Hostname: page-component-586b7cd67f-t7czq Total loading time: 0 Render date: 2024-11-25T06:27:50.569Z Has data issue: false hasContentIssue false
  • English
  • Français

Microstructural observation of the ZrC/ZrO2 interface formed by oxidation of ZrC

Published online by Cambridge University Press:  31 January 2011

Shiro Shimada ,
Michio Inagaki  and
Mikio Suzuki
Shiro Shimada*
Affiliation:
Department of Applied Chemistry, Faculty of Engineering, Hokkaido University, Sapporo 060, Japan
Michio Inagaki
Affiliation:
Department of Applied Chemistry, Faculty of Engineering, Hokkaido University, Sapporo 060, Japan
Mikio Suzuki
Affiliation:
JEOL, Akishima 196, Japan
*
a) Author to whom correspondence should be addressed.
Get access

Abstract

The oxidation of ZrC single crystals having (100) faces was performed at a temperature of 600 °C at an oxygen pressure of 2.6 kPa. A polished cross section of oxide scale was observed by backscattered electron imaging (BEI) in a scanning electron microscope (SEM). The oxide scale was observed to consist of two subscales, zones 1 and 2; zone 1 is adjacent to the ZrC. The thickness of zone 1 was kept constant (about 2 μm), independent of oxidation time. The interfacial microstructure between ZrC and cubic ZrO2 (c-ZrO2) phase in zone 1 was observed by high resolution transmission electron microscopy, by using an extremely thin foil of an oxidized crystal. The c-ZrO2 crystallites of 2 to 10 nm in size showing the (111), (200), and (220) lattice fringes were aggregated and distributed in an area about 10 to 20 nm away from the interface, with an amorphous layer observed adjacent to the ZrC. Electron dispersive x-ray analysis (EDX) indicated that carbon is concentrated at the interface; a decreasing oxygen concentration gradient in the oxide phase and away from the interface in the ZrC suggests the formation of oxygen-deficient ZrO2–x and oxycarbide on the respective sides of the interface. A black coating layer appeared, resulting from detachment or dissolution of zone 2, when a crystal oxidized for 1 h was treated in a HF solution. The layer was shown by the Raman spectrum to be amorphous carbon.

Type
Articles
Information
Journal of Materials Research , Volume 11 , Issue 10 , October 1996 , pp. 2594 - 2597
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Shimada, S. and Ishii, T., J. Am. Ceram. Soc. 73, 2804–2808 (1990).CrossRefGoogle Scholar
2. Dufour, L. C., Simon, J., and Barret, P., C. R. Acad. Sci. Paris 265, 171 (1967).Google Scholar
3. Barnier, P. and Thevenot, F., Eur. J. Solid State Inorg. Chem. 25, 495 (1988).Google Scholar
4. Shimada, S., Nishisako, M., Inagaki, M., and Yamamoto, K., J. Am. Ceram. Soc. 78, 41 (1995).CrossRefGoogle Scholar
5. Otani, S., Tanaka, T., and Hara, A., J. Cryst. Growth 51, 164 (1981).CrossRefGoogle Scholar