials, edited by Alexe, M. and Gruverman, A. (Springer, 2004).Google Scholar
6.Kalinin, S.V., Rar, A., Jesse, S. A Decade of Piezoresponse Force Microscopy: Progress, Challenges and Opportunities, cond-mat/0509009.Google Scholar
7.Kalinin, S.V., Karapetian, E., Kachanov, M.: Nanoelectromechanics of piezoresponse force microscopy. Phys. Rev. B 70, 184101 (2004).Google Scholar
8.Hay, J.L., Pharr, G.M. Instrumented indentation testing, in ASM Handbook Vol. 8: Mechanical Testing and Evaluation, 10th ed., edited by Kuhn, H. and Medlin, D. (ASM International, Materials Park, OH, 2000), pp. 232–243.Google Scholar
9.Alguero, M., Calzada, M.L., Bushby, A.J., Reece, M.J.: Ferroelectric hysteresis loops of (Pb,Ca)TiO3 thin films under spherical indentation. Appl. Phys. Lett. 85, 2023 (2004).Google Scholar
10.Sridhar, S., Giannakopoulos, A.E., Suresh, S.: Mechanical and electrical responses of piezoelectric solids to conical indentation. J. Appl. Phys. 87, 8451 (2000).CrossRefGoogle Scholar
11.Sridhar, S., Giannakopoulos, A.E., Suresh, S., Ramamurty, U.: Electrical response during indentation of piezoelectric materials: A new method for material characterization. J. Appl. Phys. 85, 380 (1999).CrossRefGoogle Scholar
12.Koval, V., Reece, M.J., Bushby, A.J.: Ferroelectric/ferroelastic behavior and piezoelectric response of lead zirconate titanate thin films under nanoindentation. J. Appl. Phys. 97, 074301 (2005).CrossRefGoogle Scholar
13.Karapetian, E., Kachanov, M., Kalinin, S.V.: Nanoelectromechanics of piezoelectric indentation and applications to scanning probe microscopies of ferroelectric materials. Philos. Mag. 85, 1017 (2005).CrossRefGoogle Scholar
14.Kalinin, S.V., Kachanov, M., Rar, A., and Karapetian, E. (unpublished).Google Scholar