Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-02T19:01:39.707Z Has data issue: false hasContentIssue false

Influence of the substrate bias on the size and thermal stability of grains in magnetron-sputtered nanocrystalline Ag films

Published online by Cambridge University Press:  01 April 2005

K. Pagh Almtoft
Affiliation:
Department of Physics and Astronomy, University of Aarhus, 8000 Aarhus C, Denmark
J. Bøttiger*
Affiliation:
Department of Physics and Astronomy, University of Aarhus, 8000 Aarhus C, Denmark
J. Chevallier
Affiliation:
Department of Physics and Astronomy, University of Aarhus, 8000 Aarhus C, Denmark
N. Schell
Affiliation:
Institute of Ion Beam Physics and Materials Research, Forschungszentrum Rossendorf, D-01314 Dresden, Germany
R.M.S. Martins
Affiliation:
Institute of Ion Beam Physics and Materials Research, Forschungszentrum Rossendorf, D-01314 Dresden, Germany
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

The nanostructural evolution during heat treatments of direct-current magnetron-sputtered Ag films, deposited at room temperature at different substrate bias voltages, was experimentally studied. A growth chamber equipped with a magnetron and Kapton windows for in-situ x-ray diffraction was mounted on a six-circle goniometer at a synchrotron beam line. Bragg–Brentano x-ray diffraction was used to monitor the (111) Bragg peak during thermal annealing of the Ag films. In addition, to investigate the 〈111〉 fiber texture, one-dimensional pole figures were measured ex situ. The thermal stability of the nanostructure was sensitively dependent on the substrate bias voltage. Increasing the bias voltage resulted in significantly lower rates of grain growth, which we ascribe mainly to the formation of Ar bubbles. Furthermore, the grain size in the as-deposited films decreased with increasing bias voltage while the width of the one-dimensional pole figures increased.

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Nanomaterials Synthesis, Properties, and Applications, edited by Edelstein, A.S. and Cammarata, R.C. (Institute of Physics Publishing, Bristol, U.K., 1998).CrossRefGoogle Scholar
2. Suryanarayana, C.: Nanocrystalline materials. Inter. Mater. Rev. 40, 41 (1995).CrossRefGoogle Scholar
3. Hall, E.O.: The deformation and ageing of mild steel: III Discussion of results. Proc. Phys. Soc. B 64, 747 (1951).CrossRefGoogle Scholar
4. Petch, N.J.: The cleavage strength of polycrystals. J. Iron Steel Inst. 174, 25 (1953).Google Scholar
5. Ohring, M.: Engineering Materials Science (Academic Press, Inc., San Diego, CA, 1995), Chap. 9.CrossRefGoogle Scholar
6. Horvath, J., Berringer, R. and Gleiter, H.: Diffusion in nanocrystalline material. Solid State Commun. 62, 319 (1987).CrossRefGoogle Scholar
7. Lu, L., Tao, N.R., Wang, L.B., Ding, B.Z. and Lu, K.: Grain growth and strain release in nanocrystalline copper. J. Appl. Phys. 89, 6408 (2001).CrossRefGoogle Scholar
8. Detavernier, C., Rossnagel, S.M., Noyan, I. Cevdet, Guha, S., Cabral, C. Jr., and Lavoie, C.: Thermodynamics and kinetics of room-temperature grain growth in Cu films. IBM Research Report RC22735(3), 1 (2003).Google Scholar
9. Detavernier, C., Deduytsche, D., Van Meirhaeghe, R.L., De Baerdmaeker, J. and Dauwe, C.: Room-temperature grain growth in sputter-deposited Cu films. Appl. Phys. Lett. 82, 1863 (2003).CrossRefGoogle Scholar
10. Thornton, J.A.: Influence of substrate temperature and deposition rate on structure of thick sputtered Cu coatings. J. Vac. Sci. Technol. 12, 830 (1975).CrossRefGoogle Scholar
11. Schell, N., Andreasen, K.P., Bøttiger, J. and Chevallier, J.: On the dependence on bias voltage of the structure evolution of magnetron-sputtered nanocrystalline Cu films during thermal annealing. Thin Solid Films 476, 280 (2005).CrossRefGoogle Scholar
12. Huang, T.C., Lim, G., Parmigiani, F. and Key, E.: Effect of ion bombardment during deposition on the x-ray microstructure of thin silver films. J. Vac. Sci. Technol. A 3, 2161 (1985).CrossRefGoogle Scholar
13. Malow, T.R. and Koch, C.C.: Grain growth in nanocrystalline iron prepared by mechanical attrition. Acta Mater. 45, 2177 (1997).CrossRefGoogle Scholar
14. Thompson, C.V.: Grain growth in thin films. Ann. Rev. Mater. Sci. 20, 245 (1990).CrossRefGoogle Scholar
15. Dannenberg, R., Stach, E., Groza, J.R. and Dresser, B.J.: TEM annealing study of normal grain growth in silver thin films. Thin Solid Films 379, 133 (2000).CrossRefGoogle Scholar
16. Günther, B., Kumpmann, A. and Kunze, H-D.: Secondary recrystallization effects in nanostructured elemental metals. Scr. Metall. Mater. 27, 833 (1992).CrossRefGoogle Scholar
17. Matz, W., Schell, N., Neumann, W., Bøttiger, J. and Chevallier, J.: A two magnetron sputter deposition chamber for in situ observation of thin film growth by synchrotron radiation scattering. Rev. Sci. Instrum. 72, 3344 (2001).CrossRefGoogle Scholar
18. Matz, W., Schell, N., Bernhard, G., Prokert, F., Reich, T., Claußner, J., Oehme, W., Schlenk, R., Dienel, S., Funke, H., Eichhorn, F., Betzl, M., Pröhl, D., Strauch, U., Hüttig, G., Krug, H., Neumann, W., Brendler, V., Reichel, P., Denecke, M.A. and Nitsche, H.: ROBL—A CRG beamline for radiochemistry and materials research at the ESRF. J. Synchr. Rad. 6, 1076 (1999).CrossRefGoogle Scholar
19. de Keijser, Th.H., Langford, J.I., Mittemeijer, E.J. and Vogels, A.B.P.: Use of the Voigt function in a single-line method for the analysis of x-ray diffraction line broadening. J. Appl. Crystallogr. 15, 308 (1982).CrossRefGoogle Scholar
20. Leavitt, J.A., McIntyre, L.C. and Weller, M.R.: Backscattering Spectrometry, in Handbook of Modern Ion Beam Materials Analysis, edited by Tesmer, J.R. and Nastasi, M. (Materials Research Society, Pittsburgh, PA, 1995), Chap. 4.Google Scholar
21. Kaminsky, M.: Atomic and Ionic Impact Phenomena on Metal Surfaces (Springer-Verlag, Berlin, 1965), Chap. 14.CrossRefGoogle Scholar
22. Schell, N., Jensen, T., Petersen, J.H., Andreasen, K.P., Bøttiger, J. and Chevallier, J.: The nanostructure evolution during and after magnetron deposition of Au films. Thin Solid Films 441, 96 (2003).CrossRefGoogle Scholar