Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-24T11:12:31.906Z Has data issue: false hasContentIssue false
  • English
  • Français

Liquidus temperature measurements for modeling oxide glass systems relevant to nuclear waste vitrification

Published online by Cambridge University Press:  01 December 2005

Jonathan B. Hanni ,
Eric Pressly ,
Jarrod V. Crum ,
Kevin B.C. Minister ,
Diana Tran ,
Pavel Hrma  and
John D. Vienna
Jonathan B. Hanni
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
Eric Pressly
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
Jarrod V. Crum
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
Kevin B.C. Minister
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
Diana Tran
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
Pavel Hrma
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
John D. Vienna*
Affiliation:
Environmental Technology Division, Pacific Northwest National Laboratory, Richland, Washington 99354
*
a)Address all correspondence to this author.e-mail: [email protected]
Get access

Abstract

Liquidus temperatures (TL) were measured, and primary phases were determined for 50 (from an initial test matrix of 76) compositions within the Al2O3–B2O3–CaO–Na2O–SiO2 glass-forming system and its constituent ternary subsystems. Strong linear correlations have been found between composition and TL for melts within the same primary phase fields. The TL and primary phase data are being used to develop and refine a modified associate species model (ASM). The impacts of Fe2O3, Li2O, NiO, ZrO2, Cr2O3, ZnO, and MnO additions on the TL of two baseline glass compositions are reported. These data are intended as benchmarks for further expansion of the ASM or other silicate melt solution models of nuclear waste glasses.

