Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-12-01T09:08:02.619Z Has data issue: false hasContentIssue false
  • English
  • Français

Oxidation and reduction behavior of pure indium

Published online by Cambridge University Press:  31 January 2011

Harry Schoeller  and
Junghyun Cho
Junghyun Cho*
Affiliation:
Department of Mechanical Engineering and Materials Science and Engineering Program, State University of New York at Binghamton, Binghamton, New York 13902-6000
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Fundamental knowledge on the oxidation behavior of pure indium, commonly used as a low-temperature, fluxless soldering material in micro-electro-mechanical system (MEMS) devices, is of importance as it influences the solder joint reliability. A thermodynamic model of the oxidation and reduction behavior of indium is developed by constructing an Ellingham diagram, and by using H2(g) reactions. Partial pressure (p) of H2O was shown to be the critical parameter in creating a reducing environment in the applicable solder reflow temperature range. Verification of the thermodynamic models was then carried out through heating and melting of indium in controlled glove box environments by adjusting p(H2)/p(H2O). The nanometer scale thickness of the oxide layer grown on indium was measured by a spectroscopic ellipsometer. The growth mechanism for oxidation in air below 220 °C follows Uhlig's logarithmic law where electron transport is the rate-controlling mechanism, implying that there is an incubation period for the onset of initial oxidation. Its activation energy was found to be 0.65 eV.

Keywords

LnOxidationSoldering
Type
Articles
Information
Journal of Materials Research , Volume 24 , Issue 2 , February 2009 , pp. 386 - 393
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Wable, G., Chu, Q., Damodaran, P., Srihari, K.: A systematic procedure for the selection of a lead-free solder paste in an electronics manufacturing environment. Solder. Surf. Mount Technol. 2, 32 (2005)CrossRefGoogle Scholar
2.Abtew, M., Selvaduray, G.: Lead-free solders in microelectronics. Mater. Sci. Eng., R 5, 95 (2000)CrossRefGoogle Scholar
3.Mil'shtein, S., Parsey, J. Jr., Lang, D., Joy, D., Temkin, H.: A low-stress low-temperature ‘micro-soldering’ technique for making electrical contacts to semiconductor crystals and thin film materials. IEEE Trans. Comp. Pac. Man. Tech. 8, 397 (1985)Google Scholar
4.Humpston, G., Jacobson, D.: Indium solders. Adv. Mater. Proc. 4, 45 (2005)Google Scholar
5.Chu, K., Lee, J., Cho, H., Park, H., Jeon, D.: A fluxless flip-chip bonding for VCSEL arrays using silver-coated indium solder bumps, in Proceedings of 2004 International IEEE Conference on Asian Green Electronics (AGEC)IEEE, Piscataway, NJ2004110–116CrossRefGoogle Scholar
6.Chen, Y., Lee, C.: Indium-copper multilayer composites for fluxless oxidation-free bonding. Thin Solid Films 1, 243 (1996)CrossRefGoogle Scholar
7.Ma, L., Bao, S., Peng, J., Du, Z.: Failure analysis of In/Au solder joints, in 7th International Conference on Electronic Packaging TechnologyIEEE, Piscataway, NJ2006CrossRefGoogle Scholar
8.Kim, J., Park, S., Schoeller, H., Cho, J.: Effect of oxidation on indium solderability. J. Electron. Mater. 4, 483 (2008)CrossRefGoogle Scholar
9.Kubaschewski, O., Hopkins, B.: Oxidation of Metals and Alloys 2nd ed. (Academic Press Inc New York 1962)Google Scholar
10.Schoeller, H., Kim, J., Park, S., Cho, J.: Thermodynamics and kinetics of oxidation of pure indium soldersAdvanced Electronic Packaging edited by V.P. Atluri, S. Sharan, C-P. Wong, and D. Frear (Mater. Res. Soc. Symp. Proc. 968, Warrendale, PA 2007)8994Google Scholar
11.Eldridge, J.M., Van Der Meulen, Y.J., Dong, D.W.: Analysis of ultrathin oxide growth on indium. Thin Solid Films 2, 447 (1972)CrossRefGoogle Scholar
12.Uhlig, H.: Initial oxidation rate of metals and logarithmic equation. Acta Metall. 5, 541 (1956)CrossRefGoogle Scholar
13.Fromhold, A.T.: Parabolic oxidation of metals. Phys. Lett. A 3, 157 (1969)CrossRefGoogle Scholar
14.Tammann, G., Vogel, R.: The ternary system iron-boron-carbon. Z. Anorg. Allg. Chem. 4, 225 (1922)Google Scholar
15.Gaskell, D.: Introduction to the Thermodynamics of Materials 4th ed.(Taylor & Francis New York 2003)89, 347Google Scholar
16.Barin, I., Knacke, O.: Thermochemical Properties of Inorganic Substances(Springer-Verlag New York 1991)Google Scholar
17.Rideal, E.K., Wansbrough-Jones, O.H.: An investigation of the combustion of platinum. Proc. R. Soc. 123, 202 (1929)Google Scholar