Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-24T09:58:28.586Z Has data issue: false hasContentIssue false
  • English
  • Français

Microstructure and dielectric properties of Ba(Cd1/3Ta2/3)O3 microwave ceramics synthesized with a boron oxide sintering aid

Published online by Cambridge University Press:  01 December 2004

Shaojun Liu ,
Jian Sun ,
Richard Taylor ,
David J. Smith  and
N. Newman
Shaojun Liu
Affiliation:
Science and Engineering of Materials Program, and Department of Chemical and Materials Engineering, Arizona State University, Tempe, Arizona 85287
Jian Sun
Affiliation:
Center for Solid State Science, Arizona State University, Tempe, Arizona 85287; and School of Materials Science and Engineering, Shanghai Jiao-tong University, Shanghai 20003, People’s Republic of China
Richard Taylor
Affiliation:
School of Information and Electrical Engineering, University of Queensland, St. Lucia, QLD 4064, Australia
David J. Smith
Affiliation:
Center for Solid State Science, and Department of Physics and Astronomy, Arizona State University, Tempe, Arizona 85287
N. Newman*
Affiliation:
Science and Engineering of Materials Program, and Department of Chemical and Materials Engineering, Arizona State University, Tempe, Arizona 85287
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The use of boron as a sintering aid reduces the sintering temperature, enhances the sintering density, and improves the microwave properties of Ba(Cd1/3Ta2/3)O3 ceramic dielectrics. Observations by transmission electron microscopy indicate that the liquid sintering mechanism contributes to the improvement in sintering density for boron concentrations exceeding 0.5 wt%. The introduction of as small as 0.01% boron also results in the production of high-density samples (∼95%), presumably indicating that a point defect mechanism may also play an important role in the sintering process. X-ray diffraction data combined with high-resolution transmission electron microscopy images show that boron-doped Ba(Cd1/3Ta2/3)O3 ceramic material has a well-ordered hexagonal structure. Annealing treatment is found to improve the microwave properties. The best sample has a dielectric constant of 32, a temperature coefficient of resonant frequency of 80 ± 15 ppm/°C, and a quality factor of >25,000 at 2 GHz.

Keywords

CeramicDielectric propertiesMicrostructure
Type
Articles
Information
Journal of Materials Research , Volume 19 , Issue 12 , December 2004 , pp. 3526 - 3533
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Rong, G., Newman, N., Shaw, B. and Cronin, D.: Role of Ni and Zr doping on the electrical, optical, magnetic, and structural properties of barium zinc tantalate ceramics. J. Mater. Res. 14, 4011 (1999).CrossRefGoogle Scholar
2Wakino, K., Nishikawa, T., Ishikawa, Y. and Tamura, H.: Dielectric resonator materials and their application for mobile communication systems. Brit. Ceram. Trans. J 89, 39 (1990).Google Scholar
3Davies, P. in Ceramic transaction: Materials and processes for wireless communication, Vol. 53, edited by Negas, T. and Ling, H. (Am. Ceram. Soc. Publications, Westerville, OH, 1995), p. 137Google Scholar
4Pond, J., Liu, S. and Newman, N.: Band pass filters using dual-mode and quad-mode Mobius resonators. IEEE Trans. MTT 49, 2363 (2001).CrossRefGoogle Scholar
5Chai, L. and Davies, P.: Formation and structural characterization of 1:1 ordered perovskites in the Ba(Zn1/3 Ta2/3)O3-BaZrO3 system. J. Am. Ceram. Soc. 80, 3193 (1997).CrossRefGoogle Scholar
6Tamura, H., Konoike, T., Sakabe, Y. and Wakino, K.: Improved high-Q dielectric resonator with complex perovskite structure. J. Am. Ceram. Soc. 67, C59 (1984).CrossRefGoogle Scholar
7Negas, T., Yeager, G., Bell, S. and Amren, R. in Chemistry of Electronic Ceramic Materials, Proceedings of the International Conference, Jackson, WY, August 17–22, 1990 (National Institute of Standards and Technology Special Publications, Gaithersburg, MD, 804 1991), p. 21Google Scholar
8 S. Liu, R. Taylor, L. Budd, N.S. Petrovic, M. Van Schilfgaarde, and N. Newman: Experimental and theoretical investigation of the structural, chemical, electronic and high frequency dielectric properties of barium cadmium tantalate-based ceramics. J. Appl. Phys. (in press).Google Scholar
9Davies, P. and Tong, J.: Effect of ordering-induced domain boundaries on low-loss Ba(Zn1/3Ta2/3)O3-BaZrO3 perovskite microwave dielectrics. J. Am. Ceram. Soc. 80, 1727 (1997).CrossRefGoogle Scholar
10Yang, J-I., Nham, S., Choi, C-H., Lee, H-J. and Park, H-M.: Microstructure and microwave dielectric properties of Ba(Zn1/3Ta2/3)O3 ceramics with ZrO2 addition. J. Am. Ceram. Soc. 85, 165 (2002).CrossRefGoogle Scholar
11Sun, J., Liu, S., Newman, N., McCartney, M.R. and Smith, D.J.: Electron microscopy characterization of Ba(Cd1/3 Ta2/3)O3 microwave dielectrics with boron additive. J. Mater. Res. 19, 1387 (2004).CrossRefGoogle Scholar
12Sun, J., Liu, S., Newman, N. and Smith, D.J.: Ordered domains and boundary structure in Ba(Cd1/3Ta2/3)O3 perovskite dielectrics. Appl. Phy. Lett. 84, 3918 (2004).CrossRefGoogle Scholar
13Kawashima, S., Nishida, M., Ueda, I. and Ouchi, H.: Ba(Zn1/3Ta2/3)O3 ceramics with low-dielectric loss at microwave frequencies. J. Am. Ceram. Soc. 66, 421 (1983).CrossRefGoogle Scholar
14Matsumoto, K., Hiuga, T., Takada, K., and Ichimura, H.: Ba(Mg1/3Ta2/3)O3 ceramics with ultra-low loss at microwave frequencies, in Proceedings of the 6th IEEE International Symposium on Application of Ferroelectrics, Bethlehem, PA (IEEE, New York, NY, June 8–11, 1986), p. 118.Google Scholar
15Galasso, F. and Pyle, J.: Ordering in compound of the A(B′0.33Ta0.67)O3 type. Inorg. Chem. 2, 482 (1963).CrossRefGoogle Scholar
16Ganguii, A.K., Jayadevan, K.P., Subbanna, G.N. and Varma, K.B.R.: Preparation and dilectric properties of zinc and cadamium doped barium tantalates, Ba(Znx Cd1/3−x Ta2/3)O3. Solid State Commun. 94, 13 (1995).CrossRefGoogle Scholar
17Chan, H.M., Hamer, M.P. and Smyth, D.M.: Compensating defects in highly donor-doped BaTiO3. J. Am. Ceram. Soc. 69, 507 (1986).CrossRefGoogle Scholar
18Lewis, G.V., Catlow, C.R.A. and Casselton, R.E.W.: PTCR effect in BaTiO3. J. Am. Ceram. Soc. 68, 555 (1985).CrossRefGoogle Scholar
19Nalwa, H.S.: Handbook of Low and High-Dielectric Constant Materials and Their Applications, Vol. 2, (Academic, San Diego, CA, 1999), p. 496.Google Scholar