Keywords

GlassPhase equilibriaThermodynamic properties
Type
Articles
Information
Journal of Materials Research , Volume 20 , Issue 12 , December 2005 , pp. 3346 - 3357
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Design Construction, and Commissioning of the Hanford Tank Waste Treatment and Immobilization Plant. U.S. Department of Energy Contract No. DE-AC27-01RV14136, (2000, as amended).Google Scholar
2.Kim, D-S. and Hrma, P.: Models for liquidus temperature of nuclear waste glasses. Ceram. Trans. 45, 327 (1994).Google Scholar
3.Choi, I.G., Bickford, D.F. and Carter, J.T.: Thermal effects of electrically conductive deposits in a joule-heated melter. Ceram. Trans. 29, 645 (1993).Google Scholar
4.Kim, D-S. and Vienna, J.D.: Influence of glass property restrictions on Hanford HLW glass volume. Ceram. Trans. 132, 105 (2002).Google Scholar
5.Hrma, P., Vienna, J.D. and Schweiger, M.J.: Liquidus temperature limited waste loading maximization for vitrified HLW. Ceram. Trans. 72, 449 (1996).Google Scholar
6.Besmann, T.M. and Spear, K.E.: Thermochemical modeling of oxide glasses. J. Am. Ceram. Soc. 85, 2887 (2002).Google Scholar
7.Besmann, T.M., Spear, K.E. and Vienna, J.D.: Extension of the modified associate species thermochemical model for high-level nuclear waste: Inclusion of chromia, in Scientific Basis for Nuclear Waste Management XXVI, edited by Finch, R.J. and Bullen, D.B. (Mater. Res. Soc. Symp. Proc. 757, Warrendale, PA, 2003), p. 195.Google Scholar
8.Besmann, T.M., Kulkarni, N.S. and Spear, K.E.: Thermochemical and phase equilibria property prediction for oxide glass systems based on the modified associate species approach, in High Temperature Corrosion and Materials Technology IV, edited by Opila, E., Hou, P., Maruyama, T., Pieraggi, B., McNallan, M., Shifler, D., and E. Wuchina. (The Electrochemical Society, Pennington, NJ, 2004), p. 557.Google Scholar
9.Spear, K.E., Besmann, T.M. and Beahm, E.E.: Thermochemical modeling of glass: Application to high-level nuclear waste glass. MRS Bull. 24(4), 37 (1999).Google Scholar
10.Crum, J.V., Hrma, P., Schweiger, M.J. and Piepel, G.F.: Liquidus temperature models for high-level waste glasses that precipitate zirconium-containing crystalline phases. Ceram. Trans. 87, 271 (1998).Google Scholar
11.Plaisted, T., Hrma, P., Vienna, J. and Jiricka, A.: Liquidus temperature and primary phase in high-zirconia high-level waste borosilicate glasses, in Scientific Basis for Nucelar Waste Management XXIII, edited by Smith, R.W. and Shoesmith, D.W. (Mater. Res. Soc. Symp. Proc. 608, Warrendale, PA, 2000), p. 709.Google Scholar
12.Vienna, J.D., Hrma, P., Crum, J.V. and Mika, M.: Liquidus temperature-composition model for multi-component glasses in the Fe, Cr, Ni, and Mn spinel primary phase field. J. Non-Cryst. Solids 292, 1 (2001).Google Scholar
13.Hrma, P., Vienna, J., Crum, J. and Piepel, G.: Liquidus temperature of high-level waste borosilicate glasses with spinel primary phase, in Scientific Basis for Nucelar Waste Management XXIII, edited by Smith, R.W. and Shoesmith, D.W. (Mater. Res. Soc. Symp. Proc. 608, Warrendale, PA, 2000), p. 671.Google Scholar
14.Mika, M., Schweiger, M.J., Vienna, J.D. and Hrma, P.: Liquidus temperature of spinel precipitating high-level waste glasses, in Scientific Basis for Nucelar Waste Management XX, edited by Gray, W.J. and Tridy, I.R. (Mater. Res. Soc. Symp. Proc., 465, Pittsburgh, PA, 1997), p. 71.Google Scholar
15.Vienna, J.D.: Nuclear waste glasses, in Properties of Glass-Forming Melts, edited by Pye, L.D., Joseph, I., and Montenero, A. (CRC Press, Boca Raton, FL, 2005). pp. 391–403.Google Scholar
16.Hastie, J.W. and Bonnell, D.W.: A predictive phase-equilibrium model for multicomponent oxide mixtures. 2. Oxides of Na–K– Ca–Mg–Al–Si. High Temp. Sci. 19, 275 (1985).Google Scholar
17.Bonnell, D.W. and Hastie, J.W.: A predictive thermodynamic model for complex high-temperature solution phases 11. High Temp. Sci. 26, 313 (1989).Google Scholar
18.Shakhmatkin, B.A., Vedishcheva, N.M. and Wright, A.C.: Can thermodynamics relate the properties of melts and glasses to their structure? J. Non-Cryst. Solids 293, 220 (2001).Google Scholar
19.Shakhmatkin, B.A., Vedishcheva, N.M., Shultz, M.M. and Wright, A.C.: The thermodynamic properties of oxide glasses and glass-forming liquids and their chemical-structure. J. Non-Cryst. Solids 177, 249 (1994).Google Scholar
20.Osborn, E.F. and Muan, A.: Fig. 501, in Phase Diagrams for Ceramists, Vol. 1, edited by Levin, E.M., Robbins, C.R., and McMurdie, H.F., (The American Ceramic Society, Columbus, OH, 1964), p. 181.Google Scholar
21.Morey, G.W. and Bowen, N.L.: J. Soc. Glass Technol., 9, p. 232 (1925), reprinted as Fig. 482 in Phase Diagrams for Ceramists, Vol. 1, edited by Levin, E.M., Robbins, C.R., and McMurdie, H.F. (The American Ceramic Society, Columbus, OH, 1964), p. 175.Google Scholar
22.Osborn, E.F. and Muan, A.: Fig. 630, in Phase Diagrams for Ceramists, Vol. 1, edited by Levin, E.M., Robbins, C.R., and McMurdie, H.F. (The American Ceramic Society, Columbus, OH, 1964), p. 219.Google Scholar
23. ASTM C829-81: Standard practices for measurement of liquidus temperature of glass by the gradient furnace method. (re-approved 1995), in 1999 Annual Book of ASTM Standards, Vol. 15.02 (American Society for Testing and Materials, West Conshohocken, PA, 1999).Google Scholar
24.Backman, R., Karlsson, K.H., Cable, M. and Pennington, N.P.: Model for liquidus temperature of multi-component silicate glasses. Phys. Chem. Glasses 38, 103 (1997).Google Scholar
25.Dreyfus, C. and Dreyfus, G.: A machine learning approach to the estimation of the liquidus temperature of glass-forming oxide blends. J. Non-Cryst. Solids 318, 63 (2003).Google Scholar
26.Li, H., Jones, B., Hrma, P. and Vienna, J.D.: Compositional effects on liquidus temperature of Hanford simulated high-level waste glasses precipitating nepheline (NaAlSiO4). Ceram. Trans. 87, 279 (1998).Google Scholar
27.ASTM E1508-98: Standard guide for quantitative analysis by energy-dispersive spectroscopy, in 2003 Annual Book of ASTM Standards, Vol. 03.01 (American Society for Testing and Materials, West Conshohocken, PA, 2003).Google Scholar
28.Pretorius, E.B. and Muan, A.: Stability of CaNiSi2O6 (“niopside”) and activity-composition relations of CaMgSi2O6 solid solutions at 1350°C. J. Am. Ceram. Soc. 75, 1458 (1992).Google Scholar